參數資料
型號: MQ80C32E-36:RD
廠商: TEMIC SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 8-BIT, 36 MHz, MICROCONTROLLER, CQFP44
文件頁數: 103/109頁
文件大?。?/td> 10824K
805
32117D–AVR-01/12
AT32UC3C
30.5.3
Clocks
The clock for the IISC bus interface (CLK_IISC) is generated by the Power Manager. This clock
is enabled at reset, and can be disabled in the Power Manager. It is recommended to disable the
IISC before disabling the clock, to avoid freezing the IISC in an undefined state.
One of the generic clocks is connected to the IISC. The generic clock (GCLK_IISC) can be set to
a wide range of frequencies and clock sources. The GCLK_IISC must be enabled and config-
ured before use. Refer to the module configuration section for details on the GCLK_IISC used
for the IISC. The frequency for this clock has to be set as described in Table.
30.5.4
DMA
The IISC DMA handshake interfaces are connected to the Peripheral DMA Controller. Using the
IISC DMA functionality requires the Peripheral DMA Controller to be programmed first.
30.5.5
Interrupts
The IISC interrupt line is connected to the Interrupt Controller. Using the IISC interrupt requires
the Interrupt Controller to be programmed first.
30.5.6
Debug Operation
When an external debugger forces the CPU into debug mode, the IISC continues normal opera-
tion. If this module is configured in a way that requires it to be periodically serviced by the CPU
through interrupt requests or similar, improper operation or data loss may result during
debugging.
30.6
Functional Description
30.6.1
Initialization
The IISC features a Receiver, a Transmitter, and, for Master and Controller modes, a Clock
Generator. Receiver and Transmitter share the same Serial Clock and Word Select.
Before enabling the IISC, the chosen configuration must be written to the Mode Register (MR).
The IMCKMODE, MODE, FORMAT, and DATALENGTH fields in the MR register must be writ-
ten. If FORMAT is configured in one of the TDM formats, then the NBCHAN and TDMFS fields
must also be written. If the IMCKMODE field is written as one, then the IMCKFS field should be
written with the chosen ratio, as described in Section 30.6.6 ”Serial Clock and Word Select Gen-
Once the Mode Register has been written, the IISC Clock Generator, Receiver, and Transmitter
can be enabled by writing a one to the CKEN, RXEN, and TXEN bits in the Control Register
(CR). The Clock Generator can be enabled alone, in Controller Mode, to output clocks to the
IMCK, ISCK, and IWS pins. The Clock Generator must also be enabled if the Receiver or the
Transmitter is enabled.
The Clock Generator, Receiver, and Transmitter can be disabled independently by writing a one
to CR.CXDIS, CR.RXDIS and/or CR.TXDIS respectively. Once requested to stop, they will only
stop when the transmission of the pending frame transmission will be completed.
30.6.2
Basic Operation
The Receiver can be operated by reading the Receiver Holding Register (RHR), whenever the
Receive Ready (RXRDY) bit in the Status Register (SR) is set. Successive values read from
RHR will correspond to the samples from the left and right audio channels, or from channels 0 to
MR.NBCHAN in TDM mode, for the successive frames.
相關PDF資料
PDF描述
S80C32-40:R 8-BIT, 40 MHz, MICROCONTROLLER, PQCC44
S80C52EXXX-30:D 8-BIT, MROM, 30 MHz, MICROCONTROLLER, PQCC44
SC80C52XXX-36/883 8-BIT, MROM, 36 MHz, MICROCONTROLLER, CDIP40
S83C154TXXX-25 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PQCC44
S83C154XXX-25R 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PQCC44
相關代理商/技術參數
參數描述
MQ82370-20 制造商:Rochester Electronics LLC 功能描述:- Bulk
MQ8238020 制造商:Intel 功能描述:CONTROLLER: OTHER
MQ82380-20 制造商:Rochester Electronics LLC 功能描述:- Bulk
MQ82380-20/R 制造商:Rochester Electronics LLC 功能描述:
MQ82592 制造商:Rochester Electronics LLC 功能描述:- Bulk