參數資料
型號: PM6641
廠商: STMICROELECTRONICS
元件分類: 穩壓器
英文描述: SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, QCC48
封裝: 7 X 7 MM, 1 MM HEIGHT, LEAD FREE, VQFP-48
文件頁數: 22/47頁
文件大?。?/td> 2254K
代理商: PM6641
PM6641
Device description
Doc ID 13510 Rev 3
29/47
7.7
Outputs soft-end
When the switching regulator enable pin (EN_1S8 for the VDDQ section, EN_1S5 and
EN_1S05 for chipset sections) goes down or when UV or thermal protections are detected,
the switching regulator output capacitor is actively discharged through a dedicated
discharge MOSFET of about 25
Ω typical resistance.
The PM6641 DDR supply allows choosing between two different output discharge
behaviors, involving the VDDQ (1S8) switching rail, VTT LDO termination and VTTREF
reference buffered voltage: the tracking discharge and the non-tracking discharge. This
selection is set by tying the discharge pin (DSCG) to AVCC (tracking discharge enabled) or
to AGND (tracking discharge disabled).
When the 1.8 V rail is turned off (EN_1S8 goes low) and non-tracking discharge is active
(DSCG is low), or when UV or thermal protections are detected, the VDDQ and VTT rails
and the VTTREF buffer are discharged by internal discharge MOSFETs, through the
VSW_1S8, VTTFB and VTTREF pins respectively. VTT termination output capacitor is
discharged through 25
Ω dedicated MOSFET whereas VTTREF output capacitor is
discharged through 200
Ω dedicated MOSFET.
When the 1.8 V rail is turned off (EN_1S8 goes low) and tracking discharge is selected
(DSCG is high), tracking discharge takes place:
The 1.8 V rail regulator is discharged by internal MOSFET
The 0.9 V VTT LDO and VTTREF work in tracking with the half of 1.8 V rail
When the VTT LDO and VTTREF reach a voltage threshold of about 200-300 mV, the
device switches to non-tracking discharge mode and the internal discharge MOSFETs are
turned on.
7.8
Switching frequency selection
SET_SWF (pin 2) allows to vary the internal oscillator switching frequency, in the range of
500 kHz
1 MHz, by connecting this pin to AGND through a resistor between
70 k
Ω
140k
Ω.
The following table summarizes the output resistor – switching frequency correspondence:
When SET_SWF is tied to AVCC the internal reference is chosen and each regulator
performs a typical 750 kHz switching frequency.
Table 10.
Typical values for switching frequency selection
RSET_SWF (kΩ)
Approx. switching frequency (kHz)
140
500
100
670
70
1000
相關PDF資料
PDF描述
PM6670ASTR 3 A SWITCHING CONTROLLER, QCC24
PM6670AS 3 A SWITCHING CONTROLLER, QCC24
PM6670A 1.4 A SWITCHING CONTROLLER, QCC24
PM6670STR 3 A SWITCHING CONTROLLER, QCC24
PM6670S 3 A SWITCHING CONTROLLER, QCC24
相關代理商/技術參數
參數描述
PM6641TR 功能描述:低壓差穩壓器 - LDO Monolithic VR RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
PM6644 功能描述:直流/直流開關調節器 350mA adjust SD reg 4.5V to 25V 350mA RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
PM6644TR 功能描述:DC/DC 開關控制器 350 mA adj step-down 4.5 to 25V -40, 150c RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
PM6650 制造商:Qualcomm 功能描述:Electronic Component
PM6652 功能描述:DC/DC 開關控制器 Single Phase CNTR Intel MVP 6.5 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK