- 您現在的位置：買賣IC網 > Datasheet目錄44 > MCZ34653EFR2 (Freescale Semiconductor)IC HOTSWAP CTRLR 1A NEG 8-SOIC Datasheet資料下載
參數資料
| 型號： | MCZ34653EFR2 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 11/24頁 |
| 文件大?。?/td> | 1649K |
| 描述： | IC HOTSWAP CTRLR 1A NEG 8-SOIC |
| 標準包裝： | 2,500 |
| 類型： | 熱交換開關 |
| 應用： | 通用 |
| 內部開關： | 是 |
| 電流限制： | 1A |
| 電源電壓： | 36 V ~ 80 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOICN |
| 包裝： | 帶卷 (TR) |
Analog Integrated Circuit Device Data
Freescale Semiconductor
11
34653
FUNCTIONAL DEVICE OPERATION
OPERATIONAL MODES
rchived by Freescale Semiconductor, Inc., 2008
Figure 7. Power MOSFET Turn-On and the Gradual
Increase in the Charging Current from 0 A to I
CHG
(2.0 ms in Example)
The I
CHG
current charges up the load capacitor relatively
slowly. When the load capacitor is fully charged, the Power
MOSFET reaches its full enhancement, which triggers the
current limit detection to change from I
CHG
to I
LIM
and the load
current to decrease (Point C in Figure 6
, page 10
). The
current spike at Point C in Figure 6
is better displayed in
Figure 8
. We can see that when the 淰
OUT
- V
IN
? 0.5 V, the
Power MOSFET fully turns on to reach its full enhancement,
charging the capacitor an additional 0.5 V with a higher
current value that quickly ramps down. This eliminates the
need for a current slew rate control because the hazard for a
voltage change is less than 0.5 V. The power good output
signals activate after a 20 ms delay (Point D in Figure 6
),
which in turn enables the load. The 34653 is now in normal
operation mode and the retry counter resets.
Figure 8. Full Power MOSFET Turn-On and Current
Spike Associated with It. End of Charging Process
NORMAL MODE
If one of the start-up conditions (list on page
10
) is violated
any time from the start of the Power MOSFET enhancement
process and thereafter during normal operation, the Power
MOSFET turns off and the power good output signals
deactivate, disabling the load, and a new timer cycle starts as
explained previously. The 34653 also monitors the load
current to prevent any overload or short circuit conditions
from happening to protect the load from damage.
LOAD CURRENT CONTROL
When in normal operation mode, the 34653 monitors the
load and provides two modes of current control as explained
in the paragraphs below.
Overcurrent Mode
The 34653 monitors the load for overcurrent conditions. If
the current going through the load becomes larger than the
overcurrent limit for longer than the overcurrent limit filter
timer of 100 約, the overcurrent signal is asserted and the
gate of the Power MOSFET is discharged to try to regulate
the current at the I
LIM
value (Point A in Figure 9
). The 34653
is in overcurrent mode for 3.0 ms. If after a 3.0 ms filter timer
the device is still in overcurrent mode, the device turns off the
Power MOSFET and deactivates the power good output
signals (Point B in Figure 9
). The 34653 then initiates another
start-up timer and goes back through the enhancement
process. If during the 3.0 ms timer the fault was cleared, then
the 34653 goes back to the normal operation mode and the
power good output signals stay activated as shown in
Figure 10
. This way the device overcomes temporary
overcurrent situations and at the same time protects the load
from a more severe overcurrent situation.
Short Circuit Mode
If the current going through the load becomes > 5.0 A, the
Power MOSFET is discharged very fast (in less than 10 約)
to try to regulate the current at the I
LIM
value, and the 34653
is in the overcurrent mode for 3.0 ms. Then it follows the
pattern outlined in the Overcurrent Mode paragraph above.
相關PDF資料 |
PDF描述 |
|---|---|
| MCZ34670EG | IC POE CURR MODE SW REG 20-SOIC |
| MIC184BM TR | IC SUPERVISOR LOCAL/REMOTE 8SOIC |
| MIC2086-MBQS TR | IC CTRLR HOW SWAP SGL 20-QSOP |
| MIC2225-4OYMT TR | IC REG DL BUCK/LINEAR 10TMLF |
| MIC2310-2ZTS TR | IC HOT SWAP CTLR 2CHAN 24TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCZ34670EG | 功能描述:熱插拔功率分布 POWER OVER ETHERNET RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MCZ34670EG/R2 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:IEEE 802.3af PD With Current Mode Switching Regulator |
| MCZ34670EGR2 | 功能描述:熱插拔功率分布 POWER OVER ETHERNET RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MCZ34701EW | 功能描述:開關變換器、穩壓器與控制器 1.5A Sw-Mode Power Supply w/Linear Reg RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| MCZ34701EWR2 | 功能描述:開關變換器、穩壓器與控制器 1.5A Sw-Mode Power Supply w/Linear Reg RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。