參數資料
型號： M41T00M6F
廠商： STMICROELECTRONICS
元件分類： 時鐘/數據恢復及定時提取
英文描述： REAL TIME CLOCK, PDSO8
封裝： 0.150 INCH, LEAD FREE, PLASTIC, SOIC-8
文件頁數： 6/25頁
文件大小： 202K
代理商： M41T00M6F
M41T00 clock operation
M41T00
3
M41T00 clock operation
The eight byte clock register (see Table 5) is used to both set the clock and to read the date
and time from the clock, in a binary coded decimal format. Seconds, minutes, and hours are
contained within the first three registers. Bits D6 and D7 of clock register 2 (century/hours
register) contain the century enable bit (CEB) and the century bit (CB). Setting CEB to a '1'
will cause CB to toggle, either from '0' to '1' or from '1' to '0' at the turn of the century
(depending upon its initial state). If CEB is set to a '0', CB will not toggle. Bits D0 through D2
of register 3 contain the day (day of week). Registers 4, 5 and 6 contain the date (day of
month), month and years. The final register is the control register (this is described in the
clock calibration section). Bit D7 of register 0 contains the STOP bit (ST). Setting this bit to a
'1' will cause the oscillator to stop. If the device is expected to spend a significant amount of
time on the shelf, the oscillator may be stopped to reduce current drain. When reset to a '0'
the oscillator restarts within one second.
Note:
In order to guarantee oscillator start-up after the initial power-up, set the ST bit to a '1,' then
reset this bit to a '0.' This sequence enables a “kick start” circuit which aids the oscillator
start-up during worst case conditions of voltage and temperature.
The seven clock registers may be read one byte at a time, or in a sequential block. The
control register (address location 7) may be accessed independently. Provision has been
made to ensure that a clock update does not occur while any of the seven clock addresses
are being read. If a clock address is being read, an update of the clock registers will be
delayed by 250 ms to allow the read to be completed before the update occurs. This will
prevent a transition of data during the read.
Note:
Note: This 250 ms delay affects only the clock register update and does not alter the actual
clock time.
相關PDF資料
PDF描述
M41T00M6E REAL TIME CLOCK, PDSO8
M41T00M6 0 TIMER(S), REAL TIME CLOCK, PDSO8
M41T0DS6 REAL TIME CLOCK, PDSO8
M41T0DS6T REAL TIME CLOCK, PDSO8
M41T0M6T 0 TIMER(S), REAL TIME CLOCK, PDSO8
相關代理商/技術參數
參數描述
M41T00M6F-CUT TAPE 制造商:ST 功能描述:M41T00 Series 2 - 5.5 V 32 kHz Serial I2C Real Time Clock - SOIC-8
M41T00S 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial access real-time clock
M41T00S_08 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial access real-time clock
M41T00SC64 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Real-Time Clock + 64Kbit (8192 x 8) EEPROM
M41T00SC64MY6E 功能描述:電可擦除可編程只讀存儲器 SERIAL REAL TIME CLOCK 64Kb 電可擦除可編程只讀存儲器 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*