- 您現在的位置：買賣IC網 > PDF目錄359159 > MDS108AL (ZARLINK SEMICONDUCTOR INC) MicroFit 3.0 Header Vert CPI 6 ckt 569 PDF資料下載
參數資料
| 型號： | MDS108AL |
| 廠商： | ZARLINK SEMICONDUCTOR INC |
| 元件分類： | 網絡接口 |
| 英文描述： | MicroFit 3.0 Header Vert CPI 6 ckt 569 |
| 中文描述： | DATACOM, LAN SWITCHING CIRCUIT, PQFP208 |
| 封裝： | 28 X 28 MM, 3.32 MM HEIGHT, PLASTIC, MO-143, QFP-208 |
| 文件頁數： | 30/37頁 |
| 文件大小： | 308K |
| 代理商： | MDS108AL |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
MDS108
Data Sheet
30
Zarlink Semiconductor Inc.
13.2 Strap Options
The Strap options are relevant during the initial power-on period, when reset is asserted. During reset, the MDS108
will examine the boot strap address pin to determine its value and modify the internal configuration of the chip
accordingly.
"1" mean Pull-up
"0" means Pull-down with an external 1 K Ohm.
Default value is 1, (all boot strap pins have internal pull up resistor).
Note 1:
If the MDS108AL is configured from EEPROM preset (L_A[6] pulled down at reset), it will try to load its configuration from the
EEPROM. If the EEPROM is blank or not preset, it will not boot up. The parallel port can be used to program the EEPROM at
any time.
Note 2:
During normal power-up, the MDS108 will run through an external SBRAM memory test to ensure that there are no memory
interface problems. If a problem is detected, the chip will stop functioning. To facilitate board debug in the event that a system
stops functioning, the MDS108AL can be put into a continuous SBRAM self test mode to allow an operator to determine if
there are stuck pins in the memory interface (using network analyzer).
Pin No(s).
Symbol
Name & Functions
Boot Strap Pins
206 (L_A[5])
Memory Size
1 - Memory size = 256 KB
0 - Memory size = 512 KB
1 - NO EEPROM Installed
0 - EEPROM Installed
1
11 - 100 Mbps
10 - 200 Mbps
01 - 300 Mbps
00 - 400 Mbps (0 - Pull down, 1 - Pull up)
1 - MII Mode for port 8
0 - Serial Mode for port 8
Link Polarity for serial interface
1 - Active Low
0 - Active High
Full/Half Duplex Polarity for serial interface
1 - Active Low
0 - Active High
Speed polarity for serial interface
1 - Active Low
0 - Active High
Use in cascade mode only
For Board/System Manufacturing Test
2
1 - Disable
0 - Enable
208 (L_A [6])
EEPROM
5, 4 (L_A [10:9])
XLINK Speed
151 (L_A[17])
Port 8 MII/Serial
150 (L_A[2])
Link Polarity
204 (L_A[3])
FDX Polarity
205 (L_A[4])
SPD100 Polarity
2 (L_A[8])
133 (TST[2])
Device ID
SBRAM Self Test
相關PDF資料 |
PDF描述 |
|---|---|
| MDS108A | Unmanaged 9-Port 10/100 Mbps Ethernet Switch |
| MDS148 | Analog IC |
| MDS149 | Analog IC |
| MDS158 | Analog IC |
| MDS212 | 12-Port 10/100Mbps Ethernet Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MDS10-IDW | 制造商:Leviton Manufacturing Co 功能描述: |
| MDS1100 | 制造商:Microsemi Corporation 功能描述:MDS1100 - Bulk 制造商:Microsemi Corporation 功能描述:RF POWER TRANSISTOR BIPOLAR/HBT |
| MDS-113 | 制造商:Power Dynamics Inc 功能描述: |
| MDS12 | 制造商:M.E.C. Relays 功能描述: 制造商:TE Connectivity 功能描述: |
| MDS12001 | 制造商:TE Connectivity 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。