參數資料
型號: MPC8536EBVTAVLA
廠商: Freescale Semiconductor
文件頁數: 18/126頁
文件大小: 0K
描述: MPU PWRQUICC III 1500MHZ 783PBGA
產品培訓模塊: MPC8536E QUICC III Processor
標準包裝: 1
系列: MPC85xx
處理器類型: 32-位 MPC85xx PowerQUICC III
速度: 1.5GHz
電壓: 1.1V
安裝類型: 表面貼裝
封裝/外殼: 783-BBGA,F(xiàn)CBGA
供應商設備封裝: 783-FCPBGA(29x29)
包裝: 托盤
其它名稱: MPC8536EBVTAVL
MPC8536EBVTAVL-ND
MPC8536E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 5
Hardware Design Considerations
Freescale Semiconductor
114
The heat sink removes most of the heat from the chip for most applications. Heat generated on the active side of the chip is
conducted through the silicon and through the heat sink attach material (or thermal interface material), and finally to the heat
sink. The junction-to-case thermal resistance is low enough that the heat sink attach material and heat sink thermal resistance
are the dominant terms.
2.24.3.2
Thermal Interface Materials
A thermal interface material is required at the package-to-heat sink interface to minimize the thermal contact resistance. The
performance of thermal interface materials improves with increased contact pressure. This performance characteristic chart is
generally provided by the thermal interface vendors.
3
Hardware Design Considerations
This section provides electrical and thermal design recommendations for successful application of the chip.
3.1
System Clocking
This chip includes seven PLLs:
The platform PLL generates the platform clock from the externally supplied SYSCLK input. The frequency ratio
between the platform and SYSCLK is selected using the platform PLL ratio configuration bits as described in
The e500 core PLL generates the core clock as a slave to the platform clock. The frequency ratio between the e500
core clock and the platform clock is selected using the e500 PLL ratio configuration bits as described in Section 2.23.3,
The PCI PLL generates the clocking for the PCI bus
The local bus PLL generates the clock for the local bus.
There is a PLL for the SerDes1 block to be used for PCI Express interface
There is a PLL for the SerDes2 block to be used for SGMII and SATA interfaces.
The DDR PLL generates the DDR clock from the externally supplied DDRCLK input in asynchronous mode. The
frequency ratio between the DDR clock and DDRCLK is described in Section 2.23.4, “DDR/DDRCLK PLL Ratio.
3.2
Power Supply Design and Sequencing
3.2.1
PLL Power Supply Filtering
Each of the PLLs listed above is provided with power through independent power supply pins (AVDD_PLAT, AVDD_CORE,
AVDD_PCI, AVDD_LBIU, and AVDD_SRDS respectively). The AVDD level should always be equivalent to VDD, and
preferably these voltages will be derived directly from VDD through a low frequency filter scheme such as the following.
There are a number of ways to reliably provide power to the PLLs, but the recommended solution is to provide independent
filter circuits per PLL power supply as illustrated in Figure 75, one to each of the AVDD pins. By providing independent filters
to each PLL the opportunity to cause noise injection from one PLL to the other is reduced.
This circuit is intended to filter noise in the PLLs resonant frequency range from a 500 kHz to 10 MHz range. It should be built
with surface mount capacitors with minimum Effective Series Inductance (ESL). Consistent with the recommendations of Dr.
Howard Johnson in High Speed Digital Design: A Handbook of Black Magic (Prentice Hall, 1993), multiple small capacitors
of equal value are recommended over a single large value capacitor.
Each circuit should be placed as close as possible to the specific AVDD pin being supplied to minimize noise coupled from
nearby circuits. It should be possible to route directly from the capacitors to the AVDD pin, which is on the periphery of 783
FC-PBGA the footprint, without the inductance of vias.
相關PDF資料
PDF描述
FMM12DREN CONN EDGECARD 24POS .156 EYELET
MPC8536EBVTAQGA MPU PWRQUICC III 1000MHZ 783PBGA
MPC8536EBVTANGA MPU PWRQUICC III 800MHZ 783PBGA
MPC8535EBVTAQGA MCU PWRQUICC II 1000MHZ 783-PBGA
MC68LC040RC25A IC MPU 32BIT 25MHZ 179-PGA
相關代理商/技術參數
參數描述
MPC8536ECVJAVLA 功能描述:IC MPU MPC85XX 1.5GHZ 783FCBGA 制造商:nxp usa inc. 系列:MPC85xx 包裝:托盤 零件狀態:在售 核心處理器:PowerPC e500 核數/總線寬度:1 ??,32 位 速度:1.5GHz 協處理器/DSP:安全;SEC RAM 控制器:DDR2,DDR3 圖形加速:無 顯示與接口控制器:- 以太網:10/100/1000 Mbps(2) SATA:SATA 3Gbps(2) USB:USB 2.0(3) 電壓 - I/O:1.8V,2.5V,3.3V 工作溫度:-40°C ~ 105°C(TA) 安全特性:密碼技術 封裝/外殼:783-BBGA,F(xiàn)CBGA 供應商器件封裝:783-FCPBGA(29x29) 附加接口:DUART,I2C,MMC/SD,PCI,SPI 基本零件編號:MPC8536 標準包裝:36
MPC8536ECVTAKG 功能描述:微處理器 - MPU 32-BIT 600MHz RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8536ECVTAKGA 功能描述:微處理器 - MPU 8536 Encrypted RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8536ECVTANG 功能描述:微處理器 - MPU 32-BIT 800MHz RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8536ECVTANGA 功能描述:微處理器 - MPU 8536 Encrypted RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324