- 您現在的位置：買賣IC網 > PDF目錄11746 > PIC18F87K90-I/PTRSL (Microchip Technology)MCU PIC 128K FLASH XLP 80TQFP PDF資料下載
參數資料
| 型號： | PIC18F87K90-I/PTRSL |
| 廠商： | Microchip Technology |
| 文件頁數： | 9/110頁 |
| 文件大小： | 0K |
| 描述： | MCU PIC 128K FLASH XLP 80TQFP |
| 產品培訓模塊： | 8-bit PIC® Microcontroller Portfolio |
| 標準包裝： | 119 |
| 系列： | PIC® XLP™ 18F |
| 核心處理器： | PIC |
| 芯體尺寸： | 8-位 |
| 速度： | 64MHz |
| 連通性： | I²C，LIN，SPI，UART/USART |
| 外圍設備： | 欠壓檢測/復位，LCD，POR，PWM，WDT |
| 輸入/輸出數： | 69 |
| 程序存儲器容量： | 128KB（64K x 16） |
| 程序存儲器類型： | 閃存 |
| EEPROM 大?。?/td> | 1K x 8 |
| RAM 容量： | 4K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.8 V ~ 5.5 V |
| 數據轉換器： | A/D 24x12b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 80-TQFP |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁
PIC18F47J53 FAMILY
DS39964B-page 456
Preliminary
2010 Microchip Technology Inc.
FIGURE 28-4:
FSCM BLOCK DIAGRAM
Clock failure is tested for on the falling edge of the
sample clock. If a sample clock falling edge occurs
while the clock monitor is still set, and a clock failure
has been detected (Figure 28-5), the following results:
The FSCM generates an oscillator fail interrupt by
setting bit, OSCFIF (PIR2<7>);
The device clock source is switched to the internal
oscillator block (OSCCON is not updated to show
the current clock source – this is the Fail-safe
condition); and
The WDT is reset.
During switchover, the postscaler frequency from the
internal oscillator block may not be sufficiently stable
for timing-sensitive applications. In these cases, it may
be desirable to select another clock configuration and
enter an alternate power-managed mode. This can be
done to attempt a partial recovery or execute a
controlled shutdown. See Section 4.1.4 “Multiple
more details.
The FSCM will detect failures of the primary or secondary
clock sources only. If the internal oscillator block fails, no
failure would be detected, nor would any action be
possible.
28.5.1
FSCM AND THE WATCHDOG TIMER
Both the FSCM and the WDT are clocked by the
INTRC oscillator. Since the WDT operates with a
separate divider and counter, disabling the WDT has
no effect on the operation of the INTRC oscillator when
the FSCM is enabled.
As already noted, the clock source is switched to the
INTRC clock when a clock failure is detected; this may
mean a substantial change in the speed of code execu-
tion. If the WDT is enabled with a small prescale value,
a decrease in clock speed allows a WDT time-out to
occur and a subsequent device Reset. For this reason,
Fail-Safe Clock Monitor events also reset the WDT and
postscaler, allowing it to start timing from when execu-
tion speed was changed and decreasing the likelihood
of an erroneous time-out.
FIGURE 28-5:
FSCM TIMING DIAGRAM
Peripheral
INTRC
÷ 64
S
C
Q
(32
s)
488 Hz
(2.048 ms)
Clock Monitor
Latch
(edge-triggered)
Clock
Failure
Detected
Source
Clock
Q
OSCFIF
Clock Monitor
Device
Clock
Output
Sample Clock
Failure
Detected
Oscillator
Failure
Note:
The device clock is normally at a much higher frequency than the sample clock. The relative frequencies in
this example have been chosen for clarity.
Output (Q)
Clock Monitor Test
相關PDF資料 |
PDF描述 |
|---|---|
| V300C12H150BG3 | CONVERTER MOD DC/DC 12V 150W |
| V300C12H150BG2 | CONVERTER MOD DC/DC 12V 150W |
| V300C12H150BG | CONVERTER MOD DC/DC 12V 150W |
| PIC16C622-20/P | IC MCU OTP 2KX14 COMP 18DIP |
| VE-BTX-IW-F1 | CONVERTER MOD DC/DC 5.2V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC18F87K90T-I/PT | 功能描述:8位微控制器 -MCU 128kB Flash 4kB RAM LCD RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F87K90T-I/PTRSL | 功能描述:8位微控制器 -MCU 128KB 4KB RAM 16MIPS nanoWatt XLP LCD 5V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC18F95J94-I/PF | 制造商:Microchip Technology Inc 功能描述:100 PINS, 32KB FLASH, 4KB RAM, 16MIPS, NANOWATT XLP, LCD, US - Trays 制造商:Microchip Technology Inc 功能描述:IC MCU 8BIT 32KB FLASH 100TQFP 制造商:Microchip Technology Inc 功能描述:100 pins, 32KB Flash, 4KB RAM, 16MIPS, nanoWatt XLP, LCD, USB, 100 TQFP 14x14x1m |
| PIC18F95J94-I/PT | 制造商:Microchip Technology Inc 功能描述:100 PINS, 32KB FLASH, 4KB RAM, 16MIPS, NANOWATT XLP, LCD, US - Trays 制造商:Microchip Technology Inc 功能描述:IC MCU 8BIT 32KB FLASH 100TQFP |
| PIC18F95J94T-I/PF | 制造商:Microchip Technology Inc 功能描述:100 PINS, 32KB FLASH, 4KB RAM, 16MIPS, NANOWATT XLP, LCD, US - Tape and Reel 制造商:Microchip Technology Inc 功能描述:IC MCU 8BIT 32KB FLASH 100TQFP 制造商:Microchip Technology Inc 功能描述:8-bit Microcontrollers - MCU 100 pins, 32KB Flash 4KB RAM, 16MIPS 制造商:Microchip Technology Inc 功能描述:100 pins, 32KB Flash, 4KB RAM, 16MIPS, nanoWatt XLP, LCD, USB, 100 TQFP 14x14x1m |
發布緊急采購，3分鐘左右您將得到回復。