參數資料
型號: LTC3851EMSE-1#TRPBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: SWITCHING CONTROLLER, PDSO16
封裝: 0.150 INCH, LEAD FREE, PLASTIC, MSOP-16
文件頁數: 27/28頁
文件大?。?/td> 337K
代理商: LTC3851EMSE-1#TRPBF
LTC3851-1
8
38511f
PIN FUNCTIONS (MSE/UD)
MODE/PLLIN (Pin 1/Pin 15): Force Continuous Mode,
Burst Mode or Pulse skipping Mode Selection Pin and
External Synchronization Input to Phase Detector Pin.
Connect this pin to INTVCC to force continuous conduction
mode of operation. Connect to GND to enable pulse skip-
ping mode of operation. To select Burst Mode operation,
tie this pin to INTVCC through a resistor no less than 50k,
but no greater than 250k. A clock on the pin will force the
controller into forced continuous mode of operation and
synchronize the internal oscillator.
FREQ/PLLFLTR (Pin 2/Pin 16): The phase-locked loop’s
lowpass lter is tied to this pin. Alternatively, a resistor
can be connected between this pin and GND to vary the
frequency of the internal oscillator.
RUN (Pin 3/Pin 1): Run Control Input. A voltage above
1.25V on this pin turns on the IC. However, forcing this
pin below 1.1V causes the IC to shut down the IC. There
is a 2μA pull-up current on this pin.
TK/SS (Pin 4/Pin 2): Output Voltage Tracking and Soft-Start
Input. A capacitor to ground at this pin sets the ramp rate
for the output voltage. An internal soft-start current of of
1μA charges this capacitor.
ITH (Pin 5/Pin 3): Current Control Threshold and Error
Amplier Compensation Point. The current comparator
tripping threshold increases with its ITH control voltage.
FB (Pin 6/Pin 4): Error Amplier Feedback Input. This pin
receives the remotely sensed feedback voltage from an
external resistive divider across the output.
SENSE(Pin 7/Pin 5):
Current Sense Comparator Inverting
Input. The (–) input to the current comparator is connected
to the output.
SENSE+ (Pin 8/Pin 6):
Current Sense Comparator Non-
inverting Input. The (+) input to the current comparator
is normally connected to the DCR sensing network or
current sensing resistor.
PGOOD (Pin 9/Pin 7): Power Good Indicator Output. Open-
drain logic out that is pulled to ground when the output
voltage exceeds the ±10% regulation window, after the
internal 17μs power bad mask timer expires.
GND (Pin 10/Pin 8): Ground. All small-signal components
and compensation components should be Kelvin connected
to this ground. The (–) terminal of CVCC and the (–) terminal
of CIN should be closely connected to this pin.
BG (Pin 11/Pin 9): Bottom Gate Driver Output. This pin
drives the gate of the bottom N-channel MOSFET between
GND and INTVCC.
INTVCC (Pin 12/Pin 10): Internal 5V Regulator Output. The
control circuit is powered from this voltage. Decouple this
pin to GND with a minimum 2.2μF low ESR tantalum or
ceramic capacitor.
VIN (Pin 13/Pin 11): Main Input Supply. Decouple this pin
to GND with a capacitor.
BOOST (Pin 14/Pin 12): Boosted Floating Driver Supply.
The (+) terminal of the boost-strap capacitor is connected
to this pin. This pin swings from a diode voltage drop
below INTVCC up to VIN + INTVCC.
TG (Pin 15/Pin 13): Top Gate Driver Output. This is the
output of a oating driver with a voltage swing equal to
INTVCC superimposed on the switch node voltage.
SW (Pin 16/Pin 14): Switch Node Connection to the In-
ductor. Voltage swing at this pin is from a Schottky diode
(external) voltage drop below ground to VIN.
Exposed Pad (Pin 17): Ground. Must be soldered to PCB,
providing a local ground for the IC.
相關PDF資料
PDF描述
LTC3851EUD-1#TRPBF SWITCHING CONTROLLER, PQCC16
LTCEMSE-1#PBF SWITCHING CONTROLLER, PDSO16
LTC3851IUD-1#TRPBF SWITCHING CONTROLLER, PQCC16
LTC3859IUHF#TRPBF SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC38
LTC3859EFE#PBF SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO38
相關代理商/技術參數
參數描述
LTC3851EUD#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3851EUD#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3851EUD-1#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3851EUD-1#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3851IGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP(0.173",4.40mm 寬) 包裝:帶卷 (TR)