- 您現在的位置：買賣IC網 > PDF目錄3763 > MAX3111ECNI+G36 (Maxim Integrated Products)IC UART SPI COMPAT 28-DIP PDF資料下載
參數資料
| 型號： | MAX3111ECNI+G36 |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 20/31頁 |
| 文件大小： | 0K |
| 描述： | IC UART SPI COMPAT 28-DIP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 14 |
| 特點： | 收發器 |
| 通道數： | 1，UART |
| 規程： | RS232，RS485 |
| 電源電壓： | 3 V ~ 3.6 V |
| 帶IrDA 編碼器/解碼器： | 是 |
| 帶故障啟動位檢測功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 28-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 28-PDIP |
| 包裝： | 管件 |
| 產品目錄頁面： | 1404 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
SPI/MICROWIRE-Compatible UART and ±15kV ESD-
Protected RS-232 Transceivers with Internal Capacitors
In 9-bit mode, the MAX3110E/MAX3111E is set up with
eight bits plus parity. The parity bit in all normal mes-
sages is clear but is set in an address-type message.
The MAX3110E/MAX3111E’s parity-interrupt mask gen-
erates an interrupt on high parity when enabled. When
the master sends an address message with the parity
bit set, all MAX3110E/MAX3111E nodes issue an inter-
rupt. All nodes then retrieve the received byte to com-
pare to their assigned address. Once addressed, the
node continues to process each received byte. If the
node was not addressed, it ignores all message traffic
until a new address is sent out by the master.
The parity/9th-bit interrupt is controlled only by the data
in the receive register and is not affected by data in the
FIFO, so the most effective use of the parity/9th-bit
interrupt is with FIFO disabled. With the FIFO disabled,
received non-address words can be ignored and not
even read from the UART. For more detailed informa-
tion on 9-bit mode, refer to the MAX3100 data sheet.
SIR IrDA Mode
The MAX3110E/MAX3111E’s IrDA mode can be used
to communicate with other IrDA SIR-compatible
devices or to reduce power consumption in opto-isolat-
ed applications.
In IrDA mode, a bit period is shortened to 3/16 of a
baud period (1.61s at 115,200 baud). A data zero is
transmitted as a pulse of light (TX pin = logic low, RX
pin = logic high), as shown in Figure 15.
In receive mode, the RX signal’s sampling is done
halfway into the transmission of a high level. The sam-
pling is done once (instead of three times, as in normal
mode). The MAX3110E/MAX3111E ignore pulses short-
er than approximately 1/16 of the baud period. The
IrDA device that is communicating with the MAX3110E/
MAX3111E must be set to transmit pulses at 3/16 of the
baud period. For compatibility with other IrDA devices,
set the format to 8-bit data, one stop, no parity. For
more detailed information on SIR IrDA mode, refer to
the MAX3100 data sheet.
Layout and Power-Supply
_____________________Considerations
The MAX3110E/MAX3111E require basic layout tech-
niques and fundamental power supply considerations.
The minimum requirements include: (1) placing a 1F
ceramic bypass capacitor as close as possible to VCC,
preferably right next to the VCC lead or on the opposite
side of the PCB directly below the VCC lead; (2) using
an internal ground plane within the PCB, returning all
circuit grounds to this ground plane, or using a ‘star’
ground technique where all circuit grounds are
returned to a common ground point at the ‘GND’ lead
of the IC; (3) ensuring that the power source to the IC
has a low inductive path and is high-frequency
bypassed to absorb ESD events with significant
changes in the supply voltage.
START
STOP
START
STOP
NORMAL
RX
UART FRAME
DATA BITS
01
1
00
0
NORMAL UART
TX
11
1
00
0
IrDA
RX
IrDA
TX
Figure 15. IrDA Timing
Maxim Integrated
27
MAX3110E/MAX3111E
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3110ECNI+G36 | IC TXRX RS232 SPI W/CAP 28-DIP |
| ATMEGA164PA-MCHR | MCU AVR 16KB FLASH 20MHZ 44-VQFN |
| SC16C654BIBS,551 | IC UART QUAD W/FIFO 48-HVQFN |
| SC16C654BIBS,528 | IC QUAD UART 64BYTE 48HVQFN |
| SCC2681AC1N40,112 | IC UART DUAL 40-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX3111ECW1+G36 | 制造商:IC'S/TRANSISTORS/DIO 功能描述: 制造商:IC'S/TRANSISTORS/DIODES 功能描述: |
| MAX3111ECWI | 功能描述:UART 接口集成電路 RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| MAX3111ECWI+ | 制造商:Maxim Integrated Products 功能描述:LINE TRNSCVR 2TR 2TX 2RX 28SOIC W - Rail/Tube |
| MAX3111ECWI+G36 | 功能描述:UART 接口集成電路 5V SPI/uWire Compatible RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| MAX3111ECWI+T | 功能描述:UART 接口集成電路 RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。