參數資料
型號: M30625MGN-XXXGP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP80
封裝: 14 X 14 MM, 0.65 MM PITCH, PLASTIC, QFP-80
文件頁數: 27/67頁
文件大?。?/td> 2968K
代理商: M30625MGN-XXXGP
34
MITSUBISHI MICROCOMPUTERS
4551 Group
SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER for
INFRARED REMOTE CONTROL TRANSMITTER
(5) Identification of the start condition
Warm start or cold start can be identified by examining the
state of the power down flag (P) with the SNZP instruction.
The warm start condition (timer 2 or external wakeup signal)
can be identified by examining the state of T2F flag.
Fig. 34 Set source and clear source of the P flag
q Set source
POF or POF2 instruction executed
Reset input
S
R
Q
Powerdown flag P
POF instruction
or
POF2 instruction
Reset input
Software start
P = “1”
T2F = “1”
?
No
Yes
Return by external
wakeup signal
Return by timer 2
underflow
Cold start
No
Fig. 35 Start condition identified example using the SNZP instruction
(6) Return signal
An external wakeup signal or timer 2 interrupt request flag is
used to return from the clock operating mode.
An external wakeup signal is used to return from the RAM
back-up mode because the oscillation is stopped. Table 16
shows the return condition for each return source.
(7) Port P1 control register
q Pull-up control register PU0
Register PU0 controls the ON/OFF of the port P1 pull-up
transistor and the ON/OFF of the key-on wakeup function.
Set the contents of this register through register A with
the TPU0A instruction. In addition, the TAPU0 instruction
can be used to transfer the contents of register PU0 to
register A.
Table 16 Return source and return condition
Remarks
Port P0 shares the falling edge detection circuit with port P1. The key-on
wakeup function of port P0 is always valid. The only key-on wakeup
function of the port P1 bit of which the pull-up transistor is turned on is
valid. Set all the port using the key-on wakeup function to “H” level before
going into the power down state.
The timer 2 interrupt request flag (T2F) can be used only when system
returns from the clock operating mode (POF instruction execution).
However, if the POF and POF2 instructions are executed while the T2F =
“1”, its operation is recognized as the return condition and system returns
from the clock operating mode.
Return condition
Returns by an external falling
edge input (“H”
→“L”).
Returns by timer 2 underflow and
setting T2F to “1.”
Return source
Ports P0, P1
Timer 2 interrupt
request flag
External
wakeup
signal
Note: P1 pin has the pull-up transistor which can be turned on/off by software.
Table 17 Pull-up control register
Pull-up transistor OFF, no key-on wakeup
Pull-up transistor ON, key-on wakeup
Pull-up transistor OFF, no key-on wakeup
Pull-up transistor ON, key-on wakeup
Pull-up transistor OFF, no key-on wakeup
Pull-up transistor ON, key-on wakeup
Pull-up transistor OFF, no key-on wakeup
Pull-up transistor ON, key-on wakeup
Port P13 pull-up transistor
control bit
Port P12 pull-up transistor
control bit
Port P11 pull-up transistor
control bit
Port P10 pull-up transistor
control bit
0
1
0
1
0
1
0
1
at reset : 00002
at power down : state retained
Pull-up control register PU0
R/W
PU03
PU02
PU01
PU00
Note: “R” represents read enabled, and “W” represents write enabled.
相關PDF資料
PDF描述
M30625FGNGP 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP80
M30621FCNGP 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP80
M3062GF8NFP 16-BIT, FLASH, 10 MHz, MICROCONTROLLER, PQFP100
M3062GF8NGP 16-BIT, FLASH, 10 MHz, MICROCONTROLLER, PQFP100
M3062GF8NGP 16-BIT, FLASH, 10 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
M30625MGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30625MGP-XXXGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30625MG-XXXGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30625MHP-XXXGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M30625MWP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER