參數資料
型號： LTC3853IUJ#TR
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 0.15 A DUAL SWITCHING CONTROLLER, 830 kHz SWITCHING FREQ-MAX, PQCC40
封裝： 6 X 6 MM, PLASTIC, QFN-40
文件頁數： 3/36頁
文件大?。?/td> 1780K
代理商： LTC3853IUJ#TR
LTC3853
11
3853fa
OPERATION
Main Control Loop
The LTC3853 is a constant-frequency, current mode
step-down controller with three channels operating 120
degrees out-of-phase. During normal operation, each
top MOSFET is turned on when the clock for that channel
sets the RS latch, and turned off when the main current
comparator, ICMP, resets the RS latch. The peak inductor
current at which ICMP resets the RS latch is controlled by
the voltage on the ITH pin, which is the output of each error
amplifier, EA. The VFB pin receives the voltage feedback
signal, which is compared to the internal reference voltage
by the EA. When the load current increases, it causes a
slight decrease in VFB relative to the 0.8V reference, which
in turn causes the ITH voltage to increase until the average
inductor current matches the new load current. After the
top MOSFET has turned off, the bottom MOSFET is turned
on until either the inductor current starts to reverse, as
indicated by the reverse current comparator IREV, or the
beginning of the next cycle.
INTVCC/EXTVCC/DRVCC12 Power
Power for the top and bottom MOSFET drivers of phase 3
and most other internal circuitry is derived from the
INTVCC pin. DRVCC12 provides driver power for phase 1
and phase 2. This pin must be externally tied to INTVCC.
If EXTVCC is taken above 4.7V, the 5V regulator is turned
off and an internal switch is turned on connecting EXTVCC.
UsingtheEXTVCCpinallowstheINTVCCpowertobederived
from a high efficiency external source such as one of the
LTC3853 switching regulator outputs.
Each top MOSFET driver is biased from the floating boot-
strap capacitor, CB, which normally recharges during each
off cycle through an external diode when the top MOSFET
turns off. If the input voltage, VIN, decreases to a voltage
close to VOUT, the loop may enter dropout and attempt to
turn on the top MOSFET continuously. The dropout detec-
tor detects this and forces the top MOSFET off for about
one-twelfth of the clock period every fifth cycle to allow
CB to recharge. However, it is recommended that there is
always a load be present during the drop-out transition
to ensure CB is recharged.
Shutdown and Start-Up (RUN1, RUN2, RUN3 and
TK/SS1, TK/SS2, TK/SS3 Pins)
The three channels of the LTC3853 can be independently
shut down using the RUN1, RUN2 and RUN3 pins. Pulling
any of these pins below 1.2V shuts down the main control
loop for that controller. Pulling all pins low disables all
three controllers and most internal circuits, including the
INTVCCregulator.ReleasinganyRUNpinallowsaninternal
0.5A current to pull up the pin and enable that control-
ler. Alternatively, the RUN pin may be externally pulled up
or driven directly by logic. Be careful not to exceed the
absolute maximum rating of 6V on this pin.
The start-up of each controller’s output voltage VOUT is
controlled by the voltage on the TK/SS1, TK/SS2 and
TK/SS3 pins. When the voltage on the TK/SS pin is less
than the 0.8V internal reference, the LTC3853 regulates
the VFB voltage to the TK/SS pin voltage instead of the
0.8V reference. This allows the TK/SS pin to be used to
program a soft-start by connecting an external capacitor
from the TK/SS pin to SGND. An internal 1.3A pull-up
current charges this capacitor, creating a voltage ramp
on the TK/SS pin. As the TK/SS voltage rises linearly
from 0V to 0.8V (and beyond), the output voltage VOUT
rises smoothly from zero to its final value. Alternatively
the TK/SS pin can be used to cause the start-up of VOUT
to “track” that of another supply. Typically, this requires
connecting to the TK/SS pin an external resistor divider
from the other supply to ground (see the Applications
Information section). When the corresponding RUN pin
is pulled low to disable a controller, or when INTVCC drops
below its undervoltage lockout threshold of 3.35V, the
TK/SS pin is pulled low by an internal MOSFET. When in
undervoltage lockout, all controllers are disabled and the
external MOSFETs are held off.
Light Load Current Operation (Burst Mode Operation,
Pulse Skipping or Continuous Conduction)
The LTC3853 can be enabled to enter high efficiency Burst
Modeoperation,constant-frequencypulseskippingmode,
or forced continuous conduction mode. To select forced
continuous operation, tie the MODE/PLLIN pin to a DC
相關PDF資料
PDF描述
LTC3853EUJ#TR 0.15 A DUAL SWITCHING CONTROLLER, 830 kHz SWITCHING FREQ-MAX, PQCC40
LTC3853EUJ 0.15 A DUAL SWITCHING CONTROLLER, 830 kHz SWITCHING FREQ-MAX, PQCC40
LTC4011EFE#PBF BATTERY CHARGE CONTROLLER, 615 kHz SWITCHING FREQ-MAX, PDSO20
LTC4075HVXEDD#TR 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10
LTC4075HVXEDD 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10
相關代理商/技術參數
參數描述
LTC3854EDDB#PBF 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Cut Tape Small Footprint, Low Pin Count Synchronous Step-Do
LTC3854EDDB#TRMPBF 功能描述:IC REG CTRLR BUCK PWM CM 12-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3854EDDB#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 12-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3854EMSE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3854EMSE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*