參數資料
型號： LTM8052EV#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PBGA81
封裝： 15 X 11.25 MM, 2.82 MM HEIGHT, ROHS COMPLIANT, MO-222, LGA-81
文件頁數： 7/28頁
文件大?。?/td> 350K
代理商： LTM8052EV#PBF
LTM8052
15
8052f
must have a logic low below 0.6V, a logic high greater
than 1.2V and frequency between 100kHz and 1MHz. The
input frequency must be 20% higher than the frequency
determined by the resistor at the RT pin. Input signals
outside of these specified parameters may cause erratic
switching behavior and subharmonic oscillations. The
SYNC pin must be tied to GND if synchronization to an
external clock is not required. When SYNC is grounded,
the switching frequency is determined by the resistor at
the RT pin.
Switching Mode
The LTM8052 operates in forced continuous mode. This
means that the part will not skip cycles when the load
approaches zero amps. This may be particularly useful in
applications where the synchronization function is used,
or any time discontinuous switching is undesirable. The
LTM8052 will not operate in forced continuous mode
when an input UVLO, output OVLO or minimum duty cycle
violation occurs.
Soft-Start
The soft-start function controls the slew rate of the power
supply output voltage during start-up. A controlled output
voltagerampminimizesoutputvoltageovershoot,reduces
inrush current from the VIN supply, and facilitates supply
sequencing. A capacitor connected from the SS pin to
GND programs the slew rate. The capacitor is charged
from an internal 11A current source to produce a ramped
output voltage.
Maximum Output Current Adjust
To adjust the regulated load current, an analog voltage
is applied to the CTL_I pin or CTL_T pins. Varying the
voltage between 0V and 1.5V adjusts the maximum
current between the minimum and the maximum current,
typically 5.6A positive and 7.7A negative. Graphs of the
output current vs CTL_I and CTL_T voltages are given
in the Typical Performance Characteristics section. The
LTM8052providesa2Vreferencevoltageforconveniently
applying resistive dividers to set the current limit. The
applicaTions inForMaTion
Figure 1. Setting the Output Current Limit
current limit can be set as shown in Figure 1 with the
following equation:
IMAX =
7.467 R2
R1
+R2
Amps Positive Current
(
)
IMAX =
7.467 R2
R1
+R2
+ 2.1 Amps Negative Current
(
)
Load Current Derating Using the CTL_T Pin
Inhighcurrentapplications,deratingthemaximumcurrent
basedonoperatingtemperaturemaypreventdamagetothe
load.Inaddition,manyapplicationshavethermallimitations
that will require the regulated current to be reduced based
on the load and/or board temperature. To achieve this,
the LTM8052 uses the CTL_T pin to reduce the effective
regulated current in the load. While CTL_I programs the
regulated current in the load, CTL_T can be configured to
reduce this regulated current based on the analog voltage
at the CTL_T pin. The load/board temperature derating is
programmed using a resistor network with a temperature
dependant resistance (Figure 2). When the board/load
temperature rises, the CTL_T voltage will decrease. To
reduce the regulated current, the CTL_T voltage must be
lower than the voltage at the CTL_I pin. VCTL_T may be
higher than VCTL_I, but then it will have no effect.
Figure 2. Load Current Derating vs
Temperature Using NTC Resistor
LTM8052
VREF
R1
2V
R2
8052 F01
CTL_I OR CTL_T
LTM8052
VREF
RNTC
RX
RV
R1
R2
(OPTION A TO D)
8052 F02
CTL_T
B
RNTC
A
RNTC
RX
D
RNTC
C
相關PDF資料
PDF描述
LTM8052IV#PBF SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PBGA81
LTM8062EV#PBF BATTERY CHARGE CONTROLLER, 1150 kHz SWITCHING FREQ-MAX, PBGA77
LTM8062AEV#PBF BATTERY CHARGE CONTROLLER, 1150 kHz SWITCHING FREQ-MAX, PBGA77
LTM9005CV-AA#PBF SPECIALTY ANALOG CIRCUIT, PBGA204
LTM9005CV-AB#PBF SPECIALTY ANALOG CIRCUIT, PBGA204
相關代理商/技術參數
參數描述
LTM8052IV#PBF 功能描述:IC UMODULE CVCC STEP DOWN 81LGA RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:µModule® 設計資源:VI-200, VI-J00 Design Guide, Appl Manual 標準包裝:1 系列:* 類型:隔離 輸出數:1 電壓 - 輸入（最?。?55V 電壓 - 輸入（最大）:100V Voltage - Output 1:5.8V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:* 電源（瓦） - 制造商系列:100W 電壓 - 隔離:* 特點:* 安裝類型:通孔 封裝/外殼:9 針半磚 BusMod 尺寸/尺寸:2.36" L x 2.28" W x 1.08" H（59.9mm x 57.9mm x 27.4mm） 包裝:散裝 工作溫度:-25°C ~ 100°C 效率:* 電源（瓦特）- 最大:*
LTM8061 制造商:LINER 制造商全稱:Linear Technology 功能描述:32V, 2A μModule Li-Ion/ Polymer Battery Charger
LTM8061EV-4.1#PBF 功能描述:IC BATTERY CHARGER 4.1V 77-LGA RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:µModule® 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2
LTM8061EV-4.1PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:32V, 2A μModule Li-Ion/ Polymer Battery Charger
LTM8061EV-4.2#PBF 功能描述:IC BATTERY CHARGER 4.2V 77-LGA RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:µModule® 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*