- 您現在的位置：買賣IC網 > PDF目錄10907 > PIC16C505/JW (Microchip Technology)IC MCU EPROM 1KX12 14CDIP PDF資料下載
參數資料
| 型號： | PIC16C505/JW |
| 廠商： | Microchip Technology |
| 文件頁數： | 31/90頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU EPROM 1KX12 14CDIP |
| 標準包裝： | 29 |
| 系列： | PIC® 16C |
| 核心處理器： | PIC |
| 芯體尺寸： | 8-位 |
| 速度： | 20MHz |
| 外圍設備： | POR，WDT |
| 輸入/輸出數： | 11 |
| 程序存儲器容量： | 1.5KB（1K x 12） |
| 程序存儲器類型： | EPROM，UV |
| RAM 容量： | 72 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 3 V ~ 5.5 V |
| 振蕩器型： | 內部 |
| 工作溫度： | 0°C ~ 70°C |
| 封裝/外殼： | 14-CDIP（0.300"，7.62mm）窗口 |
| 包裝： | 管件 |
| 配用： | ISPICR1-ND - ADAPTER IN-CIRCUIT PROGRAMMING AC124001-ND - MODULE SKT PROMATEII 8DIP/SOIC |
| 其它名稱： | PIC16C505/JWR PIC16C505/JWR-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁當前第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁
1999-2012 Microchip Technology Inc.
DS40192D-page 37
PIC16C505
7.9
Power-Down Mode (SLEEP)
A device may be powered down (SLEEP) and later
powered up (Wake-up from SLEEP).
7.9.1
SLEEP
The Power-Down mode is entered by executing a
SLEEP
instruction.
If enabled, the Watchdog Timer will be cleared but
keeps running, the TO bit (STATUS<4>) is set, the PD
bit (STATUS<3>) is cleared and the oscillator driver is
turned off. The I/O ports maintain the status they had
before the SLEEP instruction was executed (driving
high, driving low or hi-impedance).
It should be noted that a RESET generated by a WDT
time-out does not drive the MCLR pin low.
For lowest current consumption while powered down,
the T0CKI input should be at VDD or VSS and the RB3/
MCLR/VPP pin must be at a logic high level (VIHMC) if
MCLR is enabled.
7.9.2
WAKE-UP FROM SLEEP
The device can wake-up from SLEEP through one of
the following events:
1.
An external reset input on RB3/MCLR/VPP pin,
when configured as MCLR.
2.
A Watchdog Timer time-out reset (if WDT was
enabled).
3.
A change on input pin RB0, RB1, RB3 or RB4
when wake-up on change is enabled.
These events cause a device reset. The TO, PD, and
RBWUF bits can be used to determine the cause of
device reset. The TO bit is cleared if a WDT time-out
occurred (and caused wake-up). The PD bit, which is
set on power-up, is cleared when SLEEP is invoked.
The RBWUF bit indicates a change in state while in
SLEEP at pins RB0, RB1, RB3 or RB4 (since the last
file or bit operation on RB port).
The WDT is cleared when the device wakes from
sleep, regardless of the wake-up source.
Caution: Right before entering SLEEP, read the
input pins. When in SLEEP, wake up
occurs when the values at the pins change
from the state they were in at the last
reading. If a wake-up on change occurs
and the pins are not read before reentering
SLEEP, a wake-up will occur immediately
even if no pins change while in SLEEP
mode.
7.10
Program Verification/Code Protection
If the code protection bit has not been programmed,
the on-chip program memory can be read out for
verification purposes.
The first 64 locations and the last location (OSCCAL)
can be read, regardless of the code protection bit
setting.
7.11
ID Locations
Four memory locations are designated as ID locations
where the user can store checksum or other code-
identification
numbers.
These
locations
are
not
accessible during normal execution, but are readable
and writable during program/verify.
Use only the lower 4 bits of the ID locations and
always program the upper 8 bits as '0's.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC16LC77-04I/P | IC MCU OTP 8KX14 A/D PWM 40DIP |
| PIC16LC77-04/P | IC MCU OTP 8KX14 A/D PWM 40DIP |
| PIC16C77/JW | IC MCU EPROM8KX14 A/D PWM 40CDIP |
| PIC16C76/JW | IC MCU EPROM8KX14 A/D PWM 28CDIP |
| PIC16C64A/JW | IC MCU EPROM 2KX14 PWM 40CDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC16C505T-04/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 4MHz SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C505T-04E/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 4MHz Ext Temp SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C505T-04I/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 4MHz Ind Temp SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C505T-20/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 20MHz SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C505T-20E/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 20MHz ExtTemp SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。