- 您現在的位置：買賣IC網 > PDF目錄3772 > PCA8575PW,112 (NXP Semiconductors)IC I/O EXPANDER I2C 16B 24TSSOP PDF資料下載
參數資料
| 型號： | PCA8575PW,112 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 4/30頁 |
| 文件大小： | 0K |
| 描述： | IC I/O EXPANDER I2C 16B 24TSSOP |
| 產品培訓模塊： | I²C Bus Fundamentals |
| 特色產品： | NXP - I2C Interface |
| 標準包裝： | 63 |
| 接口： | I²C |
| 輸入/輸出數： | 16 |
| 中斷輸出： | 是 |
| 頻率 - 時鐘： | 400kHz |
| 電源電壓： | 2.3 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 24-TSSOP |
| 包裝： | 管件 |
| 包括： | POR |
| 產品目錄頁面： | 824 (CN2011-ZH PDF) |
| 其它名稱： | 568-4230-5 935283505112 PCA8575PW PCA8575PW-ND |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
PCA8575_2
NXP B.V. 2007. All rights reserved.
Product data sheet
Rev. 02 — 21 March 2007
12 of 30
NXP Semiconductors
PCA8575
Remote 16-bit I/O expander for I2C-bus with interrupt
9.
Characteristics of the I2C-bus
The I2C-bus is for 2-way, 2-line communication between different ICs or modules. The two
lines are a serial data line (SDA) and a serial clock line (SCL). Both lines must be
connected to a positive supply via a pull-up resistor when connected to the output stages
of a device. Data transfer may be initiated only when the bus is not busy.
9.1 Bit transfer
One data bit is transferred during each clock pulse. The data on the SDA line must remain
stable during the HIGH period of the clock pulse as changes in the data line at this time
will be interpreted as control signals (see Figure 15).
9.1.1 START and STOP conditions
Both data and clock lines remain HIGH when the bus is not busy. A HIGH-to-LOW
transition of the data line while the clock is HIGH is dened as the START condition (S). A
LOW-to-HIGH transition of the data line while the clock is HIGH is dened as the STOP
condition (P) (see Figure 16.)
9.2 System conguration
A device generating a message is a ‘transmitter’; a device receiving is the ‘receiver’. The
device that controls the message is the ‘master’ and the devices which are controlled by
the master are the ‘slaves’ (see Figure 17).
Fig 15. Bit transfer
mba607
data line
stable;
data valid
change
of data
allowed
SDA
SCL
Fig 16. Denition of START and STOP conditions
mba608
SDA
SCL
P
STOP condition
SDA
SCL
S
START condition
相關PDF資料 |
PDF描述 |
|---|---|
| PCA9535D,118 | IC I/O EXPANDER I2C 16B 24SOIC |
| 292204-2 | CONN CARD EDGE 8POS DL 2MM TIN |
| ATTINY44V-10SSUR | MCU AVR 4KB FLASH 10MHZ 14-SOIC |
| ATTINY24-20MUR | MCU AVR 2KB FLASH 20MHZ 20QFN |
| ATTINY24V-10MUR | MCU AVR 2KB FLASH 10MHZ 20QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCA8576C | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates |
| PCA8576CH/Q900,157 | 功能描述:LCD 驅動器 UNIVERSAL LCD DRIVER LOW MULTIPLEX RATES RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| PCA8576CH/Q900/1 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates |
| PCA8576CH/Q900/1,1 | 功能描述:LCD 驅動器 MULT DIG/SEG 200KHz RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| PCA8576CH/Q900/1,118 | 制造商:NXP Semiconductors 功能描述:Cut Tape 制造商:NXP Semiconductors 功能描述:0 |
發布緊急采購，3分鐘左右您將得到回復。