參數資料
型號: LTC3859EFE#TRPBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO38
封裝: 4.40 MM, LEAD FREE, PLASTIC, TSSOP-38
文件頁數: 17/42頁
文件大?。?/td> 624K
代理商: LTC3859EFE#TRPBF
LTC3859
24
3859fa
APPLICATIONS INFORMATION
a good compromise for both regions of operation due to
the relatively small average current. Larger diodes result
in additional transition losses due to their larger junction
capacitance.
Boost CIN, COUT Selection
The input ripple current in a boost converter is relatively
low (compared with the output ripple current), because
this current is continuous. The boost input capacitor CIN
voltage rating should comfortably exceed the maximum
input voltage. Although ceramic capacitors can be relatively
tolerant of overvoltage conditions, aluminum electrolytic
capacitors are not. Be sure to characterize the input voltage
for any possible overvoltage transients that could apply
excess stress to the input capacitors.
The value of CIN is a function of the source impedance, and
in general, the higher the source impedance, the higher the
required input capacitance. The required amount of input
capacitance is also greatly affected by the duty cycle. High
output current applications that also experience high duty
cycles can place great demands on the input supply, both
in terms of DC current and ripple current.
In a boost converter, the output has a discontinuous current,
so COUT must be capable of reducing the output voltage
ripple. The effects of ESR (equivalent series resistance) and
the bulk capacitance must be considered when choosing
the right capacitor for a given output ripple voltage. The
steady ripple due to charging and discharging the bulk
capacitance is given by:
Ripple
=
IOUT(MAX) VOUT VIN(MIN)
()
COUT VOUT f
V
where COUT is the output lter capacitor.
The steady ripple due to the voltage drop across the ESR
is given by:
DVESR = IL(MAX) ESR
Multiple capacitors placed in parallel may be needed to
meet the ESR and RMS current handling requirements.
Dry tantalum, special polymer, aluminum electrolytic and
ceramic capacitors are all available in surface mount
packages. Ceramic capacitors have excellent low ESR
characteristics but can have a high voltage coefcient.
Capacitors are now available with low ESR and high ripple
current ratings such as OS-CON and POSCAP.
Buck CIN, COUT Selection
The selection of CINforthetwobuckcontrollersissimplied
by the 2-phase architecture and its impact on the worst-
case RMS current drawn through the input network (bat-
tery/fuse/capacitor). It can be shown that the worst-case
capacitor RMS current occurs when only one controller
is operating. The controller with the highest (VOUT)(IOUT)
product needs to be used in the formula shown in Equa-
tion (1) to determine the maximum RMS capacitor current
requirement. Increasing the output current drawn from
the other controller will actually decrease the input RMS
ripple current from its maximum value. The out-of-phase
technique typically reduces the input capacitor’s RMS
ripple current by a factor of 30% to 70% when compared
to a single phase power supply solution.
In continuous mode, the source current of the top MOSFET
is a square wave of duty cycle (VOUT)/(VIN). To prevent
large voltage transients, a low ESR capacitor sized for the
maximum RMS current of one channel must be used. The
maximum RMS capacitor current is given by:
C
IN Required IRMS
I
MAX
V
IN
V
OUT
() V
IN VOUT
()
1/ 2
(1)
This formula has a maximum at VIN = 2VOUT, where IRMS
= IOUT/2. This simple worst-case condition is commonly
used for design because even signicant deviations do not
offer much relief. Note that capacitor manufacturers’ ripple
current ratings are often based on only 2000 hours of life.
This makes it advisable to further derate the capacitor, or
to choose a capacitor rated at a higher temperature than
required. Several capacitors may be paralleled to meet
size or height requirements in the design. Due to the high
operating frequency of the LTC3859, ceramic capacitors
can also be used for CIN. Always consult the manufacturer
if there is any question.
The benet of the LTC3859 2-phase operation can be calcu-
lated by using Equation (1) for the higher power controller
and then calculating the loss that would have resulted if
both controller channels switched on at the same time.
相關PDF資料
PDF描述
LTC4160EUDC#PBF POWER SUPPLY MANAGEMENT CKT, PQCC20
LTC4266IUHF#TRPBF POWER SUPPLY MANAGEMENT CKT, PQCC38
LTC4266CUHF#PBF POWER SUPPLY MANAGEMENT CKT, PQCC38
LTC500-4MM LOW PASS FILTER
LTC6603CUF#PBF LOW PASS FILTER
相關代理商/技術參數
參數描述
LTC3859EUHF#PBF 功能描述:IC REG CTRLR BST PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3859EUHF#TRPBF 功能描述:IC REG CTRLR BST PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3859IFE#PBF 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3859IFE#TRPBF 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3859IUHF#PBF 功能描述:IC REG CTRLR BST PWM CM 38VQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP(0.173",4.40mm 寬) 包裝:帶卷 (TR)