- 您現在的位置：買賣IC網 > PDF目錄39425 > LTC3851EMSE-1#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, PDSO16 PDF資料下載
參數資料
| 型號： | LTC3851EMSE-1#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO16 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, MSOP-16 |
| 文件頁數： | 13/28頁 |
| 文件大小： | 337K |
| 代理商： | LTC3851EMSE-1#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC3851-1
20
38511f
APPLICATIONS INFORMATION
The loop lter components, CLP and RLP, smooth out
the current pulses from the phase detector and provide
a stable input to the voltage-controlled oscillator. The
lter components CLP and RLP determine how fast the
loop acquires lock. Typically RLP is 1k to 10k and CLP is
2200pF to 0.01μF.
When the external oscillator is active before the LTC3851
is enabled, the internal oscillator frequency will track the
external oscillator frequency as described in the preceding
paragraphs. In situations where the LTC3851 is enabled
before the external oscillator is active, a low free-running
oscillator frequency of approximately 50kHz will result. It
is possible to increase the free-running, pre-synchroniza-
tion frequency by adding a second resistor in parallel with
RLP and CLP. The second resistor will also cause a phase
difference between the internal and external oscillator
signals. The magnitude of the phase difference is inversely
proportional to the value of the second resistor.
The external clock (on MODE/PLLIN pin) input high
threshold is nominally 1.6V, while the input low threshold
is nominally 1.2V.
Minimum On-Time Considerations
Minimum on-time tON(MIN)isthesmallesttimedurationthat
the LTC3851-1 is capable of turning on the top MOSFET.
It is determined by internal timing delays and the gate
charge required to turn on the top MOSFET. Low duty
cycle applications may approach this minimum on-time
limit and care should be taken to ensure that:
t
V
Vf
ON MIN
OUT
IN
()
<
If the duty cycle falls below what can be accommodated
by the minimum on-time, the controller will begin to skip
cycles. The output voltage will continue to be regulated,
but the ripple voltage and current will increase.
The minimum on-time for the LTC3851-1 is approximately
90ns. However, as the peak sense voltage decreases the
minimum on-time gradually increases. This is of particu-
lar concern in forced continuous applications with low
ripple current at light loads. If the duty cycle drops below
the minimum on-time limit in this situation, a signicant
amount of cycle skipping can occur with correspondingly
larger current and voltage ripple.
Efciency Considerations
The percent efciency of a switching regulator is equal to
the output power divided by the input power times 100%.
It is often useful to analyze individual losses to determine
what is limiting the efciency and which change would
produce the most improvement. Percent efciency can
be expressed as:
%Efciency = 100% – (L1 + L2 + L3 + ...)
where L1, L2, etc. are the individual losses as a percent-
age of input power.
Although all dissipative elements in the circuit produce
losses, four main sources usually account for most of
the losses in LTC3851-1 circuits: 1) IC VIN current, 2)
INTVCCregulatorcurrent,3)I2Rlosses,4)topsideMOSFET
transition losses.
1. The VIN current is the DC supply current given in the
Electrical Characteristics table, which excludes MOSFET
driver current. VIN current typically results in a small
(<0.1%) loss.
2. INTVCC current is the sum of the MOSFET driver and
control currents. The MOSFET driver current results
from switching the gate capacitance of the power
MOSFETs. Each time a MOSFET gate is switched from
low to high to low again, a packet of charge dQ moves
from INTVCC to ground. The resulting dQ/dt is a current
out of INTVCC that is typically much larger than the
control circuit current. In continuous mode, IGATECHG
= f(QT + QB), where QT and QB are the gate charges of
the topside and bottom side MOSFETs.
3. I2R losses are predicted from the DC resistances of
the fuse (if used), MOSFET, inductor and current sense
resistor. In continuous mode, the average output current
ows through L and RSENSE, but is “chopped” between
the topside MOSFET and the synchronous MOSFET. If
the two MOSFETs have approximately the same RDS(ON),
then the resistance of one MOSFET can simply be
summed with the resistances of L and RSENSE to ob-
tain I2R losses. For example, if each RDS(ON) = 10mΩ,
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3851EUD-1#TRPBF | SWITCHING CONTROLLER, PQCC16 |
| LTCEMSE-1#PBF | SWITCHING CONTROLLER, PDSO16 |
| LTC3851IUD-1#TRPBF | SWITCHING CONTROLLER, PQCC16 |
| LTC3859IUHF#TRPBF | SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC38 |
| LTC3859EFE#PBF | SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO38 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3851EUD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3851EUD#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851EUD-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851EUD-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851IGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。