- 您現在的位置：買賣IC網 > PDF目錄361102 > NCP5318FTR2 (ON SEMICONDUCTOR) Two/Three/Four−Phase Buck CPU Controller PDF資料下載
參數資料
| 型號： | NCP5318FTR2 |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | Two/Three/Four−Phase Buck CPU Controller |
| 中文描述： | SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQFP32 |
| 封裝： | LQFP-32 |
| 文件頁數： | 25/31頁 |
| 文件大小： | 384K |
| 代理商： | NCP5318FTR2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁
NCP5318
http://onsemi.com
25
As with any power design, proper laboratory testing
should be performed to insure the design will dissipate the
required power under worst case operating conditions.
Variables considered during testing should include
maximum ambient temperature, minimum airflow,
maximum input voltage, maximum loading and component
variations (i.e., worst case MOSFET R
DS(on)
). Also, the
inductors and capacitors share the MOSFET’s heatsinks and
will add heat and raise the temperature of the circuit board
and MOSFET. For any new design, it is advisable to have as
much heatsink area as possible. All too often, new designs are
found to be too hot and require re
design to add heatsinking.
7. Error Amplifier Tuning
The high frequency gain of the voltage feedback loop
affects transient response and control loop stability. This
loop gain can be adjusted by changing the Error Amplifier’s
high frequency gain, which is done by increasing or
decreasing the Error Amplifier output loading capacitor
(C
AMP
). The Error Amplifier has a transconductance
characteristic (amplifier output current is proportional to
amplifier input voltage), causing amplifier output voltage to
be proportional to amplifier output load impedance.
If C
AMP
is too large, the loop gain at high frequencies will
be too low, and the converter output voltage may exhibit an
underdamped response to a load transient. On the other
hand, if C
AMP
is too small, there will be too much loop gain
at high frequencies, which may decrease converter output
voltage stability. For initial prototype startup, C
AMP
= 10 nF
is recommended. When reducing C
AMP
, peak
to
peak
ripple voltage at the COMP pin should remain less than
20 mVp
p. Excessive ripple at the COMP pin will
contribute to PWM pulse jitter. In general, the lowest loop
gain that achieves acceptable transient response should be
used.
Adding a resistor in series with C
AMP
will increase control
loop damping in response to load transients as shown in
Figures 26 and 27, where 1430 was added in series with
the 1.8 nF C
AMP
(Adaptive Voltage Positioning not used).
Figure 26. Converter Output and COMP Response to
a Load Step (No Droop). 0 in Series with C
AMP
Figure 27. Converter Output and COMP Response to
a Load Step (No Droop), Resistance in Series with
C
AMP
Current
LOAD CURRENT, 60 A/DIV
LOAD CURRENT, 60 A/DIV
OUTPUT VOLTAGE, 50 mV/DIV
OUTPUT VOLTAGE, 50 mV/DIV
COMP VOLTAGE, 100 mV/DIV
COMP VOLTAGE, 100 mV/DIV
20 S/DIV
20 S/DIV
相關PDF資料 |
PDF描述 |
|---|---|
| NCP5318FTR2G | Two/Three/Four−Phase Buck CPU Controller |
| NCP5322ADWG | Two−Phase Buck Controller with Integrated Gate Drivers and 5−Bit DAC |
| NCP5322ADWR2G | Two−Phase Buck Controller with Integrated Gate Drivers and 5−Bit DAC |
| NCP5331FTR2G | Two-Phase PWM Controller with Integrated Gate Drivers |
| NCP5331 | Two-Phase PWM Controller with Integrated Gate Drivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP5318FTR2G | 功能描述:DC/DC 開關控制器 2/3/4 Phase Buck CPU RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| NCP5322A | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Two−Phase Buck Controller with Integrated Gate Drivers and 5−Bit DAC |
| NCP5322A/D | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Two-Phase Buck Controller with integrated Gate Drivers and 5-Bit DAC |
| NCP5322A_07 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Two−Phase Buck Controller with Integrated Gate Drivers and 5−Bit DAC |
| NCP5322ADW | 功能描述:DC/DC 開關控制器 2 Phase Buck w/Gate RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
發布緊急采購，3分鐘左右您將得到回復。