參數資料
型號: MVTX2602
廠商: Zarlink Semiconductor Inc.
英文描述: Managed 24 Port 10/100 Mbps Ethernet Switch
中文描述: 管理的24端口10/100 Mbps以太網交換機
文件頁數: 35/147頁
文件大?。?/td> 924K
代理商: MVTX2602
MVTX2602
Data Sheet
35
Zarlink Semiconductor Inc.
Example: Suppose that the user wants to restrict Fast Ethernet port P’s average departure rate to 32 Mbps – 32%
of line rate – when the average is taken over a period of 10 ms. In an interval of 10 ms, exactly 40000 bytes can be
transmitted at an average rate of 32 Mbps.
So how do we set the parameters The rate control parameters are contained in an internal RAM block accessible
through the CPU port (See Programming QoS Registers application note and Processor interface application note).
The data format is shown below.
As we indicated earlier, the number of bytes is measured in 8-byte increments, so the 16-bit field "Number of bytes"
should be set to 40000/8, or 5000. In addition, the time interval has to be indicated in units of 10 ms. Though we
want the average data rate on port P to be 32 Mbps when measured over an interval of 10 ms, we can also adjust
the maximum number of bytes that can be transmitted at full line rate in any single burst. Suppose we wish this limit
to be 12 kilobytes. The number of bytes is measured in 8-byte increments, so the 16-bit field "Maximum burst size"
is set to 12000/8, or 1500.
7.7 WRED Drop Threshold Management Support
To avoid congestion, the Weighted Random Early Detection (WRED) logic drops packets according to specified
parameters. The following table summarizes the behaviour of the WRED logic.
Table 7 - WRED Drop Thresholds
Px is the total byte count, in the priority queue x. The WRED logic has three drop levels, depending on the value of
N, which is based on the number of bytes in the priority queues. If delay bound scheduling is used, N equals
P3*16+P2*4+P1. If using WFQ scheduling, N equals P3+P2+P1. Each drop level from one to three has defined
high-drop and low-drop percentages, which indicate the minimum and maximum percentages of the data that can
be discarded. The X, Y Z percent can be programmed by the register RDRC0, RDRC1. In Level 3, all packets are
dropped if the bytes in each priority queue exceed the threshold. Parameters A, B, C are the byte count thresholds
for each priority queue. They can be programmed by the QOS control register (refer to the register group 5). See
Programming QoS Registers application note for more information.
63:40
39:32
31:16
15:0
0
Time interval
Maximum burst size
Number of bytes
In KB (kilobytes)
P3
P2
P1
High Drop
Low Drop
Level 1
N
120
P3
AKB
P2
BKB
P1
CKB
X%
0%
Level 2
N
140
Y%
Z%
Level 3
N
160
100%
100%
相關PDF資料
PDF描述
MVTX2602AG Managed 24 Port 10/100 Mbps Ethernet Switch
MVTX2603 Unmanaged 24-Port 10/100 Mb + 2-Port 1 Gb Ethernet Switch
MVTX2603AG Unmanaged 24-Port 10/100 Mb + 2-Port 1 Gb Ethernet Switch
MVTX2604 Managed 24-Port 10/100 Mb + 2 Port 1 Gb Ethernet Switch
MVTX2604AG Managed 24-Port 10/100 Mb + 2 Port 1 Gb Ethernet Switch
相關代理商/技術參數
參數描述
MVTX2602A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MVTX260x Port Mirroring
MVTX2602AG 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Managed 24 Port 10/100 Mbps Ethernet Switch
MVTX2602AG2 制造商:Microsemi Corporation 功能描述:
MVTX2603 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Unmanaged 24-Port 10/100 Mb + 2-Port 1 Gb Ethernet Switch
MVTX2603A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Unmanaged 24 port 10/100Mb + 2 port 1Gb Ethernet switch