參數資料
型號: PKF4128BSI
廠商: ERICSSON POWER MODULES AB
元件分類: 電源模塊
英文描述: 2-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE
文件頁數: 6/8頁
文件大小: 232K
代理商: PKF4128BSI
6
EN/LZT 146 089 R1A Ericsson Power Modules AB, March 2005
Operating Information
Radiated EMS (Electro-Magnetic Fields)
Radiated EMS is measured according to test methods in
IEC Standard publ. 801-3. No deviation outside the VO
tolerance band will occur under the following conditions:
Frequency range
Voltage level
0.01...200 MHz
3 Vrms/m
200...1,000 MHz
3 Vrms/m
1...12 GHz
10 Vrms/m
Conducted EMS
Electro Magnetic Susceptibility is measured by injection of
electrical disturbances on the input terminals. No deviation
outside the VO tolerance band will occur under the following
conditions:
Frequency range
Voltage level
30...300 MHz
1.0 Vrms
The signal is amplitude modulated with 1 kHz/80% and
applied in both differential and common mode.
ESD
Electro Static Discharge is tested according to IEC publ. 801-
2. No destruction will occur if the following voltage levels are
applied to any of the terminal pins:
Test
Voltage level
Air discharge
±4 kV
Contact discharge
±2 kV
EFT
Electrical Fast Transients on the input terminals could affect
the output voltage regulation causing functional errors on
the Printed Board Assembly (PBA). The PKF power modules
withstand EFT levels of 0.5 kV keeping VO within the
tolerance band and
2.0 kV without destruction. Tested according to IEC publ.
801-4.
Output Ripple & Noise (VOac)
Output ripple is measured as the peak to peak voltage of the
fundamental switching frequency.
Remote Control (RC)
Turn-on or turn-off can be realized by using the RC-pin. If pin
7 is connected to pin 11 the power modules turns off. Normal
operation is achieved if pin 7 is open (NC). To ensure safe turn-
off the voltage difference between pin 7 and 11 shall be less
than 1.0 V. RC is an open collector compatible input. A sink
capacity of 1mA is needed. (see g. 1).
Fuse Considerations
To prevent excessive current from owing through the input
supply line, in the case of a short-circuit across the converter
input, an external fuse should be installed in the non-earthed
input supply line. We recommend using a fuse rated at
approximately 2 to 4 times the value calculated in the formula
below:
Refer to the fuse manufacturer for further information.
POmax
min × VImin)
Iinmax =
PKF 4128BSI
RC (pin 7)
-In (pin 11)
Figure 1
相關PDF資料
PDF描述
PKF4610API 1-OUTPUT 6.6 W DC-DC REG PWR SUPPLY MODULE
PKF4910APINS 1-OUTPUT 9.9 W DC-DC REG PWR SUPPLY MODULE
PKF4910API 1-OUTPUT 9.9 W DC-DC REG PWR SUPPLY MODULE
PKF4918BI 1-OUTPUT 9 W DC-DC REG PWR SUPPLY MODULE
PKF5113SI 1-OUTPUT 11 W DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
PKF4310 制造商:ERICSSON 制造商全稱:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series
PKF4310PI 制造商:Ericsson 功能描述:
PKF4310SI 制造商:ERICSSON 制造商全稱:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series
PKF4510 制造商:ERICSSON 制造商全稱:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series
PKF4510PI 制造商:Ericsson 功能描述: