參數資料
型號： M37905M4C-XXXFP
元件分類： 微控制器/微處理器
英文描述： 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64
封裝： 14 X 14 MM, 0.80 MM PITCH, PLASTIC, QFP-64
文件頁數： 27/102頁
文件大?。?/td> 881K
代理商： M37905M4C-XXXFP
30
M37905M4C-XXXFP, M37905M4C-XXXSP
M37905M6C-XXXFP, M37905M6C-XXXSP
M37905M8C-XXXFP, M37905M8C-XXXSP
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
16-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
When a phase-related pulse with a falling edge input to the TAkOUT
pin is input after the level of TAlIN pin changes from “H” to “L”, the
count is decremented at the respective rising edge and falling edge
of the TAlIN pin and TAlOUT pin. When performing this two-phase
pulse signal processing, bits 0 and 4 of timer Aj mode register must
be set to “1” and bits 1, 2, 3, and 5 must be “0”. Bits 6 and 7 are ig-
nored. (See Figure 27.) Note that bits 5, 6, and 7 of the up-down reg-
ister 0 (address 4416) are the two-phase pulse signal processing
select bits for timers A2, A3, and A4, respectively. Also, bits 5, 6, and
7 of the up-down register 1 (address C416) are the two-phase pulse
signal processing select bits for timers A7, A8, and A9, respectively.
Each timer operates in normal event counter mode when the corre-
sponding bit is “0” and performs two-phase pulse signal processing
when it is “1”.
Count is started by setting the count start bit to “1”. Data write and
read are performed in the same way as for normal event counter
mode. Note that the direction register of the input port must be set to
input mode because two kinds of pulse signals, described above,
are input. Also, there can be no pulse output in this mode.
Fig. 27 Bit configuration of timer Aj mode register when performing
two-phase pulse signal processing in event counter mode
Fig. 25 Two-phase pulse processing operation of timer A2, A3, A7,
A8
Fig. 26 Two-phase pulse processing operation of timers A4 and A9
TAkOUT
Decre-
ment-
count
Decre-
ment-
count
Decre-
ment-
count
Incre-
ment-
count
Incre-
ment-
count
Incre-
ment-
count
TAkIN
(k = 2, 3, 7, 8)
Fig. 24 Bit configuration of up-down register
Timer A0 up-down bit
Timer A1 up-down bit
Timer A2 up-down bit
Timer A3 up-down bit
Timer A4 up-down bit
Timer A2 two-phase pulse signal
processing select bit
0 : Two-phase pulse signal processing
disabled
1 : Two-phase pulse signal processing
mode
Timer A3 two-phase pulse signal
processing select bit
0 : Two-phase pulse signal processing
disabled
1 : Two-phase pulse signal processing
mode
Timer A4 two-phase pulse signal
processing select bit
0 : Two-phase pulse signal processing
disabled
1 : Two-phase pulse signal processing
mode
Up-down register 0
Address
4416
76543210
Timer A5 up-down bit
Timer A6 up-down bit
Timer A7 up-down bit
Timer A8 up-down bit
Timer A9 up-down bit
Timer A7 two-phase pulse signal
processing select bit
0 : Two-phase pulse signal processing
disabled
1 : Two-phase pulse signal processing
mode
Timer A8 two-phase pulse signal
processing select bit
0 : Two-phase pulse signal processing
disabled
1 : Two-phase pulse signal processing
mode
Timer A9 two-phase pulse signal
processing select bit
0 : Two-phase pulse signal processing
disabled
1 : Two-phase pulse signal processing
mode
Up-down register 1
Address
C416
76543210
TAlOUT
TAlIN
(l = 4, 9)
Decrement-count at each edge
Increment-count at each edge
Decrement-count at each edge
Increment-count at each edge
76543210
1
0
×
0100
0 1 : Always “01” in event counter mode
0 1 0 0 : Always “0100” when processing
two-phase pulse signal
× × : Not used in event counter mode
Timer A2 mode register
Timer A3 mode register
Timer A4 mode register
Timer A7 mode register
Timer A8 mode register
Timer A9 mode register
Addresses
5816
5916
5A16
C816
C916
CA16
相關PDF資料
PDF描述
M37905M8C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64
M37905M8C-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP64
M37905M4C-XXXSP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP64
M37905M4C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64
M37905M8C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64
相關代理商/技術參數
參數描述
M37905M4C-XXXSP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16 BIT CMOS MICROCOMPUTER
M37905M6C-XXXFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16 BIT CMOS MICROCOMPUTER
M37905M6C-XXXSP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16 BIT CMOS MICROCOMPUTER
M37905M8C-XXXFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16 BIT CMOS MICROCOMPUTER
M37905M8C-XXXSP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16 BIT CMOS MICROCOMPUTER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*