- 您現在的位置：買賣IC網 > PDF目錄45050 > M41T82RMY6F (STMICROELECTRONICS) 1 TIMER(S), REAL TIME CLOCK, PDSO18 PDF資料下載
參數資料
| 型號： | M41T82RMY6F |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 時鐘/數據恢復及定時提取 |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PDSO18 |
| 封裝： | 0.300 INCH, ROHS COMPLIANT, PLASTIC, SOP-18 |
| 文件頁數： | 37/58頁 |
| 文件大?。?/td> | 462K |
| 代理商： | M41T82RMY6F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁
Clock operation
M41T82 M41T83
3.13
Oscillator fail detection
If the Oscillator Fail (OF) bit is internally set to a '1,' this indicates that the oscillator has
either stopped, or was stopped for some period of time. This bit can be used to judge the
validity of the clock and date data. This bit will be set to '1' any time the oscillator stops.
In the event the OF bit is found to be set to '1' at any time other than the initial power-up, the
STOP bit (ST) should be written to a '1,' then immediately reset to '0.' This will restart the
oscillator. The following conditions can cause the OF bit to be set:
●
The first time power is applied (defaults to a '1' on power-up).
Note:
If the OF bit cannot be written to '1' 4 seconds after the initial power-up, the STOP bit (ST)
should be written to a '1,' then immediately reset to '0.'
●
The voltage present on VCC or battery is insufficient to support oscillation.
●
The ST bit is set to '1.'
●
External interference of the crystal
For the M41T83, if the Oscillator Fail Interrupt Enable bit (OFIE) is set to a '1,' the
IRQ1/FT/OUT pin will also be activated. The IRQ1/FT/OUT output is cleared by resetting the
OFIE or OF bit to '0' (NOT by reading the Flag Register).
The OF bit will remain set to '1' until written to logic '0.' The oscillator must start and have
run for at least 4 seconds before attempting to reset the OF bit to '0.' If the trigger event
occurs during a power down condition, this bit will be set correctly.
3.14
Oscillator fail interrupt enable (M41T83 only)
If the Oscillator Fail Interrupt Enable bit (OFIE) is set to a '1,' the IRQ1/FT/OUT pin will also
be activated. The IRQ1/FT/OUT output is cleared by resetting the OFIE or OF bit to '0' (not
by reading the Flags Register).
3.15
Initial power-on defaults
Upon initial application of power to the device, the register bits will initially power-on in the
Table 15.
Initial power-on default values (part 1)
Condition(1)
1.
All other control bits power-up in an undetermined state.
ST
CB1 CB0 OUT
FT
DCS
ACS
Digital
calib.
Analog
calib.
OFIE
(2)
2.
M41T83 only.
Watchdog
(3)
3.
BMB0-BMB4, RB0, RB1.
A1IE
SQWE
ABE
Initial
Power-up
00
0
1
0
1
0
Subsequent
Power-up(4) (5)
4.
With battery back-up.
5.
UC = unchanged.
UC
0
UC
0
UC
相關PDF資料 |
PDF描述 |
|---|---|
| M41T82SQA6F | 1 TIMER(S), REAL TIME CLOCK, QCC16 |
| M41T83RM6F | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
| M41T83ZM6E | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
| M41T83ZQA6E | 1 TIMER(S), REAL TIME CLOCK, QCC16 |
| M41T83RMY6E | 1 TIMER(S), REAL TIME CLOCK, PDSO18 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M41T82RQ6E | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial RTC with battery switchover |
| M41T82RQ6F | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial RTC with battery switchover |
| M41T82RQA6E | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial I2C bus RTC with battery switchover |
| M41T82RQA6F | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial I2C bus RTC with battery switchover |
| M41T82SM6E | 功能描述:實時時鐘 Serial I2C bus RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。