- 您現在的位置：買賣IC網 > PDF目錄369895 > MC13155 (Motorola, Inc.) Wideband FM IF Detector(寬頻帶FM IF探測器) PDF資料下載
參數資料
| 型號： | MC13155 |
| 廠商： | Motorola, Inc. |
| 英文描述： | Wideband FM IF Detector(寬頻帶FM IF探測器) |
| 中文描述： | 寬帶調頻中頻中頻探測器探測（寬頻帶調頻） |
| 文件頁數： | 11/16頁 |
| 文件大小： | 267K |
| 代理商： | MC13155 |
MC13155
11
MOTOROLA ANALOG IC DEVICE DATA
Quadrature Detector
The quadrature detector is coupled to the IF with internal
2.0 pF capacitors between Pins 7 and 8 and Pins 9 and 10.
For wideband data applications, such as FM video and
satellite receivers, the drive to the detector can be increased
with additional external capacitors between these pins, thus,
the recovered video signal level output is increased for a
given bandwidth (see Figure 11A and Figure 11B).
The wideband performance of the detector is controlled by
the loaded Q of the LC tank circuit. The following equation
defines the components which set the detector circuit’s
bandwidth:
Q = RT/XL
(1)
where: RT is the equivalent shunt resistance across the LC
Tank and XL is the reactance of the quadrature inductor at the
IF frequency (XL = 2
π
fL).
The inductor and capacitor are chosen to form a resonant
LC Tank with the PCB and parasitic device capacitance at the
desired IF center frequency as predicted by:
fc = (2
π
√
(LCp)) –1
(2)
where: L is the parallel tank inductor and Cp is the equivalent
parallel capacitance of the parallel resonant tank circuit.
The following is a design example for a wideband detector
at 70 MHz and a loaded Q of 5. The loaded Q of the
quadrature detector is chosen somewhat less than the Q of
the IF bandpass. For an IF frequency of 70 MHz and an
IF bandpass of 10.9 MHz, the IF bandpass Q is
approximately 6.4.
Example:
Let the external Cext = 20 pF. (The minimum value here
should be greater than 15 pF making it greater than the
internal device and PCB parasitic capacitance, Cint
≈
3.0 pF).
Cp = Cint + Cext = 23 pF
Rewrite Equation 2 and solve for L:
L = (0.159)2 /(Cp fc2)
L = 198 nH, thus, a standard value is chosen.
L = 0.22
μ
H (tunable shielded inductor).
The value of the total damping resistor to obtain the
required loaded Q of 5 can be calculated by rearranging
Equation 1:
RT = Q(2
π
fL)
RT = 5 (2
π
)(70)(0.22) = 483.8
.
The internal resistance, Rint between the quadrature tank
Pins 8 and 9 is approximately 3200
and is considered in
determining the external resistance, Rext which is calculated
from:
Rext = ((RT)(Rint))/ (Rint – RT)
Rext = 570, thus, choose the standard value.
Rext = 560
.
SAW Filter
In wideband video data applications, the IF occupied
bandwidth may be several MHz wide. A good rule of thumb is
to choose the IF frequency about 10 or more times greater
than the IF occupied bandwidth. The IF bandpass filter is a
SAW filter in video data applications where a very selective
response is needed (i.e., very sharp bandpass response).
The evaluation PCB is laid out to accommodate two SAW
filter package types: 1) A five–leaded plastic SIP package.
Recommended part numbers are Siemens X6950M which
operates at 70 MHz; 10.4 MHz 3 dB passband, X6951M
(X252.8) which operates at 70 MHz; 9.2 MHz 3 dB passband;
and X6958M which operates at 70 MHz, 6.3 MHz 3 dB
passband, and 2) A four–leaded TO–39 metal can package.
Typical insertion loss in a wide bandpass SAW filter is 25 dB.
The above SAW filters require source and load
impedances of 50
to assure stable operation. On the PC
board layout, space is provided to add a matching network,
such as a 1:4 surface mount transformer between the SAW
filter output and the input to the MC13155. A 1:4 transformer,
made by Coilcraft and Mini Circuits, provides a suitable
interface (see Figures 16, 17 and 18). In the circuit and
layout, the SAW filter and the MC13155 are differentially
configured with interconnect traces which are equal in length
and symmetrical. This balanced feed enhances RF stability,
phase linearity, and noise performance.
相關PDF資料 |
PDF描述 |
|---|---|
| MC13155D | WIDEBAND FM IF |
| MC13156 | Wideband FM IF System |
| MC13158 | WIDEBAND FM IF SUBSYSTEM FOR DECT AND DIGITAL APPLICATIONS |
| MC13181 | Wireless Power Management Integrated Circuit |
| MC13181R2 | Wireless Power Management Integrated Circuit |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC13155D | 制造商:LANSDALE 制造商全稱:LANSDALE Semiconductor Inc. 功能描述:Wideband FM IF |
| MC13156 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Wideband FM IF System |
| MC13156DW | 制造商:Motorola Inc 功能描述: |
| MC13156FB | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:WIDEBAND FM IF SYSTEM FOR DIGITAL AND ANALOG APPLICATIONS |
| MC13158 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:WIDEBAND FM IF SUBSYSTEM FOR DECT AND DIGITAL APPLICATIONS |
發布緊急采購，3分鐘左右您將得到回復。