- 您現在的位置：買賣IC網 > PDF目錄69008 > LX1684CDT (MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP) 1 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO14 PDF資料下載
參數資料
| 型號： | LX1684CDT |
| 廠商： | MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封裝： | PLASTIC, SOIC-14 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 292K |
| 代理商： | LX1684CDT |
Microsemi
Linfinity Microelectronics Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 6
Copyright
2000
Rev. 1.0, 2001-09-19
WWW
.M
ic
ro
sem
i
.COM
LX1684
Voltage-Mode PWM Controller
PRODUCTION
L I N F IN IT Y
D I V I S I O N
APPLI CATION I
APPLI CATION I N FO RM ATION
NF O R M A TION
OUTPUT INDUCTOR
The output inductor should be selected to meet the requirements
of the output voltage ripple in steady-state operation and the
inductor current slew-rate during transient. The peak-to-peak
output voltage ripple is:
RIPPLE
I
ESR
V
×
=
where
()
IN
OUT
IN
RIPPLE
V
-
V
I
×
=
L
fSW
IRIPPLE is the inductor ripple current, L is the output inductor
value and ESR is the Effective Series Resistance of the output
capacitor.
IRIPPLE should typically be in the range of 20% to 40% of the
maximum output current. Higher inductance results in lower
output voltage ripple, allowing slightly higher ESR to satisfy the
transient specification. Higher inductance also slows the inductor
current slew rate in response to the load-current step change, I,
resulting in more output-capacitor voltage droop. The inductor-
current rise and fall times are:
()
OUT
IN
V
×
=
I
L
TRISE
and
OUT
V
I
L
TFALL
×
=
When using electrolytic capacitors, the capacitor voltage droop
is usually negligible, due to the large capacitance.
OUTPUT CAPACITOR
The output capacitor is sized to meet ripple and transient
performance specifications. Effective Series Resistance (ESR) is a
critical parameter. When a step load current occurs, the output
voltage will have a step that equals the product of the ESR and the
current step, I. In an advanced microprocessor power supply, the
output capacitor is usually selected for ESR instead of capacitance
or RMS current capability. A capacitor that satisfies the ESR
requirement usually has a larger capacitance and current capability
than strictly needed. The allowed ESR can be found by:
()
EX
V
I
ESR
<
+
× RIPPLE
I
where IRIPPLE is the inductor ripple current, I is the maximum
load current step change, and V
EX is the allowed output voltage
excursion in the transient.
OUTPUT CAPACITOR (continued)
Electrolytic capacitors can be used for the output capacitor, but
are less stable with age than tantalum capacitors. As they age, their
ESR degrades, reducing the system performance and increasing
the risk of failure. It is recommended that multiple parallel
capacitors be used, so that, as ESR increases with age, overall
performance will still meet the processor’s requirements.
There is frequently strong pressure to use the least expensive
components possible, however, this could lead to degraded long-
term reliability, especially in the case of filter capacitors.
Linfinity’s demonstration boards use Sanyo MV-GX filter
capacitors,
which
are
aluminum
electrolytic,
and
have
demonstrated reliability. The Oscon series from Sanyo generally
provides the very best performance in terms of long term ESR
stability and general reliability, but at a substantial cost penalty.
The MV-GX series provides excellent ESR performance at a
reasonable cost. Beware of off-brand, very low-cost filter
capacitors, which have been shown to degrade in both ESR and
general electrolytic characteristics over time.
INPUT CAPACITOR
The input capacitor and the input inductor are to filter the
pulsating current generated by the buck converter to reduce
interference to other circuits connected to the same 12V rail. In
addition, the input capacitor provides local de-coupling the buck
converter. The capacitor should be rated to handle the RMS
current requirement. The RMS current is:
)
1
(
d
I
L
RMS
=
where I
L is the inductor current and the d is the duty cycle. The
maximum value, when d = 50%, I
RMS = 0.5IL . For 12V input and
output in the range of 3V, the required RMS current is very close
to 0.43I
L.
SOFT-START CAPACITOR
The value of the soft-start capacitor determines how fast the
output voltage rises and how large the inductor current is required
to charge the output capacitor. The output voltage will follow the
voltage at SS pin if the required inductor current does not exceed
the maximum current in the inductor. The SS pin voltage can be
expressed as:
)
1
(
/
SS
C
R
t
SET
SS
e
V
=
where V
SET is the reference voltage. RSS and CSS are soft start
resistor and capacitor. The required inductor current for the output
capacitor to follow the SS-pin voltage equals the required
capacitor current plus the load current. The soft-start capacitor
should be selected so that the overall inductor current does not
exceed its maximum.
AA
PP
LL
IICC
AA
TT
IIOO
NN
SS
相關PDF資料 |
PDF描述 |
|---|---|
| LX1689CPW-TR | FLUORESCENT LIGHT CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LX1689IPW-TR | FLUORESCENT LIGHT CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LX1691IPWTR | 0.1 A FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO16 |
| LX1741CLM-TR | 0.145 A SWITCHING CONTROLLER, PDSO8 |
| LX1741CDU-TR | 0.145 A SWITCHING CONTROLLER, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LX1684CD-TR | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Voltage-Mode PWM Controller |
| LX1686 | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Digital Dimming CCFL Controller IC |
| LX1686CPW | 功能描述:IC CTRLR CCFL BACKLIGHT 24TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 照明，鎮流器控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:CCFL 控制器 頻率:40 ~ 80 kHz 電流 - 電源:5mA 電流 - 輸出:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) 其它名稱:90-3991V+V01 |
| LX1686CPWT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Ballast/Backlight Controller/Driver |
| LX1686CPW-TR | 制造商:Microsemi Corporation 功能描述:CCFL Controller 3.3V/5V 24-Pin TSSOP T/R |
發布緊急采購，3分鐘左右您將得到回復。