- 您現在的位置：買賣IC網 > Datasheet目錄55 > MAX2369EGM+TD (Maxim Integrated)IC TRANSMITTER QUAD 48QFN-EP Datasheet資料下載
參數資料
| 型號： | MAX2369EGM+TD |
| 廠商： | Maxim Integrated |
| 文件頁數： | 13/16頁 |
| 文件大?。?/td> | 229K |
| 描述： | IC TRANSMITTER QUAD 48QFN-EP |
| 標準包裝： | 2,500 |
| 頻率： | 120MHz ~ 235MHz |
| 應用： | 手機，GAIT 手持話機，LAN，PCS，TDMA，WAN，WLL |
| 功率 - 輸出： | 5.8dBm ~ 12dBm |
| 電流 - 傳輸： | 6.5mA ~ 155mA |
| 數據接口： | PCB，表面貼裝 |
| 天線連接器： | PCB，表面貼裝 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 48-QFN 裸露焊盤 |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁
Complete Dual-Band
Quadrature Transmitter
______________________________________________________________________________________ 13
BIT NAME
FUNCTION
IF_PLL_SHDN
1
0 shuts down the IF PLL. This mode is used with an external IF VCO and IF PLL.
UNUSED
1
Set to 0 for normal operation.
UNUSED
0
Set to 0 for normal operation.
ICP
00
A 2-bit register sets the IF charge-pump current as follows:
00 = 200礎
01 = 260礎
10 = 400礎
11 = 530礎
VCO_BYPASS
0
1 bypasses IF VCO and enables a buffered input for external VCO use.
BUF_DIV
0
1 selects ? on IFLO port; 0 bypasses the divider.
IQ_LEVEL
1
1 selects 200mV
RMS
input mode; 0 selects 100mV
RMS
input mode.
UNUSED
00
Not used. Leave in the power-up/initialized state.
15
14
13
9, 8
10
11
12
7, 6
IF_PD_POL
1
5
IF phase-detector polarity; 1 selects positive polarity (increasing tuning voltage
on the VCO produces increasing frequency); 0 selects negative polarity
(increasing tuning voltage on the VCO produces decreasing frequency).
UNUSED
111
4, 3 ,2
Not used. Leave in the power-up/initialized state.
LD_MODE
1
0
Determines output mode for LOCK detector pin as follows:
0 = test mode, LD_MODE cannot be 0 for normal operation
1 = IF PLL lock detector
POWER-UP
STATE
BIT
LOCATION
(0 = LSB)
Table 4. Configuration Register (CONFIG)
Electromagnetic
Compliance Considerations
Two major concepts should be employed to produce a
noise-free and EMC-compliant transmitter: minimize cir-
cular current-loop area to reduce H-field radiation and
minimize voltage drops to reduce E-field radiation. To
minimize the circular current-loop area, bypass as
close to the part as possible and use the distributed
capacitance of a ground plane. To minimize voltage
drops, make V
CC
traces short and wide, and make RF
traces short.
The don't care bits in the registers should be zero in
order to minimize electromagnetic radiation due to
unnecessary bit banging. RC filtering can also be used
to slow the clock edges on the 3-wire interface, reduc-
ing high-frequency spectral content. RC filtering also
provides for transient protection against IEC802 testing
by shunting high frequencies to ground, while the
series resistance attenuates the transients for error-free
operation. The same applies to the override pins
(SHDN, TXGATE).
When floating the override pins, bypass to ground with
the capacitors as close to the part as possible.
High-frequency bypass capacitors are required close
to the pins with a dedicated via to ground. The 48-pin
QFN-EP package provides minimal inductance ground
by using an exposed paddle under the part. Provide at
least five low-inductance vias under the paddle to
ground to minimize ground inductance. Use a solid
ground plane wherever possible. Any cutout in the
ground plane may act as slot radiator and reduce its
shield effectiveness.
Keep the RF LO traces as short as possible to reduce
LO radiation and susceptibility to interference.
UNUSED
1
1
Set to 0 for normal operation.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX2850ITK+ | TRANSMITTER MIMO 5GHZ 4CH 68TQFN |
| MAX7057ASE+T | IC TRANSMITTER ASK/FSK 16-SOIC |
| MBA-2060 | ANTENNA METROLOGY BICONICAL |
| MC33493ADTBER2 | IC RF TRANSMITTER UHF 14-TSSOP |
| MDEV-916-ES | KIT MASTER DEVELOP 916MHZ ES SRS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX2369EGM-TDG069 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX236C/D | 功能描述:RS-232接口集成電路 +5V Pwrd 4 RS-232 Xmttrs and 3 RS-232 Rcvrs w/ Pwr Shtdwn & Rcvr RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX236C/D DIE | 制造商:Maxim Integrated Products 功能描述: |
| MAX236C/D+ | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX236CNG | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。