- 您現在的位置：買賣IC網 > PDF目錄3290 > MCP6002-I/SN (Microchip Technology)IC OPAMP 1.8V 1MHZ DUAL 8-SOIC PDF資料下載
參數資料
| 型號： | MCP6002-I/SN |
| 廠商： | Microchip Technology |
| 文件頁數： | 8/42頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP 1.8V 1MHZ DUAL 8-SOIC |
| 標準包裝： | 100 |
| 放大器類型： | 通用 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.6 V/µs |
| 增益帶寬積： | 1MHz |
| 電流 - 輸入偏壓： | 1pA |
| 電壓 - 輸入偏移： | 4500µV |
| 電流 - 電源： | 100µA |
| 電流 - 輸出 / 通道： | 23mA |
| 電壓 - 電源，單路/雙路(±)： | 1.8 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOICN |
| 包裝： | 管件 |
| 產品目錄頁面： | 678 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
MCP6001/1R/1U/2/4
DS21733J-page 16
2009 Microchip Technology Inc.
4.7.3
PEAK DETECTOR
The MCP6001/2/4 op amp has a high input impedance,
rail-to-rail input/output and low input bias current, which
makes
this
device
suitable
for
peak
detector
applications. Figure 4-9 shows a peak detector circuit
with clear and sample switches. The peak-detection
cycle uses a clock (CLK), as shown in Figure 4-9.
At the rising edge of CLK, Sample Switch closes to
begin sampling. The peak voltage stored on C1 is
sampled to C2 for a sample time defined by tSAMP. At
the end of the sample time (falling edge of Sample
Signal), Clear Signal goes high and closes the Clear
Switch. When the Clear Switch closes, C1 discharges
through R1 for a time defined by tCLEAR. At the end of
the clear time (falling edge of Clear Signal), op amp A
begins to store the peak value of VIN on C1 for a time
defined by tDETECT.
In order to define tSAMP and tCLEAR, it is necessary to
determine the capacitor charging and discharging
period. The capacitor charging time is limited by the
amplifier source current, while the discharging time (
τ)
is defined using R1 (τ = R1C1). tDETECT is the time that
the input signal is sampled on C1 and is dependent on
the input voltage change frequency.
The op amp output current limit, and the size of the
storage capacitors (both C1 and C2), could create
slewing limitations as the input voltage (VIN) increases.
Current through a capacitor is dependent on the size of
the capacitor and the rate of voltage change. From this
relationship, the rate of voltage change or the slew rate
can be determined. For example, with an op amp short
circuit current of ISC = 25 mA and a load capacitor of
C1 = 0.1 F, then:
EQUATION 4-1:
This voltage rate of change is less than the MCP6001/2/4
slew rate of 0.6 V/s. When the input voltage swings
below the voltage across C1, D1 becomes reverse-
biased. This opens the feedback loop and rails the
amplifier. When the input voltage increases, the amplifier
recovers at its slew rate. Based on the rate of voltage
change shown in the above equation, it takes an
extended period of time to charge a 0.1 F capacitor. The
capacitors need to be selected so that the circuit is not
limited by the amplifier slew rate. Therefore, the
capacitors should be less than 40 F and a stabilizing
resistor (RISO) needs to be properly selected. (Refer to
FIGURE 4-9:
Peak Detector with Clear and Sample CMOS Analog Switches.
dV
C1
dt
-------------
I
SC
C
1
--------
=
25mA
0.1
μF
---------------
=
dV
C1
dt
-------------
250mV
μs
=
I
SC
C
1
dV
C1
dt
-------------
=
VIN
MCP6002
VC1
MCP6002
D1
Op Amp A
Op Amp B
VOUT
MCP6001
Op Amp C
C2
Sample Signal
Clear Signal
Clear
RISO
Sample
–
+
–
+
–
+
CLK
tSAMP
tCLEAR
tDETECT
Switch
1/2
R1
RISO VC2
C1
相關PDF資料 |
PDF描述 |
|---|---|
| 0459848162 | CONN RCPT R/A 8PWR 32SGL 2.36MM |
| 1-188275-4 | CONN FMALE-ON-BRD 14POS VERT SMD |
| 0459848161 | CONN RCPT R/A 8PWR 32SGL 3.18MM |
| MCP6002-I/MS | IC OPAMP 1.8V 1MHZ DUAL 8-MSOP |
| 0459841443 | CONN RCPT R/A 10PWR 24SGL 1.57MM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP6002IST | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:1 MHz Bandwidth Low Power Op Amp |
| MCP6002T-E/LT | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:1 MHz, Low-Power Op Amp |
| MCP6002T-E/MC | 功能描述:運算放大器 - 運放 Dual 1.8V 1MHz OP, E temp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MCP6002T-E/MS | 功能描述:運算放大器 - 運放 Dual 1.8V 1MHz RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MCP6002T-E/OT | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:1 MHz, Low-Power Op Amp |
發布緊急采購，3分鐘左右您將得到回復。