- 您現在的位置：買賣IC網 > PDF目錄96681 > PKF5713SI (ERICSSON POWER MODULES AB) 1-OUTPUT 7.8 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PKF5713SI |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 7.8 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | PLASTIC, SMD-18 |
| 文件頁數： | 7/8頁 |
| 文件大?。?/td> | 282K |
| 代理商： | PKF5713SI |
7
EN/LZT 146 127 R1B Ericsson Power Modules AB, May 2004
Output Voltage Adjust (Vadj)
Output voltage, VO, can be adjusted by using an external resistor or
other external circuitry. If other circuitry is used, the slew rate has to
be limited to maximum 5 V/ms. If pins 8 and 9 are not connected
together the output will decrease to a low value. To increase VO a
resistor should be connected between pin 8/9 and 17, and to de-
crease VO a resistor should be connected between pin 8 and 9 (see
fig. 3).
To increase output voltage:
Rounom=3.18× (14.04-VO)/(VO-VI) k
W
VI is the initial output voltage when pin 8 and 9 are connected, VO
is the desired output voltage.
To decrease output voltage:
Rodnom=11.60× (VI-VO)/(VO-10) k
W
VI is the initial output voltage when pin 8 and 9 are connected, VO
is the desired output voltage.
Figure 2
Figure 3
Current Limiting Protection (Ilim)
The output power is limited at loads above the output current
limiting threshold (Ilim), specified as a minimum value.
Capacitive Load
The PKF series has no maximum limit for capacitive load on the
output. The power module may operate in current limiting mode
during start-up, affecting the ramp-up and the start-up time. For
optimum start performance we recommend maximum 100
mF/A of
IO. Connect capacitors at the point of load for best performance.
Input and Output Impedance
Both the source impedance of the power feeding and the load im-
pedance will interact with the impedance of the DC/DC power
module.
It is most important to have the ratio between L and C as low as
possible, i.e. a low characteristic impedance, both at the input and
output, as the power modules have a low energy storage capability.
Use an electrolytic capacitor across the input if the source induct-
ance is higher than 10
mH. Their equivalent series resistance togeth-
er with the capacitance acts as a lossless damping filter. Suitable
capacitor values are in the range 10–100
mF.
Synchronization (Sync)
It is possible to synchronize the switching frequency to an external
symmetrical clock signal. The input can be driven by an TTL-
compatible output and referenced to the input pin 17.
Parallel Operation
Paralleling of several converters is easily accomplished by direct
connection of the output voltage terminal pins. The load regula-
tion characteristic is specifically designed for optimum paralleling
performance. Load sharing between converters will be within
±10%. It is recommended not to exceed PO = n × 0.9 × POmax,
where POmax is the maximum converter output power and n the
number of paralleled converters, to prevent overloading any of the
converters and thereby decreasing the reliability performance.
*)
Rise time <10ns
Information given in this data sheet is believed to be accurate and reliable.
No responsibility is assumed for the consequences of its use nor for any infringement
of patents or other rights of third parties which may result from its use.
No license is granted by implication or otherwise under any patent or patent rights of
Ericsson Power Modules. These products are sold only according to
Ericsson Power Modules general conditions of sale, unless otherwise confirmed in
writing. Specifications subject to change without notice.
Ordering Information
Surface mount
PKF 5713 SI
Through hole
PKF 5713 PI
Version
Part No.
Characteristics
min
typ
max
unit
High level
2.2
6.5
V
Threshold level*)
1.2
1.7
2.2
V
Low level
0
0.4
V
Sink current
1.5
mA
Sync. frequency
520
688
kHz
相關PDF資料 |
PDF描述 |
|---|---|
| PKG4617PI0A | 1-OUTPUT 60 W DC-DC REG PWR SUPPLY MODULE |
| PKJ4128PIT | 2-OUTPUT 110 W DC-DC REG PWR SUPPLY MODULE |
| PKJ4128PIPT | 2-OUTPUT 110 W DC-DC REG PWR SUPPLY MODULE |
| PKJ4318PIPOAT | 1-OUTPUT 30 W DC-DC REG PWR SUPPLY MODULE |
| PKJ4218PIPOAT | 1-OUTPUT 22.5 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PKF70B1/4 | 制造商:TE Connectivity 功能描述: |
| PK-FAC4F-GR | 制造商:General Motors 功能描述:4 Way Medium Gray Metri-Pack 280 Sealed Female Connector Assembly, Max Current 30 amps |
| PKFAC-FO85 | 制造商:General Motors 功能描述:Female Metri-Pack 280 Tin Plated Terminal, Cable Range 1.00 - 0.75 mm2, Cable Insulation Range 2.64 - 1.96 mm |
| P-KFB3-440-12ET | 制造商:PSM International 功能描述: |
| P-KFB3-440-2 | 制造商:PSM International 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。