- 您現在的位置：買賣IC網 > PDF目錄358968 > LZ21N3 (Sharp Corporation) 1/2-type Interline Color CCD Area Sensor with 2 140 k Pixels PDF資料下載
參數資料
| 型號： | LZ21N3 |
| 廠商： | Sharp Corporation |
| 英文描述： | 1/2-type Interline Color CCD Area Sensor with 2 140 k Pixels |
| 中文描述： | 1/2-type隔行彩色CCD傳感器的面積2 140萬像素 |
| 文件頁數： | 4/19頁 |
| 文件大?。?/td> | 153K |
| 代理商： | LZ21N3 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁
LZ21N3
4
CHARACTERISTICS
(Drive method : 1/30 s frame accumulation)
(T
A
= +25 C, Operating conditions : The typical values specified in "
RECOMMENDED OPERATING CONDITIONS
".
Color temperature of light source : 3 200 K, IR cut-off filter (CM-500, 1 mmt) is used.)
PARAMETER
SYMBOL
Standard output voltage
Photo response non-uniformity
MIN.
TYP.
150
MAX.
UNIT
mV
%
mV
mV
NOTE
2
3
4
5
V
O
PRNU
10
Saturation output voltage
V
SAT
450
320
530
400
Dark output voltage
Dark signal non-uniformity
Sensitivity
Smear ratio
Image lag
Blooming suppression ratio
Output transistor drain current
NOTES :
Within the recommended operating conditions of V
OD
,
V
OFD
of the internal output satisfies with ABL larger than
1 000 times exposure of the standard exposure conditions,
and V
SAT
larger than 320 mV.
1. T
A
= +60 C
2. The average output voltage under uniform illumination.
The standard exposure conditions are defined as when
Vo is 150 mV.
3. The image area is divided into 10 x 10 segments under
the standard exposure conditions. Each segment's
voltage is the average output voltage of all pixels within
the segment. PRNU is defined by (Vmax – Vmin)/Vo,
where Vmax and Vmin are the maximum and minimum
values of each segment's voltage respectively.
4. The image area is divided into 10 x 10 segments. Each
segment's voltage is the average output voltage of all
pixels within the segment. V
SAT
is the minimum
segment's voltage under 10 times exposure of the
standard exposure conditions. The operation of OFDC is
high. (for still image capturing)
5. The image area is divided into 10 x 10 segments. Each
segment's voltage is the average output voltage of all
pixels within the segment. V
SAT
is the minimum
segment's voltage under 10 times exposure of the
standard exposure conditions. The operation of OFDC is
low.
V
DARK
DSNU
R
SMR
AI
ABL
I
OD
0.5
0.5
180
–89
3.0
2.0
mV
mV
mV
dB
%
1, 6
1, 7
8
9
10
11
140
–82
1.0
1 000
4.0
8.0
mA
6. The average output voltage under non-exposure
conditions.
7. The image area is divided into 10 x 10 segments under
non-exposure conditions. DSNU is defined by (Vdmax –
Vdmin), where Vdmax and Vdmin are the maximum and
minimum values of each segment's voltage respectively.
8. The average output voltage when a 1 000 lux light
source with a 90% reflector is imaged by a lens of F4,
f50 mm.
9. The sensor is exposed only in the central area of V/10
square with a lens at F4, where V is the vertical image
size. SMR is defined by the ratio of the output voltage
detected during the vertical blanking period to the
maximum output voltage in the V/10 square.
10. The sensor is exposed at the exposure level
corresponding to the standard conditions. AI is defined
by the ratio of the output voltage measured at the 1st
field during the non-exposure period to the standard
output voltage.
11. The sensor is exposed only in the central area of V/10
square, where V is the vertical image size. ABL is
defined by the ratio of the exposure at the standard
conditions to the exposure at a point where blooming is
observed.
相關PDF資料 |
PDF描述 |
|---|---|
| LZ2314HJ | 1/3-type CCD Area Sensors with 270 k Pixels |
| LZ2316AR | Dual-power-supply (5 V/12 V) Operation 1/3-type CCD Area Sensors with 270 k Pixels |
| LZ2323H5 | PLUG, D, FILTERED, 330PF, 62WAY; Connector type:D Sub, High-Density; Gender:Plug; Ways, No. of:62; Termination method:Solder; Material, contact:Copper Alloy; Plating, contact:Bright Tin; Series:FHTB; Material:Steel; Current RoHS Compliant: Yes |
| LZ2325A | Dual-power-supply (5 V/12 V) Operation 1/3-type CCD Area Sensors with 320 k Pixels |
| LZ2336 | Two-power supply (+5 V and +12 V) operation 1 / 3 type B/W CCD Area Sensor for EIA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LZ21N3V | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:1/2-type Interline Color CCD Area Sensors with 2 140 k Pixels |
| LZ21N3VS | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:1/2-type Interline Color CCD Area Sensors with 2 140 k Pixels |
| LZ22 | 制造商:ebm-papst Inc 功能描述:GUARD FINGER 200X51MM 制造商:ebm-papst Inc 功能描述:GUARD, FINGER, 200X51MM 制造商:ebm-papst Inc 功能描述:GUARD, FINGER, 200X51MM; For Use With:Fans; Fan Size:200mm; Fixing Centres:148.5mm; Guard Material:Steel; SVHC:No SVHC (19-Dec-2012); Accessory Type:Finger Guard; External Height:199.5mm; External Width:199.5mm ;RoHS Compliant: Yes 制造商:ebm-papst Inc 功能描述:2200F metal fan finger guard, 200x51mm |
| LZ22-2 | 功能描述:風扇電線及配件 FINGER GRD RoHS:否 制造商:ebm-papst 類型:Finger Guard 適合風扇大小:120 mm 系列: |
| LZ22250G | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Photoresistor-Based Position Sensor |
發布緊急采購，3分鐘左右您將得到回復。