- 您現在的位置：買賣IC網 > PDF目錄369945 > PA7540S-15 PA7540 PEEL Array? Programmable Electrically Erasable Logic Array PDF資料下載
參數資料
| 型號： | PA7540S-15 |
| 英文描述： | PA7540 PEEL Array? Programmable Electrically Erasable Logic Array |
| 中文描述： | PA7540果皮陣列？電可擦除可編程邏輯陣列 |
| 文件頁數： | 3/10頁 |
| 文件大?。?/td> | 239K |
| 代理商： | PA7540S-15 |
3
04-02-051B
Sum-A = D, T, J or Sum-A
Sum-B = Preset, K or Sum-B
Sum-C = Reset, Clock, Sum-C
Sum-D = Clock, Output Enable
D
R
P
Q
D Register
Q = D after clocked
Best for storage, simple counters,
shifters and state machines with
few hold (loop) conditions.
T
R
P
Q
T Register
Q toggles when T = 1
Q holds when T = 0
Best for wide binary counters (saves
product terms) and state machines
with many hold (loop) conditions.
JK Register
Q toggles when J/K = 1/1
Q holds when J/K = 0/0
Q = 1 when J/K = 1/0
Q = 0 when J/K = 0/1
Combines features of both D and T
registers.
J
R
P
Q
K
08-14-005A
Figure 5. LCC Register Types
SUM-A can serve as the D, T, or J input of the register or a
combinatorial path. SUM-B can serve as the K input, or the
preset to the register, or a combinatorial path. SUM-C can
be the clock, the reset to the register, or a combinatorial
path. SUM-D can be the clock to the register or the output
enable for the connected I/O cell. Note that the sums
controlling clocks, resets, presets and output enables are
complete sum-of-product functions, not just product terms
as with most other PLDs. This also means that any input or
I/O pin can be used as a clock or other control function.
Several signals from the global cell are provided primarily
for synchronous (global) register control. The global cell
signals are routed to all LCCs. These signals include a
high-speed clock of positive or negative polarity, global
preset and reset, and a special register-type control that
selectively allows dynamic switching of register type. This
last feature is especially useful for saving product terms
when implementing loadable counters and state machines
by dynamically switching from D-type registers to load and
T-type registers to count (see Figure 10).
Multiple Outputs Per Logic Cell
An important feature of the logic control cell is its capability
to have multiple output functions per cell, each operating
independently. As shown in Figure 4, two of the three
outputs can select the Q output from the register or the
Sum A, B or C combinatorial paths. Thus, one LCC output
can be registered, one output can be combinatorial and the
third, an output enable. The multi-function PEEL Array logic
cells are equivalent to two or three macrocells of other PLDs,
which have only one output per cell. They also allow registers
to be truly buried from I/O pins without limiting them to input-
only (see Figure 8 ).
7540 /O Cell (IOC)
MUX
From
Logic
Control
Cell
A,B,C
or
Q
MUX
1 0
D
I/O Pin
MUX
To
Array
REG/
Latch
Q
I/O Cell Clock
From Global Cell
Input
08-14-006A
Figure 6. I/O Cell Block Diagram
IOC Register
Q = D after rising edge of clock
holds until next rising edge
IOC Latch
Q = L when clock is high
holds value when clock is low
L
Q
D
Q
08-14-007A
Figure 7. IOC Register Configurations
I/O Cell (IOC)
All PEEL Arrays have I/O cells (IOC) as shown above in
Figure 6. Inputs to the IOCs can be fed from any of the LCCs
in the array. Each IOC consists of routing and control
multiplexers, an input register/transparent latch, a three-state
buffer and an output polarity control. The register/ latch can
be clocked from a variety of sources determined by the global
cell. It can also be bypassed for a non-registered input. The
combination of LCC and IOC allows for multiple buried
registers and logic paths. (See Figure 8).
相關PDF資料 |
PDF描述 |
|---|---|
| PA7540SI-15 | PA7540 PEEL Array? Programmable Electrically Erasable Logic Array |
| PA83A | HIGH VOLTAGE POWER OPERATIONAL AMPLIFIERS |
| PA886C02 | SCHOTTKY BARRIER DIODE |
| PA905C4 | LOW LOSS SUPER HIGH SPEED RECTIFIER |
| PA905C6 | LOW LOSS SUPER HIGH SPEED RECTIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PA7540S-15L | 功能描述:EEPLD - 電子擦除可編程邏輯設備 2 Input 20 I/O 15ns RoHS:否 制造商:Atmel 邏輯系列:ATF16V8BQL 最大工作頻率:62 MHz 可編程輸入/輸出端數量:20 電源電流:20 mA 延遲時間:15 ns 每個宏指令的積項數:8 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 大電池數量:8 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-20 |
| PA7540SI-15 | 功能描述:EEPLD - 電子擦除可編程邏輯設備 2 INP 20 I/O 15ns RoHS:否 制造商:Atmel 邏輯系列:ATF16V8BQL 最大工作頻率:62 MHz 可編程輸入/輸出端數量:20 電源電流:20 mA 延遲時間:15 ns 每個宏指令的積項數:8 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 大電池數量:8 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-20 |
| PA7540SI-15L | 功能描述:EEPLD - 電子擦除可編程邏輯設備 2 Input 20 I/O 15ns RoHS:否 制造商:Atmel 邏輯系列:ATF16V8BQL 最大工作頻率:62 MHz 可編程輸入/輸出端數量:20 電源電流:20 mA 延遲時間:15 ns 每個宏指令的積項數:8 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 大電池數量:8 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-20 |
| PA756-68Z | 功能描述:插座和適配器 PLCC68-DIP40 RoHS:否 制造商:Silicon Labs 產品:Adapter 用于:EM35x |
| PA7572 | 制造商:ANACHIP 制造商全稱:Anachip Corp 功能描述:Programmable Electrically Erasable Logic Array |
發布緊急采購，3分鐘左右您將得到回復。