Mitsubishi microcomputers
M16C / 62 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Interrupt
52
Hardware Interrupts
Hardware interrupts are classified into two types — special interrupts and peripheral I/O interrupts.
(1) Special interrupts
Special interrupts are non-maskable interrupts.
Reset
NMI interrupt
DBC interrupt
This interrupt is exclusively for the debugger, do not use it in other circumstances.
Watchdog timer interrupt
Generated by the watchdog timer.
Single-step interrupt
This interrupt is exclusively for the debugger, do not use it in other circumstances. With the debug
flag (D flag) set to “1”, a single-step interrupt occurs after one instruction is executed.
Address match interrupt
An address match interrupt occurs immediately before the instruction held in the address indicated by
the address match interrupt register is executed with the address match interrupt enable bit set to “1”.
If an address other than the first address of the instruction in the address match interrupt register is set,
no address match interrupt occurs.
_______
(2) Peripheral I/O interrupts
A peripheral I/O interrupt is generated by one of built-in peripheral functions. Built-in peripheral func-
tions are dependent on classes of products, so the interrupt factors too are dependent on classes of
products. The interrupt vector table is the same as the one for software interrupt numbers 0 through
31 the INT instruction uses. Peripheral I/O interrupts are maskable interrupts.
Bus collision detection interrupt
This is an interrupt that the serial I/O bus collision detection generates.
DMA0 interrupt, DMA1 interrupt
These are interrupts that DMA generates.
Key-input interrupt
A key-input interrupt occurs if an “L” is input to the KI pin.
A-D conversion interrupt
This is an interrupt that the A-D converter generates.
UART0, UART1, UART2/NACK, SI/O3 and SI/O4 transmission interrupt
These are interrupts that the serial I/O transmission generates.
UART0, UART1, UART2/ACK, SI/O3 and SI/O4 reception interrupt
These are interrupts that the serial I/O reception generates.
Timer A0 interrupt through timer A4 interrupt
These are interrupts that timer A generates
Timer B0 interrupt through timer B5 interrupt
INT0 interrupt through INT5 interrupt
An INT interrupt occurs if either a rising edge or a falling edge or a both edge is input to the INT pin.