Chapter 26 4 Kbyte EEPROM Module (S12XEETX4KV2)
MC9S12XDP512 Data Sheet, Rev. 2.17
Freescale Semiconductor
1103
26.4.3
Illegal EEPROM Operations
The ACCERR ag will be set during the command write sequence if any of the following illegal steps are
performed, causing the command write sequence to immediately abort:
1. Writing to an EEPROM address before initializing the ECLKDIV register.
2. Writing a byte or misaligned word to a valid EEPROM address.
3. Starting a command write sequence while a sector erase abort operation is active.
4. Writing to any EEPROM register other than ECMD after writing to an EEPROM address.
5. Writing a second command to the ECMD register in the same command write sequence.
6. Writing an invalid command to the ECMD register.
7. Writing to an EEPROM address after writing to the ECMD register.
8. Writing to any EEPROM register other than ESTAT (to clear CBEIF) after writing to the ECMD
register.
9. Writing a 0 to the CBEIF ag in the ESTAT register to abort a command write sequence.
The ACCERR ag will not be set if any EEPROM register is read during a valid command write sequence.
The ACCERR ag will also be set if any of the following events occur:
1. Launching the sector erase abort command while a sector erase or sector modify operation is active
which results in the early termination of the sector erase or sector modify operation (see
2. The MCU enters stop mode and a command operation is in progress. The operation is aborted
If the EEPROM memory is read during execution of an algorithm (CCIF = 0), the read operation will
return invalid data and the ACCERR ag will not be set.
If the ACCERR ag is set in the ESTAT register, the user must clear the ACCERR ag before starting
The PVIOL ag will be set after the command is written to the ECMD register during a command write
sequence if any of the following illegal operations are attempted, causing the command write sequence to
immediately abort:
1. Writing the program command if the address written in the command write sequence was in a
protected area of the EEPROM memory.
2. Writing the sector erase command if the address written in the command write sequence was in a
protected area of the EEPROM memory.
3. Writing the mass erase command to the EEPROM memory while any EEPROM protection is
enabled.
4. Writing the sector modify command if the address written in the command write sequence was in
a protected area of the EEPROM memory.
If the PVIOL ag is set in the ESTAT register, the user must clear the PVIOL ag before starting another