- 您現在的位置：買賣IC網 > PDF目錄376196 > MSP3425G (Electronic Theatre Controls, Inc.) MSP 34x5G Multistandard Sound Processor Family PDF資料下載
參數資料
| 型號： | MSP3425G |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | MSP 34x5G Multistandard Sound Processor Family |
| 中文描述： | 中型34x5G多標準聲音處理器系列 |
| 文件頁數： | 88/98頁 |
| 文件大?。?/td> | 1541K |
| 代理商： | MSP3425G |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁當前第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁
MSP 34x5G
PRELIMINARY DATA SHEET
88
Micronas
6.4.4. NICAM Error Rate Register
Average error rate of the NICAM reception in a time
interval of 182 ms, which should be close to 0. The ini-
tial and maximum value of ERROR_RATE is 2047.
This value is also active if the NICAM bit of
MODE_REG is not set. Since the value is achieved by
filtering, a certain transition time (approx. 0.5 sec) is
unavoidable. Acceptable audio may have error rates
up to a value of 700 int. Individual evaluation of this
value by the controller and an appropriate threshold
may define the fallback mode from NICAM to FM/
AM-mono in case of poor NICAM reception.
The bit error rate per second (BER) can be calculated
by means of the following formula:
BER= ERROR_RATE * 12.3*10
6
/s
6.4.5. PLL_CAPS Readback Register
It is possible to read out the actual setting of the
PLL_CAPS. In standard applications, this register is
not of interest for the customer.
6.4.6. AGC_GAIN Readback Register
It is possible to read out the actual setting of
AGC_GAIN in Automatic Gain Mode. In standard
applications, this register is not of interest for the cus-
tomer
.
6.4.7. Automatic Search Function for FM-Carrier
Detection in Satellite Mode
The AM demodulation ability of the MSP 3415G and
MSP 3455G offers the possibility to calculate the
“
field
strength
”
of the momentarily selected FM carrier,
which can be read out by the controller. In SAT receiv-
ers, this feature can be used to make automatic FM
carrier search possible.
For this, the MSP has to be switched to AM-mode
(MODE_REG[8]), FM-Prescale must be set to
7F
hex
= +127
dec
, and the FM DC notch (see
Section 6.5.7.)
must be switched off. The sound-IF fre-
quency range must now be
“
scanned
”
in the
MSP-channel 2 by means of the programmable
quadrature mixer with an appropriate incremental fre-
quency (i.e. 10 kHz). After each incrementation, a field
strength value is available at the quasi-peak detector
output (quasi-peak detector source must be set to
FM), which must be examined for relative maxima by
the controller. This results in either continuing search
or switching the MSP back to FM demodulation mode.
During the search process, the FIR2 must be loaded
with the coefficient set
“
AUTOSEARCH
”
, which
enables small bandwidth, resulting in appropriate field
strength characteristics. The absolute field strength
value (can be read out of
“
quasi peak detector output
FM1
”
) also gives information on whether a main FM
carrier or a subcarrier was detected; and as a practical
consequence, the FM bandwidth (FIR1/2) and the
deemphasis (50
μ
s or adaptive) can be switched
accordingly.
Due to the fact that a constant demodulation frequency
offset of a few kHz, leads to a DC level in the demodu-
lated signal, further fine tuning of the found carrier can
be achieved by evaluating the
“
DC Level Readout
FM1
”
. Therefore, the FM DC Notch must be switched
on, and the demodulator part must be switched back to
FM-demodulation mode.
For a detailed description of the automatic search
function, please refer to the corresponding MSP Win-
dows software.
ERROR_RATE
00 57
hex
Error free
0000
hex
maximum error rate
07FF
hex
PLL_CAPS
02 1F
hex
L
minimum frequency
1111 1111
FF
hex
nominal frequency
0101 0110
RESET
56
hex
maximum frequency
0000 0000
00
hex
PLL_CAPS
02 1F
hex
H
PLL open
xxxx xxx0
PLL closed
xxxx xxx1
AGC_GAIN
02 1E
hex
max. amplification
(20 dB)
0001 0100
14
hex
min. amplification
(3 dB)
0000 0000
00
hex
相關PDF資料 |
PDF描述 |
|---|---|
| MSP3435G | MSP 34x5G Multistandard Sound Processor Family |
| MSP3445G | MSP 34x5G Multistandard Sound Processor Family |
| MSP34X5G | MSP 34x5G Multistandard Sound Processor Family |
| MSP3430 | Multistandard Sound Processor Family |
| MSP34X1G | Multistandard Sound Processor Family with Virtual Dolby Surround |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MSP3425GB8V3 | 制造商:MICRONAS 功能描述: |
| MSP3427G | 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Multistandard Sound Processor Family |
| MSP3430 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Multistandard Sound Processor Family |
| MSP3430G-A4 | 制造商:Micronas 功能描述: |
| MSP3430G-QA-A4 | 制造商:MICR 功能描述:3430G-QA-A4 |
發布緊急采購，3分鐘左右您將得到回復。