- 您現在的位置：買賣IC網 > PDF目錄69022 > MB91F610APMC (FUJITSU LTD) 32-BIT, FLASH, 33 MHz, RISC MICROCONTROLLER, PQFP120 PDF資料下載
參數資料
| 型號： | MB91F610APMC |
| 廠商： | FUJITSU LTD |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 33 MHz, RISC MICROCONTROLLER, PQFP120 |
| 封裝： | 16 X 16 MM, 1.70 MM HEIGHT, 0.50 MM PITCH, PLASTIC, LQFP-120 |
| 文件頁數： | 2/53頁 |
| 文件大小： | 2625K |
| 代理商： | MB91F610APMC |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁
MB89202 Series
10
DS07-12561-2E
■ HANDLING DEVICES
Preventing Latch-up
Latch-up may occur on CMOS ICs if voltage higher than VCC or lower than VSS is applied to input and output pins
other than medium- and high-voltage pins or if higher than the voltage which shows on “1. Absolute Maximum
Ratings” in section “
■ ELECTRICAL CHARACTERISTICS” is applied between VCC and VSS.
When latch-up occurs, power supply current increases rapidly and might thermally damage elements. When
using, take great care not to exceed the absolute maximum ratings.
Treatment of Unused Input Pins
Leaving unused input terminals open may lead to permanent damage due to malfunction and latch-up; pull up
or pull down the terminals through the resistors of 2 k
or more.
Make the unused I/O terminal in a state of output and leave it open or if it is in an input state, handle it with the
same procedure as the input terminals.
Treatment of NC Pins
Be sure to leave (internally connected) NC pins open.
Power Supply Voltage Fluctuations
Although VCC power supply voltage is assured to operate within the rated range, a rapid fluctuation of the voltage
could cause malfunctions, even if it occurs within the rated range. Stabilizing voltage supplied to the IC is therefore
important. As stabilization guidelines, it is recommended to control power so that VCC ripple fluctuations (P-P
value) will be less than 10
% of the standard VCC value at the commercial frequency (50 Hz/60 Hz) and the
transient fluctuation rate will be less than 0.1 V/ms at the time of a momentary fluctuation such as when power
is switched.
Precautions when Using an External Clock
When an external clock is used, oscillation stabilization time is required even for power-on reset (optional) and
wake-up from stop mode.
About the Wild Register Function
No wild register can be debugged on the MB89V201. For the operation check, test the MB89F202/F202Y installed
on a target system.
Program Execution in RAM
When the MB89V201 is used, no program can be executed in RAM.
Note to Noise in the External Reset Pin (RST)
If the reset pulse applied to the external reset pin (RST) does not meet the specifications, it may cause malfunc-
tions. Use caution so that the reset pulse less than the specifications will not be fed to the external reset pin (RST).
External pull-up for the External Reset Pin (RST) of MB89F202
Internal pull-up control for RST pin is not available for MB89F202/F202Y. To ensure proper external reset control
in MB89F202/F202Y, an external pull-up (recommend 100 k
) for RST pin must be required.
Notes on selecting mask option
Please select “With reset output” by the mask option when power-on reset is generated at the power supply ON,
and the device is used without inputting external reset.
相關PDF資料 |
PDF描述 |
|---|---|
| MB91F647ABGL | 32-BIT, FLASH, 60 MHz, RISC MICROCONTROLLER, PBGA176 |
| MB91F647APMC | 32-BIT, FLASH, 60 MHz, RISC MICROCONTROLLER, PQFP176 |
| MB91F668PMC | 32-BIT, FLASH, 33 MHz, RISC MICROCONTROLLER, PQFP48 |
| MB91F669PMC | 32-BIT, FLASH, 33 MHz, RISC MICROCONTROLLER, PQFP64 |
| MB91FV130CR-ES | 32-BIT, FLASH, 33 MHz, RISC MICROCONTROLLER, CPGA299 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB91F613 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Microcontrollers |
| MB91F627 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Microcontrollers |
| MB91F627PMC | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:32-bit Microcontrollers |
| MB91F662PMC-GE1 | 功能描述:IC MCU 512KB FLASH FR80 120-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:FR MB91660 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND |
| MB91F668PMC-G-JNE1 | 制造商:FUJITSU 功能描述: 制造商:FUJITSU 功能描述:MCU 32BIT FR80 128K FLASH 48LQFP |
發布緊急采購，3分鐘左右您將得到回復。