- 您現在的位置：買賣IC網 > PDF目錄377768 > LTCVX (Linear Technology Corporation) Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown PDF資料下載
參數資料
| 型號： | LTCVX |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown |
| 中文描述： | 串行12-Bit/14-Bit，3.5Msps采樣ADC，帶有關斷 |
| 文件頁數： | 10/16頁 |
| 文件大小： | 232K |
| 代理商： | LTCVX |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁
10
LTC2355-12/LTC2355-14
2355f
INPUT FILTERING AND SOURCE IMPEDANCE
The noise and the distortion of the input amplifier and
other circuitry must be considered since they will add to
the LTC2355-12/LTC2355-14 noise and distortion. The
small-signal bandwidth of the sample-and-hold circuit is
50MHz. Any noise or distortion products that are present
at the analog inputs will be summed over this entire
bandwidth. Noisy input circuitry should be filtered prior to
the analog inputs to minimize noise. A simple 1-pole RC
filter is sufficient for many applications. For example,
Figure 1 shows a 47pF capacitor from A
IN+
to ground and
a 51
source resistor to limit the input bandwidth to
47MHz. The 47pF capacitor also acts as a charge reservoir
for the input sample-and-hold and isolates the ADC input
from sampling-glitch sensitive circuitry. High quality ca-
pacitors and resistors should be used since these compo-
nents can add distortion. NPO and silvermica type dielectric
capacitors have excellent linearity. Carbon surface mount
resistors can generate distortion from self heating and
from damage that may occur during soldering. Metal film
surface mount resistors are much less susceptible to both
problems. When high amplitude unwanted signals are
close in frequency to the desired signal frequency, a
multiple pole filter is required. High external source resis-
tance, combined with the 13pF of input capacitance, will
reduce the rated 50MHz bandwidth and increase acquisi-
tion time beyond 39ns.
Figure 1. RC Input Filter
Figure 2. Overdriving V
REF
Pin with an External Reference
INPUT RANGE
The analog inputs of the LTC2355-12/LTC2355-14 may be
driven fully differentially with a single supply. Each input
may swing up to 2.5V
P-P
individually. When using the
internal reference, the noninverting input should never be
more than 2.5V more positive than the inverting input. The
0V to 2.5V range is also ideally suited for single-ended
input use with single supply applications. The common
mode range of the inputs extend from ground to the supply
voltage V
DD
. If the difference between the A
IN+
and A
IN–
inputs exceeds 2.5V, the output code will stay fixed at all
ones and if this difference goes below 0V, the ouput code
will stay fixed at all zeros.
INTERNAL REFERENCE
The LTC2355-12/LTC2355-14 has an on-chip, tempera-
ture compensated, bandgap reference that is factory
trimmed to 2.5V to obtain a unipolar 0V to 2.5V input span.
The reference amplifier output V
REF
, (Pin 3) must be
bypassed with a capacitor to ground. The reference ampli-
fier is stable with capacitors of 1
μ
F or greater. For the best
noise performance, a 10
μ
F ceramic or a 10
μ
F tantalum in
parallel with a 0.1
μ
F ceramic is recommended. The V
REF
pin can be overdriven with an external reference as shown
in Figure 2. The voltage of the external reference must be
higher than the 2.5V output of the internal reference. The
recommended range for an external reference is 2.55V to
V
DD
. An external reference at 2.55V will see a DC quiescent
load of 0.75mA and as much as 3mA during conversion.
APPLICATIU
W
U
U
10
μ
F
11
3
A
IN–
LTC2355-12/
LTC2355-14
V
REF
A
IN+
47pF
2
1
51
GND
2355 F01
GND
LTC2355-12/
LTC2355-14
LT1790-3
V
REF
10
μ
F
3.5V TO 18V
11
3
3V
2355 F02
相關PDF資料 |
PDF描述 |
|---|---|
| LTCVY | Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown |
| LTC2402CMS | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| LTC2401 | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| LTC2401CMS | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| LTC2401IMS | 18-Bit Universal Bus Driver With 3-State Outputs 56-SSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTCVY | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown |
| LTCWK | 制造商:LINER 制造商全稱:Linear Technology 功能描述:36V Low Cost High Side Current Sense in a SOT-23 |
| LTCXX | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.1A, Low Noise, Low Dropout Linear Regulator |
| LTCYF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:36V, 2A, 2.4MHz Step-Down Switching Regulator |
| LTCYM | 制造商:LINER 制造商全稱:Linear Technology 功能描述:36V, 3.5A, 2.4MHz Step-Down Switching Regulator with 75μA Quiescent Current |
發布緊急采購，3分鐘左右您將得到回復。