- 您現在的位置：買賣IC網 > PDF目錄95794 > LV5654T (SANYO SEMICONDUCTOR CO LTD) SWITCHING REGULATOR, PDSO36 PDF資料下載
參數資料
| 型號： | LV5654T |
| 廠商： | SANYO SEMICONDUCTOR CO LTD |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO36 |
| 封裝： | 0.275 INCH, TSSOP-36 |
| 文件頁數： | 2/10頁 |
| 文件大?。?/td> | 117K |
| 代理商： | LV5654T |
LV5654T
PS No.A1360-10/10
SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using
products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.
products described or contained herein.
SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all
semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or
malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise
to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt
safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not
limited to protective circuits and error prevention circuits for safe design, redundant design, and structural
design.
Upon using the technical information or products described herein, neither warranty nor license shall be granted
with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third
party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's
intellctual property rights which has resulted from the use of the technical information and products mentioned
above.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed
for volume production.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the
SANYO Semiconductor Co.,Ltd. product that you intend to use.
In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are
controlled under any of applicable local export control laws and regulations, such products may require the
export license from the authorities concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,
without the prior written consent of SANYO Semiconductor Co.,Ltd.
(4) SCP function
Description of operation
When any one of FB1 to FB4 goes High due to the load being shorted or other reason, charging to the SCP pin starts.
If output does not recover during the set time Tscp and the SCP pin voltage exceeds the threshold voltage, the
protection circuit (SCP) operates, and all channel outputs are turned OFF. The SCP_OUT pin set from High to Low.
All outputs are latched OFF by the protection circuit (SCP). This latched state (output OFF) is canceled by setting
the CTL pin Low or by turning the power supply off.
When not using the protection function (SCP), the SCP pin must be shorted to GND_S with a line that is as short as
possible.
SCP_OUT
The SCP_OUT pin functions to notify an external microcontroller or other component of the output status (Low
when SCP operates). The output configuration is an open drain output, and a pull-up resistor is used. When not used,
leave this pin open.
Switching time
The SCP_OUT switching time is set by the capacitor connected to the SCP pin.
(SCP charging operation)
(SCP and SCP_OUT operation)
This catalog provides information as of December, 2008. Specifications and information herein are subject
to change without notice.
SCP [V]
SCP
CTL
When STBY* is regarded as High
(the output is turned on by setting CTL Low to High).
SCP_OUT
T [s]
tscp
SCP operation
Charging with Iscp = 4 [
A]
Threshold voltage
1.25V (TYP)
Capacitor charging starts
with the load being shorted
Output short circuit
1.25 [V]
(TYP)
相關PDF資料 |
PDF描述 |
|---|---|
| LV5761V | SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PDSO16 |
| LV58061MX | SWITCHING REGULATOR, PDSO8 |
| LV58761MX | SWITCHING REGULATOR, PDSO8 |
| LV59012M | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LV8012T | BRUSH DC MOTOR CONTROLLER, 1.4 A, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LV5654T-MPB-H | 制造商:ON Semiconductor 功能描述:4 CHANNEL DC-DC CONVERTER - Ammo Pack |
| LV5654T-TLM-H | 制造商:ON Semiconductor 功能描述:4 CHANNEL DC-DC CONVERTER - Tape and Reel |
| LV5655VB | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:3-channel Switching Regulator Controller |
| LV5655VB-MPB-E | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| LV5655VB-TLM-E | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
發布緊急采購，3分鐘左右您將得到回復。