- 您現在的位置：買賣IC網 > PDF目錄69035 > ML67Q4002LA (OKI ELECTRIC INDUSTRY CO LTD) 32-BIT, FLASH, 33.333 MHz, RISC MICROCONTROLLER, PBGA144 PDF資料下載
參數資料
| 型號： | ML67Q4002LA |
| 廠商： | OKI ELECTRIC INDUSTRY CO LTD |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 33.333 MHz, RISC MICROCONTROLLER, PBGA144 |
| 封裝： | 11 X 11 MM, 0.80 MM PITCH, PLASTIC, LFBGA-144 |
| 文件頁數： | 15/19頁 |
| 文件大?。?/td> | 645K |
| 代理商： | ML67Q4002LA |
Oki Semiconductor 5
ML674001/ML67Q4002/ML67Q4003
April 2004, Rev 2.0
Pulse Width Modulation
This MCU contains two channels of Pulse Width Modulation (PWM) function
which can change the duty cycle of a waveform with a constant period. The
PWM output resolution is 16 bits for each channel.
A/D Converter
Successive approximation type A/D converter.
1. 10 bits x 4 channels
2. Sample and hold function
3. Scan mode and select mode are supported
4. Interrupt is generated after completion of conversion.
5. Conversion time: 5 s (min).
Power Management
HALT, STANDBY and clock gear clock control functions are supported as
power save functions.
1. HALT mode
HALT object
- CPU, internal RAM, AHB bus control
HALT mode setting: Set by the system control register.
Exit HALT mode due to: Reset, interrupt
2. STANDBY mode
Stops the clock for the entire device.
STANDBY mode setting: Specied by the system control register.
Exit STANDBY mode due to: Reset, external interrupt (other than EFIQ_N)
3. Clock gear
The MCU has two clock systems, HCLK and CCLK. Configure HCLK
and CCLK frequency.
HCLK: CPU, bus control, synchronous serial interface, I2C.
CCLK: Timers, PWM SIO, AD converter, etc.
4. Clock control by each function unit
AD converter, PWM, Timers, DRAMC, DMAC, UART(FIFO), SIO, SSIO,
I2C.
Built-In Flash ROM Programming
The robust features of the ash permit simple and optimized programming of
the ash-ROM.
1. There are three methods for programming the FLASH-ROM
- Programming via the JTAG interface
- Programming using boot mode
Boot mode is used by the host to download data to the FLASH ROM via
the UART interface.
A program stored in the on-chip boot ROM is used to transfer the
incoming serial data on the UART interface to the internal Flash ROM.
- Programming via a user application running from external memory
Internal ash can be programmed by executing a user ash program-
ming application from external memory.
2. Single power source for reading and programming of FLASH: 3.0V to
3.6V
3. Programming units: 2 bytes
4. Selectable erasing size
- Sector erase: 2 KBytes/sector
- Block erase: 64 KBytes/block
- Chip erase: All memory cell
5. Word program time: 20 sec (2 bytes)
6. Sector/block erase time: 25 msec
7. Chip erase time: 100 msec
8. Write protection
- Block protect: top address 8Kwords can be protected
- Chip protect: all words can be protected
9. Number of commands: 9
10. Highly reliable read/program
- Sector programming: 1,000 times
- Data hold period: 10 years
相關PDF資料 |
PDF描述 |
|---|---|
| ML674001LA | 32-BIT, MROM, 33.333 MHz, RISC MICROCONTROLLER, PBGA144 |
| ML67Q4051TC | RISC MICROCONTROLLER, PQFP144 |
| ML67Q4060TB | RISC MICROCONTROLLER, PQFP64 |
| ML67Q4050TC | RISC MICROCONTROLLER, PQFP144 |
| ML696201LA | 32-BIT, MROM, 120 MHz, RISC MICROCONTROLLER, PBGA272 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ML67Q4003 | 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:32-bit ARM-Based General-Purpose Microcontroller |
| ML67Q4003-1NNNTCZ03A | 制造商:OKI Semiconductor 功能描述:OKIML67Q4003-1NNNTCZ03A 32-bit ARM Micro 制造商:ROHM Semiconductor 功能描述:RHOML67Q4003-1NNNTCZ03A ML67Q4003-1NNNTC |
| ML67Q4003LA | 制造商:ROHM Semiconductor 功能描述: |
| ML67Q4003TC | 制造商:ROHM Semiconductor 功能描述: |
| ML67Q4050-1NNNTCZG3A | 功能描述:ARM微控制器 - MCU 16/32-BIT ARM7TDMI 64KB FLASH 16KB RAM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。