- 您現在的位置：買賣IC網 > PDF目錄367901 > PEB80900H ?Network Termination Controller? PDF資料下載
參數資料
| 型號： | PEB80900H |
| 英文描述： | ?Network Termination Controller? |
| 中文描述： | ？網絡終端控制器？ |
| 文件頁數： | 125/181頁 |
| 文件大小： | 3288K |
| 代理商： | PEB80900H |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁當前第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁
PEB 80900
Part II
’
IEC-T
’
: Operational Description
Data Sheet
113
2001-04-02
The IOM
interfaces and the UK0 interfaces are defined to prohibit states which cannot
be left with normal commands and infos. Deactivation of the line leads all devices to
defined states. Nevertheless, it is recommended to implement a power-on reset (at pin
RESQ of NTC-T AM with IEC-T functionality selected) to start in a defined manner, and
to shorten the first deactivation and activation.
The usage of the two input pins, RESQ and TSP, has the same effect as inputs RES and
SSP in the C/I channel with one exception: If RESQ pin is low, DISS pin is set to high. If
the reset is given only in the C/I channel, DISS pin is set to low. They always overwrite
the IOM
C/I channel input.
For instance, the PEB 2080 (SBC) sends an EI code in the C/I channel, if RESET and
TM2 pins of the SBC are set. The NTC-T AM with IEC-T functionality selected might
interpret the EI code as the TEST command, but the SBC and NTC-T AM with IEC-T
functionality selected reset pins (active low) are connected together in the NT. Thus, the
NTC-T AM with IEC-T functionality selected ignores the EI code performing the reset
request.
7.2
Activation and Deactivation of Uk0 Transmission Lines
On Uk0, the exchange of control information is partially state oriented. Some signal
elements are given as long as no other information has to be transferred, other signal
elements have distinct durations.
7.2.1
Awake Protocol
To awake the Uk0 interface and the Idle modules, an awake and an acknowledge signal
have been defined.
Procedure for awaking NTC-T AM with IEC-T functionality selected
After sending the awake signal, the awaking device waits for the acknowledge. After 12
ms in the LT mode or 6 ms in the NT mode, the awake signal is repeated, if no
acknowledge has been recognized.
If an acknowledge signal has been recognized, the NTC-T AM with IEC-T functionality
selected waits for its possible repetition (in case of previous coincidence of two awake
signals). If no repetition was detected, the NTC-T AM with IEC-T functionality selected
starts transmitting INFO U2 in the LT mode, INFO U2A in the LT-RP mode and INFO
U1A in NT modes with a delay of 7 ms in the LT mode or 13 ms in the NT mode.
If such a repetition is detected, the NTC-T AM with IEC-T functionality selected interprets
it as an awake signal and the NTC-T AM with IEC-T functionality selected behaves like
a device awoken by the far end.
相關PDF資料 |
PDF描述 |
|---|---|
| PEB8091(64MQFP) | ISDN Line Interface |
| PEB8091(64TQFP) | ISDN Line Interface |
| PEF8091(64MQFP) | 1MHz Off-Line Current Mode PWM and DC/DC Converter; Package: SO; No of Pins: 8; Temperature Range: 0°C to +70°C |
| PEF8091(64TQFP) | ISDN Line Interface |
| PEF80912 | Power Factor Controller; Package: PDIP; No of Pins: 16; Temperature Range: 0°C to +70°C |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PEB8090FV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Infineon Technologies AG 功能描述: |
| PEB8091FDV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| PEB8091FGDV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Infineon Technologies AG 功能描述: |
| PEB8091HDV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Infineon Technologies AG 功能描述: |
| PEB8191FGDV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。