參數資料
型號: NCP1080DEG
廠商: ON Semiconductor
文件頁數: 11/15頁
文件大小: 221K
描述: IC CONV CTLR POE-PD 13W 20-TSSOP
標準包裝: 74
類型: 以太網供電開關(PoE)
應用: 遠程外設(工業控制,相機,數據訪問)
內部開關:
電流限制: 500mA
電源電壓: 0 V ~ 57 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 20-TSSOP(0.173",4.40mm 寬)裸露焊盤
供應商設備封裝: 20-TSSOP-EP
包裝: 管件
NCP1080
http://onsemi.com
11
When using the external resistor divider, the NCP1080 has an external reference voltage hysteresis of 15% typical.
 Inrush and Operational Current Limitations
The inrush current limit and the operational current limit are programmed individually by an external Rinrush and Rilim1
resistors respectively connected between INRUSH and VPORTN
1,2
, and between ILIM1 and VPORTN
1,2
 as shown in
Figure 9.
ILIM1 /
INRUSH
VDDA1
Vbg1
VDDA1
VPORTNx
Ilim_ref
NCP1080
Figure 9. Current Limitation Configuration (Inrush & Ilim1 Pins)
Ilim1
Vds_pgood
threshold
VPORTNx
Pass Switch
Inrush
I_pass_switch
NCP1080
RTN
VDS_PGOOD
0
1
VDDA1
VDDA1
1 V / 9.2 V
2 V
Current_limit_ON
&
detector
Figure 10. Inrush and Ilim1 Selection Mechanism
VDDA1
When VPORT reaches the UVLO_on level, the Cpd
capacitor is charged with the INRUSH current (in order to
limit the internal power dissipation of the passswitch).
Once the Cpd capacitor is fully charged, the current limit
switches from the inrush current to the current limit level
(ilim1) as shown in Figure 10. This transition occurs when
both following conditions are satisfied:
1. The VDS of the passswitch is below the
Vds_pgood low level (1 V typical).
2. The passswitch is no longer in current limit
mode, meaning the gate of the passswitch is
high (above 2 V typical).
The operational current limit will stay selected as long as
Vds_pgood is true (meaning that RTNVPORTN
1,2
  is
below the high level of Vds_pgood). This mechanism allows
a current level transition without any current spike in the
passswitch because the operational current limit (ilim1) is
enabled once the passswitch is not limiting the current
anymore, meaning that the Cpd capacitor is fully charged.
 Thermal Shutdown
The NCP1080 includes thermal protection which shuts
down the device in case of high power dissipation. Once the
thermal shutdown (TSD) threshold is exceeded, following
blocks are turned off:
" DCDC controller
" Passswitch
" VDDH and VDDL regulators
" CLASS regulator
When the TSD error disappears and if the input line
voltage is still above the UVLO level, the NCP1080
automatically restarts with the current limit set in the inrush
state, the DCDC controller is disabled and the Css
相關PDF資料
PDF描述
NCP1081DEG IC CONV CTLR POE-PD 40W 20-TSSOP
NCP1082DEG IC CONV CTLR POE-PD 13W 20-TSSOP
NCP1083DEG IC CONV CTLR POE-PD 40W 20-TSSOP
NCP1501DMR2G IC REG SGL BUCK/LINEAR 8MICRO
NCP1578MNR2G IC REG DL BCK/LINEAR SYNC 20-QFN
相關代理商/技術參數
參數描述
NCP1080DER2G 功能描述:直流/直流開關轉換器 POE-PD 13W DC-DC RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
NCP1081 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Integrated High Power PoE-PD Interface & DC-DC Converter Controller
NCP1081DEG 功能描述:DC/DC 開關控制器 POE-PD 40W DC-DC RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
NCP1081DER2G 功能描述:DC/DC 開關控制器 POE-PD 40W DC-DC RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
NCP1081SPCGEVB 功能描述:電源管理IC開發工具 HPOWER POE-PD SPLITTER RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V