- 您現在的位置：買賣IC網 > PDF目錄69009 > M30240M6-XXXXFP 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | M30240M6-XXXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 0.80 MM PITCH, PLASTIC, QFP-80 |
| 文件頁數： | 61/231頁 |
| 文件大?。?/td> | 3508K |
| 代理商： | M30240M6-XXXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁當前第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁
134
Mitsubishi microcomputers
M30240 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Specifications REV. G
Specifications in this manual are tentative and subject to change
Frequency Synthesizer
Change the DC-DC converter from high current mode to low current mode by setting USBC3 (bit 3
of the USBC) to a “1”
Disable the USB clock by setting USBC5 (bit 5 of USBC) to a “0”. Once the USB clock is disabled,
registers internal to the USB FCU should not be written to. This includes all USB SFRs from address
030016 to 033C16. It does not include USBC or FSC.
Perform other tasks to reduce total current to below 500
A.
Disable the PLL by setting FSE (bit 0 of FSC) to a “0”.
Make sure the I-FLAG is set to “1”.
Stop the system clock by setting CM10 (bit 0 of CM1) to a “1”. Make sure to first enable writing to the
system clock control register by setting PRCO (bit 0 of PRCR) to “1’. Also, make sure to enable the
USB Resume Interrupt (RSMIC register) and clear or execute any pending interrupts prior to stop-
ping the clock so the MCU can wake up once resume signaling is detected. If the clock is stopped
using an interrupt routine, make sure to set the priority of the Resume Interrupt (RSMIC) higher than
the current interrupt.
Note that no action may be necessary if the device is self powered.
1.5.1.6 Set up after USB Resume Signaling Detected
A resume occurs when the USB FCU is in the suspend state and detects a non-idle signaling on D+/
D-. Detection of a resume results in bit 6 of USBIS2 and bit 1 of USBPM (RESUME) being set to a “1”.
This causes bit 3 of RSMIC to also be set to “1”. If the MCU was in the stop state prior to the detection
of the resume, the USB Resume Interrupt request will cause the MCU to wake up from the stop state.
Bit 6 of USBIS2 needs to be cleared (by writing a “1” to the bit) in order to allow a future resume event.
See section 2.9 “Stop Mode” for details on waking up from the stop state.
The configuration of the frequency synthesizer and DC-DC converter should be changed as follows in
the USB Resume Interrupt routine (if the device is bus powered):
Re-enable the PLL for 48MHz f(VCO) by setting FSE (bit 0 of the FSC) to a “1”, then wait for 2 ms.
Wait for 2 ms.
Check the lock status bit (LS, bit 7 of FSC).
If the bit is a “1”, continue.
If the bit is a “0”, wait 0.1
ms longer and then re-check the bit.
Enable the USB clock by setting USBC5 (bit 5 of USBC) to a “1”.
Wait for a minimum of 4 cycles.
Change the DC-DC converter from low current mode to high current mode by setting USBC3 (bit 3
of the USBC) to a “0”.
Enable other blocks as necessary.
Registers internal to the USB FCU should not be written to until the USB clock is re-enabled. This in-
cludes all USB SFRs from address 030016 to 033C16. It does not include USBC or FSC.
Note that the configuration changes described above may not need to be made if the MCU was not
placed in a suspend state as described in section 5.1.2.3 Set up after USB Suspend Detected.
1.5.1.7 PLL Lock Bit
The PLL lock bit is used to indicate when the PLL is first locked. Accordingly, after the PLL is enabled
and it has been given 2.0 ms to stabilize, the lock bit status should be checked. Once the lock bit is
HIGH, the USB check should be enabled. After this stage, the lock bit is no longer valid and should
not be monitored, unless the PLL is re-enabled.
相關PDF資料 |
PDF描述 |
|---|---|
| M30240ECFP | 16-BIT, OTPROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240M5-XXXXFP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240M6-XXXXFP | 16-BIT, OTPROM, MICROCONTROLLER, PQFP80 |
| M30240ECFP | 16-BIT, OTPROM, MICROCONTROLLER, PQFP80 |
| M30621FCMGP | 16-BIT, FLASH, 10 MHz, MICROCONTROLLER, PQFP80 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M30240M7 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M7-XXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M8 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M8-XXXFP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M9 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。