- 您現在的位置：買賣IC網 > PDF目錄359134 > MC34701EK (飛思卡爾半導體(中國)有限公司) 1.5 A Switch-Mode Power Supply with Linear Regulator PDF資料下載
參數資料
| 型號： | MC34701EK |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | 1.5 A Switch-Mode Power Supply with Linear Regulator |
| 中文描述： | 1.5開關模式電源，線性穩壓器 |
| 文件頁數： | 25/38頁 |
| 文件大小： | 739K |
| 代理商： | MC34701EK |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
Analog Integrated Circuit Device Data
Freescale Semiconductor
25
34701
FUNCTIONAL DESCRIPTION
FUNCTIONAL DEVICE OPERATION
INVERTED OPERATING MODE
Single 3.3 V Supply, VIN = VIN1 = VIN2 = 3.3 V
The 3.3 V supplies the microprocessor I/O voltage, the
LDO supplies core voltage (e.g., 1.5 V nominal), and the
switcher VOUT operates independently. Power sequencing
depends only on the normal LDO intrinsic operation to control
the Pass MOSFET.
Power-Up
When VIN is rising, initially LDO is below the regulation
point and the Pass MOSFET is on. In order not to exceed the
2.1 V differential requirement between the I/O (VIN) and the
core (LDO), the LDO must start up at 2.1 V or less and be
able to maintain the 2.1 V or less differential. The maximum
slew rate for V
IN
is 1.0 V/ms.
Power-Down
When VIN is falling, LDO falls below the regulation point;
therefore, the Pass MOSFET is on. In the case where LDO is
falling faster than VIN, the Pass MOSFET attempts to
maintain LDO. In the case where VIN is falling faster than
LDO, the Pass MOSFET is also on, and the LDO load
capacitor is discharged through the Pass MOSFET to VIN.
Thus, provided VIN does not fall too fast, the core voltage
(LDO) does not exceed the I/O voltage (VIN) by more than
maximum of 0.4 V.
Shorted Load
1.
LDO shorted to ground.
This will cause the I/O voltage
to exceed the core voltage by more than 2.1 V. No load
protection.
2.
VIN shorted to ground.
Until the LDO load capacitance
is discharged, the core voltage exceeds the I/O voltage
by more than 0.4 V. By the intrinsic operation of the
LDO, the load capacitor is discharged rapidly through
the Pass MOSFET to VIN.
3.
LDO shorted to supply.
No load protection.
Single 5.0 V Supply, VIN1 = VIN2, or Dual Supply VIN1
≠
VIN2
The switcher VOUT supplies the microprocessor I/O
voltage. The LDO supplies the core (e.g., 1.5 V nominal) (see
Figure 19
, page
22
).
Power-Up
This condition depends upon the regulator current limit,
load current and capacitance, and the relative rise times of
the VIN1 and VIN2 supplies. There are two cases:
1.
VOUT rises faster than LDO.
The switcher VOUT uses
control methods (1) and (2) described in the section
Methods of Control on page 22
.
2.
LDO rises faster than VOUT.
The LDO uses control
methods (5) and (6) described in the section
Methods
of Control on page 22
.
Power-Down
This condition depends upon the regulator load current
and capacitance and the relative fall times of the VIN1 and
VIN2 supplies. There are two cases:
1.
LDO falls faster than VOUT .
The VOUT uses control
methods (4) and (5) described in the section
Methods
of Control on page 22
.
In the case VIN1 = VIN2, the intrinsic operation turns
on both the Buck High-Side MOSFET and the LDO
external Pass MOSFET, and discharges the VOUT
load capacitor into the VIN supply.
2.
VOUT falls faster than LDO.
The LDO uses control
methods (
5
) and (
6
) described in the section
Methods
of Control on page 22
.
Shorted Load
1.
LDO shorted to ground.
The VOUT uses methods (1)
and (2) described in the section
Methods of Control on
page 22
.
2.
VOUT shorted to ground.
The LDO uses control
methods (5) and (6) described in the section
Methods
of Control on page 22
.
3. VIN1 shorted to ground. Device is not working.
4.
VIN2 shorted to ground.
This is equivalent to the
switcher V
OUT
output shorted to ground.
5.
LDO shorted to supply.
No load protection. 34701 is
protected by current limit and Thermal Shutdown.
6.
VOUT shorted to supply.
No load protection. 34701 is
protected by current limit and Thermal Shutdown.
相關PDF資料 |
PDF描述 |
|---|---|
| MC34701R2 | 1.5 A Switch-Mode Power Supply with Linear Regulator |
| MC34920 | 2.8 Ohm(Typ) Quad H-Bridge Motor Driver(2.8歐（典型值）四H橋電機驅動器) |
| MC34923 | Full-Bridge PWM Motor Driver(全橋PWM電機驅動器) |
| MC34982PNA | Single Intelligent High-Current Self-Protected Silicon High-Side Switch (2.0 mOhm)(單智能大電流帶自保護功能的硅高端開關（2mOhm）) |
| MC35004 | GENERAL PURPOSE QUAD J FET OPERATIONAL AMPLIFIERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC34701EKR2 | 功能描述:開關變換器、穩壓器與控制器 QUICCSUPPLY1 RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| MC34702EK | 功能描述:開關變換器、穩壓器與控制器 QUICCSUPPLY2 RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| MC34702EKR2 | 功能描述:開關變換器、穩壓器與控制器 QUICCSUPPLY2 RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| MC34703 | 制造商:SPC Multicomp 功能描述:HEADER R/ANGLE 7WAY 制造商:SPC Multicomp 功能描述:HEADER, R/ANGLE, 7WAY |
| MC34703PNB | 功能描述:開關變換器、穩壓器與控制器 QUICC SUPPLY 3 RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。