參數資料
型號: MPC5200CBV266R2
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: 266 MHz, MICROPROCESSOR, PBGA272
封裝: 27 X 27 MM, 1.27 MM PITCH, PLASTIC, BGA-272
文件頁數: 31/80頁
文件大?。?/td> 6728K
代理商: MPC5200CBV266R2
Electrical and Thermal Characteristics
MPC5200 Data Sheet, Rev. 4
Freescale Semiconductor
37
(t)LI
015001500150
Limited Interlock time.1,2
A8.34
(t)MLI
20
20
20
Interlock time with minimum.1,2
A8.35
(t)UI
0
0
0
Unlimited interlock time. 1,2
A8.36
(t)AZ
10
10
10
Maximum time allowed for output drivers to release
from being asserted or negated
A8.37
(t)ZAH
20
20
20
Minimum delay time required for output drivers to
assert or negate from released state
A8.38
(t)ZAD
0—0—0—
A8.39
(t)ENV
20
70
20
70
20
70
Envelope time—from DMACK to STOP and
HDMARDY during data out burst initiation.
A8.40
(t)SR
50
30
20
STROBE to DMARDY time, if DMARDY is negated
before this long after STROBE edge, the recipient
receives no more than one additional data word.
A8.41
(t)RFS
75
60
50
Ready-to-Final STROBE time—no STROBE edges
are sent this long after negation of DMARDY.
A8.42
(t)RP
160
125
100
Ready-to-Pause time—the time recipient waits to
initiate pause after negating DMARDY.
A8.43
(t)IORDYZ
20
20
20
Pull-up time before allowing IORDY to be released.
A8.44
(t)ZIORDY
0
0
0
Minimum time drive waits before driving IORDY
A8.45
(t)ACK
20
20
20
Setup and hold times for DMACK, before assertion or
negation.
A8.46
(t)SS
50
50
50
Time from STROBE edge to negation of DMARQ or
assertion of STOP, when sender terminates a burst.
A8.47
NOTES:
1
tUI, tMLI, tLI indicate sender-to-recipient or recipient-to-sender interlocks. That is, one agent (either sender or recipient)
is waiting for the other agent to respond with a signal before proceeding.
tUI is an unlimited interlock that has no maximum time value.
tMLI is a limited time-out that has a defined minimum.
tLI is a limited time-out that has a defined maximum.
2
All timing parameters are measured at the connector of the drive to which the parameter applies. For example, the
sender shall stop generating STROBE edges tRFS after negation of DMARDY. Both STROBE and DMARDY timing
measurements are taken at the connector of the sender. Even though the sender stops generating STROBE edges,
the receiver may receive additional STROBE edges due to propagation delays. All timing measurement switching
points (low to high and high to low) are taken at 1.5 V.
Table 29. Ultra DMA Timing Specification (continued)
Name
MODE 0
(ns)
MODE 1
(ns)
MODE 2
(ns)
Comment
SpecID
Min
Max
Min
Max
Min
Max
相關PDF資料
PDF描述
MPC5200CBV266BR2 266 MHz, MICROPROCESSOR, PBGA272
MPC5200BV400B 400 MHz, MICROPROCESSOR, PBGA272
MPC5200CBV400B 400 MHz, MICROPROCESSOR, PBGA272
MPC5200BV400BR2 400 MHz, MICROPROCESSOR, PBGA272
SPC5200CBV466B 466 MHz, MICROPROCESSOR, PBGA272
相關代理商/技術參數
參數描述
MPC5200CBV400 功能描述:微處理器 - MPU 400MHz 760MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC5200CBV400B 制造商:Freescale Semiconductor 功能描述:
MPC5200CVR266 功能描述:微處理器 - MPU NO-PB IND’L 5200 266MHZ RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC5200CVR400 功能描述:微處理器 - MPU NO-PB IND’L 5200 400MHZ RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC5200CVR400B 功能描述:微處理器 - MPU HABANERO INDUS PBFREE RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324