參數資料
型號: MBM29F800TA-90PFTR
廠商: FUJITSU LTD
元件分類: DRAM
英文描述: 0.345A, 2.7-5.5V Single Hi-Side MOSFET, Fault Report, Act-Low Enable 8-SOIC 0 to 85
中文描述: 512K X 16 FLASH 5V PROM, 90 ns, PDSO48
封裝: PLASTIC, REVERSE, TSOP1-48
文件頁數: 12/48頁
文件大?。?/td> 537K
代理商: MBM29F800TA-90PFTR
12
MBM29F800TA
-55/-70/-90
/MBM29F800BA
-55/-70/-90
To activate this mode, the programming equipment must force V
ID
on address pin A
9
and control pin OE, (suggest
V
ID
= 11.5V), CE = V
IL
, and A
6
= V
IL
. The sector addresses (A
18
, A
17
, A
16
, A
15
, A
14
, A
13
, and A
12
) should be set to
the sector to be protected. Tables 5 and 6 define the sector address for each of the nineteen (19) individual
sectors. Programming of the protection circuitry begins on the falling edge of the WE pulse and is terminated
with the rising edge of the same. Sector addresses must be held constant during the WE pulse. See Figures 16
and 23 for sector protection waveforms and algorithm.
To verify programming of the protection circuitry, the programming equipment must force V
ID
on address pin A
9
with CE and OE at V
IL
and WE at V
IH
. Scanning the sector addresses (A
18
, A
17
, A
16
, A
15
, A
14
, A
13
, and A
12
) while
(A
6
, A
1
, A
0
) = (0, 1, 0) will produce a logical “1” code at device output DQ
0
for a protected sector. Otherwise the
devices will read 00H for unprotected sector. In this mode, the lower order addresses, except for A
0
, A
1
, and A
6
are DON’T CARES. Address locations with A
1
= V
IL
are reserved for Autoselect manufacturer and device codes.
A
-1
requires to apply to V
IL
on byte mode.
It is also possible to determine if a sector is protected in the system by writing an Autoselect command. Performing
a read operation at the address location XX02H, where the higher order addresses (A
18
, A
17
, A
16
, A
15
, A
14
, A
13
,
and A
12
) are the desired sector address will produce a logical “1” at DQ
0
for a protected sector. See Tables 4.1
and 4.2 for Autoselect codes.
Temporary Sector Unprotection
This feature allows temporary unprotection of previously protected sectors of the MBM29F800TA/BA device in
order to change data. The Sector Unprotection mode is activated by setting the RESET pin to high voltage (12
V). During this mode, formerly protected sectors can be programmed or erased by selecting the sector addresses.
Once the 12 V is taken away from the RESET pin, all the previously protected sectors will be protected again.
Refer to Figures 17 and 24.
相關PDF資料
PDF描述
MBM29F800BA-55 LED Lamp; Bulb Size:T-1; LED Color:Red; Luminous Intensity:12ucd; Viewing Angle:50 ; Forward Current:20mA; Forward Voltage:2V; Operating Temperature Range:-40 C to +85 C; Color:Red; Leaded Process Compatible:Yes; Lens Color:Clear RoHS Compliant: Yes
MBM29F800BA-55PF LED Lamp; Bulb Size:T-1; LED Color:Yellow; Luminous Intensity:45ucd; Viewing Angle:50 ; Forward Current:20mA; Forward Voltage:2.1V; Operating Temperature Range:-40 C to C; Color:Yellow; Leaded Process Compatible:Yes RoHS Compliant: Yes
MBM29F800BA-55PFTN LED Lamp; Bulb Size:T-1; LED Color:Red; Luminous Intensity:3ucd; Viewing Angle:60 ; Forward Current:20mA; Forward Voltage:2V; Operating Temperature Range:-40 C to +85 C; Color:Red; Leaded Process Compatible:Yes; Lens Color:Red RoHS Compliant: Yes
MBM29F800BA-55PFTR LED Lamp; Bulb Size:T-1; LED Color:Yellow; Luminous Intensity:20ucd; Viewing Angle:60 ; Forward Current:20mA; Forward Voltage:2.1V; Operating Temperature Range:-40 C to +85 C; Color:Yellow; Leaded Process Compatible:Yes RoHS Compliant: Yes
MBM29F800TA-70 8M (1M X 8/512K X 16) BIT
相關代理商/技術參數
參數描述
MBM29FS12DH15PBT 制造商:SPANSION 制造商全稱:SPANSION 功能描述:BURST MODE FLASH MEMORY CMOS 128M (8M X 16) BIT
MBM29LV001BC 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:1M (128K x 8) BIT
MBM29LV001BC-55 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:1M (128K x 8) BIT
MBM29LV001BC-55PD 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:1M (128K x 8) BIT
MBM29LV001BC-55PFTN 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:1M (128K x 8) BIT