參數資料
型號: LTNS
廠商: Linear Technology Corporation
英文描述: 24-Bit No Latency ADC with Differential Input and Reference in MSOP
中文描述: 24位不具有差動輸入和ADC的參考延遲,采用MSOP
文件頁數: 38/40頁
文件大?。?/td> 503K
代理商: LTNS
LTC2411/LTC2411-1
38
APPLICATIOU
gain error or due to offset voltages. A 1
μ
V/
°
C offset voltage
drift translates into 0.05ppm/
°
C gain error. Simpler alter-
natives, with the amplifiers providing gain using resistor
arrays for feedback, can produce results that are similar to
bridge sensing schemes via attenuators. Note that the
amplifiers must have high open-loop gain or gain error will
be a source of error. The fact that input offset voltage has
relatively little effect on overall error may lead one to use
low performance amplifiers for this application. Note that
the gain of a device such as an LF156, (25V/mV over
temperature) will produce a worst-case error of –180ppm
at a noise gain of 3, such as would be encountered in an
inverting gain of 2, to produce –10V from a 5V reference.
The error associated with the 10V excitation would be
–80ppm. Hence, overall reference error could be as high
as 130ppm, the average of the two.
Figure 47 shows a similar scheme to provide excitation
using resistor arrays to produce precise gain. The circuit
is configured to provide 10V and –5V excitation to the
bridge, producing a common mode voltage at the input to
W
U
U
Figure 46. Use a Differential Multiplexer to Expand Channel Capability
the LTC2411/LTC2411-1 of 2.5V, maximizing the AC input
range for applications where induced 60Hz could reach
amplitudes up to 2V
RMS
.
The circuits in Figures 45 and 47 could be used where
multiple bridge circuits are involved and bridge output can
be multiplexed onto a single LTC2411/LTC2411-1, via an
inexpensive multiplexer such as the 74HC4052.
Figure 46 shows the use of an LTC2411/LTC2411-1 with
a differential multiplexer. This is an inexpensive multi-
plexer that will contribute some error due to leakage if
used directly with the output from the bridge, or if resistors
are inserted as a protection mechanism from overvoltage.
Although the bridge output may be within the input range
of the A/D and multiplexer in normal operation, some
thought should be given to fault conditions that could
result in full excitation voltage at the inputs to the multi-
plexer or ADC. The use of amplification prior to the
multiplexer will largely eliminate errors associated with
channel leakage developing error voltages in the source
impedance.
2411 F46
REF
+
REF
IN
IN
6
A0
A1
V
CC
GND
13
3
6
12
47
μ
F
14
1
5
10
16
5V
15
11
2
TO OTHER
DEVICES
4
9
8
5V
+
74HC4052
2
3
4
5
1
LTC2411/
LTC2411-1
相關PDF資料
PDF描述
LTNT 24-Bit No Latency ADC with Differential Input and Reference in MSOP
LTWV 24-Bit No Latency ADC with Differential Input and Reference in MSOP
LTZ1000ACH Ultra Precision Reference
LTZ1000CH Ultra Precision Reference
LUDZS4.3B Low Current Operation at 250??A???Low Reverse Leakage,Low Noise Zener Diode(250??A?·¥?????μ?μ?????°????????????μ?μ?????????a?£°???é???o3?o???????)
相關代理商/技術參數
參數描述
LTNT 制造商:LINER 制造商全稱:Linear Technology 功能描述:24-Bit No Latency ADC with Differential Input and Reference in MSOP
LTO-01T-110N 制造商:JST Manufacturing 功能描述:Crimping Tools, Hand Tools 制造商:Pentair Technical Products / Hoffman 功能描述:TERMINAL FEMALE DISCONNECT 0.11IN CRIMP 制造商:HOFFMAN PRODUCTS 功能描述:TERMINAL, FEMALE DISCONNECT 0.11IN CRIMP 制造商:Pentair Technical Products / Hoffman 功能描述:TERMINAL, FEMALE DISCONNECT 0.11IN CRIMP; Connector Type:Female Disconnect; Series:-; Termination Method:Crimp; Stud/Tab Size:0.11" x 0.02"; Wire Size AWG Min:24AWG; Wire Size AWG Max:20AWG; Insulator Material:Uninsulated
LTO-01T-187N 制造商:JST Manufacturing 功能描述:
LTO030F10000FTE3 功能描述:厚膜電阻器 - 透孔 1K OHM 1% 30W RoHS:否 制造商:Caddock 電阻:27 kOhms 容差:1 % 功率額定值:8 W 溫度系數:50 PPM / C 系列:MS 端接類型:Axial 電壓額定值:2 kV 工作溫度范圍:- 15 C to + 275 C 尺寸:8.89 mm Dia. x 23.11 mm L 封裝:Bulk
LTO030F10000JTE3 功能描述:厚膜電阻器 - 透孔 1000ohms 5% RoHS:否 制造商:Caddock 電阻:27 kOhms 容差:1 % 功率額定值:8 W 溫度系數:50 PPM / C 系列:MS 端接類型:Axial 電壓額定值:2 kV 工作溫度范圍:- 15 C to + 275 C 尺寸:8.89 mm Dia. x 23.11 mm L 封裝:Bulk