- 您現在的位置：買賣IC網 > PDF目錄45222 > MC68HC05P18MDW (MOTOROLA INC) 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO28 PDF資料下載
參數資料
| 型號： | MC68HC05P18MDW |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO28 |
| 封裝： | SOIC-28 |
| 文件頁數： | 116/144頁 |
| 文件大?。?/td> | 1348K |
| 代理商： | MC68HC05P18MDW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁當前第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁
EEPROM
EEPROM Programming Register
MC68HC(8)05P18 — Rev. 2.0
Advance Information
MOTOROLA
EEPROM
73
In byte erase mode, only the selected byte is erased. In block mode,
a 32-byte block of EEPROM is erased. The EEPROM memory space
is divided into four 32-byte blocks ($140–$15F, $160–$17F,
$180–$19F and $1A0–$1BF) and doing a block erase to any address
within a block will erase the entire block. In bulk erase mode, the
entire 128-byte EEPROM section is erased.
LATCH — Latch Bit
When set, LATCH configures the EEPROM address and data bus for
programming. Writes to the EEPROM array cause the data bus and
the address bus to be latched. This bit is readable and writable, but
reads from the array are inhibited if the LATCH bit is set and a write
to the EEPROM space has taken place.
When clear, address and data buses are configured for normal
operation. Reset clears this bit.
EERC — EEPROM RC Oscillator Control Bit
When this bit is set, the EEPROM section uses the internal RC
oscillator instead of the CPU clock. The RC oscillator is shared with
the A/D converter, so this bit should be set by the user when the
internal bus frequency is below 1.5 MHz to guarantee reliable
operation of the EEPROM or A/D converter. After setting the EERC
bit, delay a time, tRCON, to allow the RC oscillator to stabilize. This bit
is readable and writable. The EERC bit is cleared by reset. The RC
oscillator is disabled while the MCU is in stop mode.
EEPGM — EEPROM Programming Power Enable Bit
EEPGM must be written to enable (or disable) the EEPGM function.
When set, EEPGM turns on the charge pump and enables the
programming (or erasing) power to the EEPROM array. When clear,
this power is switched off. This will enable pulsing of the programming
voltage to be controlled internally. This bit can be read at any time, but
can only be written to if LATCH = 1. If LATCH is not set, then EEPGM
cannot be set. LATCH and EEPGM cannot both be set with one write
if LATCH is cleared. EEPGM is cleared automatically when LATCH is
cleared. Reset clears this bit.
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC05P1AP | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP28 |
| MC68HCL05P1ADW | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO28 |
| MC68HC05P2CFN | 8-BIT, MROM, MICROCONTROLLER, PQCC32 |
| MC68HC05P2FN | 8-BIT, MROM, MICROCONTROLLER, PQCC32 |
| MC68HC05P3DWR3 | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC05P1A | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification |
| MC68HC05P1ADW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification |
| MC68HC05P1AP | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification |
| MC68HC05P1CDW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS Microcontroller Unit |
| MC68HC05P1CP | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS Microcontroller Unit |
發布緊急采購，3分鐘左右您將得到回復。