
Mitsubishi microcomputers
M30220 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
A-D Converter
130
Item
Performance
Method of A-D conversion Successive approximation (capacitive coupling amplifier)
Analog input voltage (Note 1) 0V to AVCC (VCC)
Operating clock
φAD (Note 2) VCC = 4.0 to 5.5V fAD/divide-by-2 of fAD/divide-by-4 of fAD, fAD=f(XIN)
VCC = 2.7 to 4.0V divide-by-2 of fAD/divide-by-4 of fAD, fAD=f(XIN)
Resolution
8-bit or 10-bit (selectable)
Absolute precision
VCC = 5V
Without sample and hold function
±3LSB
With sample and hold function (8-bit resolution)
±2LSB
With sample and hold function (10-bit resolution)
±3LSB
VCC = 3V
Without sample and hold function (8-bit resolution)
±2LSB
Operating modes
One-shot mode, repeat mode, single sweep mode, repeat sweep mode 0,
and repeat sweep mode 1
Analog input pins
8pins (AN0 to AN7)
A-D conversion start condition Software trigger
A-D conversion starts when the A-D conversion start flag changes to “1”
External trigger (can be retriggered)
A-D conversion starts when the A-D conversion start flag is “1” and the
___________
ADTRG/P130 input changes from “H” to “L”
Conversion speed per pin Without sample and hold function
8-bit resolution: 49
φAD cycles, 10-bit resolution: 59 φAD cycles
With sample and hold function
8-bit resolution: 28
φAD cycles, 10-bit resolution: 33 φAD cycles
A-D Converter
The A-D converter consists of one 10-bit successive approximation A-D converter circuit with a capacitive coupling
amplifier. Pins P90 to P97 also function as the analog signal input pins. The direction registers of these pins for A-
D conversion must therefore be set to input. The Vref connect bit (bit 5 at address 03D716) can be used to isolate
the resistance ladder of the A-D converter from the reference voltage input pin (VREF) when the A-D converter is not
used. Doing so stops any current flowing into the resistance ladder from VREF, reducing the power dissipation.
When using the A-D converter, start A-D conversion only after setting bit 5 of 03D716 to connect VREF.
The result of A-D conversion is stored in the A-D registers of the selected pins. When set to 10-bit precision, the low
8 bits are stored in the even addresses and the high 2 bits in the odd addresses. When set to 8-bit precision, the low
8 bits are stored in the even addresses.
Table 1.17.1 shows the performance of the A-D converter. Figure 1.17.1 shows the block diagram of the
A-D converter, and Figures 1.17.2 and 1.17.3 show the A-D converter-related registers.
Note 1: Does not depend on use of sample and hold function.
Note 2: Without sample and hold function, set the
φAD frequency to 250kHZ min.
With the sample and hold function, set the
φAD frequency to 1MHZ min.
Table 1.17.1. Performance of A-D converter