
9
PC7410
2141D–HIREL–02/04
Detailed Specification
Scope
This drawing describes the specific requirements for the microprocessor PC7410 in
compliance with Atmel-Grenoble standard screening.
Applicable
Documents
1.
2.
MIL-STD-883: Test methods and procedures for electronics
MIL-PRF-38535: Appendix A: General specifications for microcircuits
Requirements
General
The microcircuits are in accordance with the applicable documents and as specified
herein.
Design and Construction
Terminal Connections
Depending on the package, the terminal connections are as shown in Table 16, Table 4
and Figure 2.
Absolute Maximum
Ratings
Notes:
1. Functional and tested operating conditions are given in Table 4. Absolute maximum ratings are stress ratings only. Stresses
beyond those listed may affect device reliability or cause permanent damage to the device.
2. Caution: V
IN
must not exceed OV
DD
or L2OV
DD
by more than 0.2V at any time including during power-on reset.
3. Caution: L2OV
DD
/OV
DD
must not exceed V
DD
/AV
DD
/L2AV
DD
by more than 2.0V at any time including during power-on reset;
this limit may be exceeded for a maximum of 20 ms during power-on reset and power-down sequences.
4. Caution: V
DD
/AV
DD
/L2AV
DD
must not exceed L2OV
DD
/OV
DD
by more than 0.4V at any time including during power-on reset;
this limit may be exceeded for a maximum of 20 ms during power-on reset and power-down sequences.
5. V
IN
may overshoot/undershoot to a voltage and for a maximum duration as shown in Figure 3.
6. PC7410RXnnnLE (Rev 1.4) and later only. Previous revisions do not support 3.3V OV
DD
and have a maximum value OV
DD
of
-0.3 to 2.6V.
Table 2.
Absolute Maximum Ratings
(1)
Symbol
Characteristic
Value
Unit
V
DD
Core supply voltage
-0.3 to 2.1
(4)
V
AV
DD
PLL supply voltage
-0.3 to 2.1
(4)
V
L2AV
DD
L2 DLL supply voltage
-0.3 to 2.1
(4)
V
OV
DD
60x bus supply voltage
-0.3 to 3.465
(3)(6)
V
L2OV
DD
L2 bus supply voltage
-0.3 to 2.6
(3)
V
V
IN
Processor bus input voltage
L2 bus input voltage
-0.3 to OVDD + 0,2V
(2)(5)
V
V
IN
-0.3 to L2OVDD + 0,2V
(2)(5)
V
V
IN
JTAG signal input voltage
-0.3 to OVDD + 0,2V
V
T
STG
Storage temperature range
-55 to 150
°C
Rework temperature
260
°C