參數資料
型號： MIC2583R-MBQS TR
廠商： Micrel Inc
文件頁數： 3/25頁
文件大?。?/td> 826K
描述： IC CTRLR HOT SWAP 200MV 16-QSOP
標準包裝： 2,500
類型： 熱交換控制器
應用： 通用
內部開關： 無
電源電壓： 2.3 V ~ 13.2 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-SSOP（0.154"，3.90mm 寬）
供應商設備封裝： 16-QSOP
包裝： 帶卷 (TR)
其它名稱： MIC2583R-MBQSTR
MIC2583R-MBQSTR-ND
Micrel, Inc.
MIC2582/MIC2583
 
 
April 2009 
3
M9999-043009-C
 
Pin Description 
Pin Number
8-Pin SOIC
Pin Number
16-Pin QSOP
Pin Name
Pin Name
1
1
/POR
Power-On Reset Output: Open drain N-channel device, Active Low. This pin
remains asserted during start-up until a time period (t
POR
) after the FB pin
voltage rises above the power-good threshold (VFB). The timing capacitor C
POR
 
determines t
POR
. When the output voltage monitored at the FB pin falls below
V
FB
, /POR is asserted for a minimum of one timing cycle (t
POR
). The /POR pin
requires a pull-up resistor (10k& minimum) to VCC.
2
3
ON
ON Input: Active High. The ON pin, an input to a Schmitt-triggered comparator
used to enable/disable the controller, is compared to a 1.24V reference with
50mV of hysteresis. When a logic high is applied to the ON pin (V
ON
 > 1.24V), a
start-up sequence begins when the GATE pin starts ramping up towards its final
operating voltage. When the ON pin receives a logic low signal (V
ON
 < 1.19V),
the GATE pin is grounded and /FAULT remains high if VCC is above the UVLO
threshold. ON must be low for 20祍 in order to initiate a start-up sequence.
Additionally, toggling the ON pin LOW to HIGH resets the circuit breaker.
3
4
CPOR
Power-On Reset Timer: A capacitor connected between this pin and ground sets
the supply contact start-up delay (t
START
) and the power-on reset interval (t
POR
).
When VCC rises above the UVLO threshold, the capacitor connected to C
POR
 
begins to charge. When the voltage at CPOR crosses 0.3V, the start-up
threshold (V
START
), a start cycle is initiated if ON is asserted while capacitor C
POR
 
is immediately discharged to ground. When the voltage at FB rises above V
FB
,
capacitor C
POR
 begins to charge again. When the voltage at CPOR rises above
the power-on reset delay threshold (V
TH
), the timer resets by pulling CPOR to
ground, and /POR is de-asserted. If C
POR
is left open, then t
START
 defaults to
20祍.
4
7, 8
GND
Ground Connection: Tie to analog ground.
5
12
FB
Power-Good Threshold Input (Under-voltage Detect): This input is internally
compared to a 1.24V reference with 30mV of hysteresis. An external resistive
divider may be used to set the voltage at this pin. If this input momentarily goes
below 1.24V, then /POR is activated for one timing cycle, t
POR
, indicating an
output under-voltage condition. The /POR signal de-asserts one timing cycle
after the FB pin exceeds the power-good threshold by 30mV. A 5祍 filter on this
pin prevents glitches from inadvertently activating this signal.
6
14
GATE
Gate Drive Output: Connects to the gate of an external N-channel MOSFET. An
internal clamp ensures that no more than 9V is applied between the GATE pin
and the source of the external MOSFET. The GATE pin is immediately brought
low when either the circuit breaker trips or an under-voltage lockout condition
occurs.
7
15
SENSE
Circuit Breaker Sense Input: A resistor between this pin and VCC sets the
current limit threshold. Whenever the voltage across the sense resistor exceeds
the slow trip current limit threshold (V
TRIPSLOW
), the GATE voltage is adjusted to
ensure a constant load current. If V
TRIPSLOW
 (50mV) is exceeded for longer than
time period t
OCSLOW
, then the circuit breaker is tripped and the GATE pin is
immediately pulled low. If the voltage across the sense resistor exceeds the fast
trip circuit breaker threshold, V
TRIPFAST
, at any point due to fast, high amplitude
power supply faults, then the GATE pin is immediately brought low without delay.
To disable the circuit breaker, the SENSE and VCC pins can be tied together.
The default V
TRIPFAST
 for either device is 100mV. Other fast trip thresholds are
available: 150mV, 200mV, or OFF (V
TRIPFAST
 disabled). Please contact factory for
availability of other options.
8
16
VCC
Positive Supply Input: 2.3V to 13.2V. The GATE pin is held low by an internal
under-voltage lockout circuit until VCC exceeds a threshold of 2.2V. If VCC
exceeds 13.2V, an internal shunt regulator protects the chip from transient
voltages up to 20V at the VCC and SENSE pins.
相關PDF資料
PDF描述
MIC2585-2MBTS TR IC CTRLR HOT SWAP DUAL 24-TSSOP
MIC2586R-2BM TR IC CTRLR/SEQ HOT SWAP 14-SOIC
MIC2587R-2BM TR IC CTRLR HOT SWAP POS HV 8-SOIC
MIC2590B-5BTQ TR IC PCI HOT PLUG CTLR DUAL 48TQFP
MIC2591B-2BTQ TR IC PCI HOT PLUG CTLR DUAL 48TQFP
相關代理商/技術參數
參數描述
MIC2583R-MYQS 功能描述:熱插拔功率分布 Single-Channel Hot-Swap Controller - 200mV Fast-Trip Threshold - Lead Free RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
MIC2583R-MYQS TR 功能描述:熱插拔功率分布 Single-Channel Hot-Swap Controller - 200mV Fast-Trip Threshold - Lead Free RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
MIC2584-JBTS 功能描述:IC CTRLR HOT SWAP DUAL 16-TSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件
MIC2584-JBTS TR 功能描述:IC CTRLR HOT SWAP DUAL 16-TSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件
MIC2584-JYTS 功能描述:熱插拔功率分布 Dual Channel Hot-Swap Controller - 100mV Threshold - Lead Free RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*