- 您現在的位置：買賣IC網 > PDF目錄30770 > LTC3766MPUFD#PBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PQCC28 PDF資料下載
參數資料
| 型號： | LTC3766MPUFD#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PQCC28 |
| 封裝： | 4 X 5 MM, LEAD FREE, PLASTIC, MO-220, QFN-28 |
| 文件頁數： | 43/60頁 |
| 文件大?。?/td> | 607K |
| 代理商： | LTC3766MPUFD#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
LTC3766
48
3766f
APPLICATIONS INFORMATION
switched once. The SSFLT pin currents then decrease to
theirnominalvalues.Thisensuresthatallphasesbegintheir
asynchronous,open-loopstart-upatnearlythesametime.
On the secondary side, the SS pins from all phases are
interconnected as well. This prevents any one phase from
starting until all phases have adequate bias voltage and
have detected switching on their respective SW pins.
Once this condition is met, the master will advance the
soft-start voltage to match the VOUT of the converter, and
switchingbeginsonthesecondarysideonallphases.After
a brief lock sequence, all phases will transfer control to
the secondary. The ITH pins are interconnected between
the phases so that current is shared evenly between the
master (which controls the ITH pin to regulate VOUT) and
the slaves.
The LTC3765 SSFLT connection is also used to com-
municate faults. If one phase has a primary-side fault
(undervoltage, overcurrent, overtemperature, or com-
munication loss), it immediately stops switching and
rapidly pulls SSFLT to 6V. The other phases will detect
that SSFLT is above 5V and will also stop switching. On
the secondary side, the LTC3766s detect that switching
has stopped and also fault, which is communicated to all
phases through the common SS connection. The voltage
on the primary-side SSFLT node then slowly decreases
and a restart begins. Likewise, if a fault originates on the
secondarysideonagivephase,thisfaultiscommunicated
to the other LTC3766s so that all phases stop switching.
This will cause a communication fault on the primary side
followed by a restart attempt.
For the LTC3765 on the primary side, choose components
basedonasingle-phasedesign.Duplicatethesinglephase
to the desired number of phases, up to the maximum of
four, with the following modifications:
1. Connect the SSFLT pins together. Instead of having
multiple capacitors from the SSFLT node to ground,
the capacitors can be consolidated into one capacitor
with a value equal to N CSSFLT, where N is the number
of phases.
2. If desired, the phases can share the linear regulator of
one phase by shorting their VCC and NDRV pins to the
linearregulatoroutput;however,beawarethatthelinear
regulator pass device will be dissipating more power
and may require a larger and more thermally conduc-
tive package. The design and PCB layout are generally
simplified if each phase uses its own linear regulator.
The secondary side follows a similar procedure; however,
there is more differentiation between the master phase
and the slave phases. For the master, choose components
based on the above design equations. Be aware that each
phase should have its own linear regulator pass device to
distributethepowerdissipation.Duplicatethecomponents
for each slave, with the following exceptions:
1. Connect all of the SS pins together. Instead of having
multiple capacitors from the SS node to ground, the
capacitors can be consolidated into one capacitor. Note
that only the master charges and discharges the soft-
start capacitor.
2. Connect the FB pin of the slaves to VCC. This connection
puts the LTC3766 into slave mode. In this mode, the ITH
pin becomes a high impedance input and the SS pin is
only used for fault communication. An LTC3766 slave
will not perform a pre-set of the soft-start capacitor, nor
will it charge or discharge it. A slave can only force the
SS pin high to indicate a fault, and it also monitors the
SS pin to respond to a fault in another phase.
3. For each slave, the integrated unity-gain differential
amplifier is used to sense the voltage on the ITH pin
of the master. Connect the VS+/VS– inputs of each slave
between the ITH and signal GND pins of the master.
Connect the VSOUT pin on each slave to its own ITH pin.
4. Connect the FS/SYNC pins of each slave to the PT– pin
of the master. The PT– pin of the master contains the
clock signal used to synchronize the slaves and master
together.
For each slave, set the relative phase using the PHASE pin.
Note that ripple current in the input capacitor is minimized
by operating the controllers out of phase. For a 2-phase
system, set the slave at 180°. For a 3-phase system, set
the slaves at 120° and 240°. For a 4-phase system, set
the slaves at 90°, 180°, and 270°. Refer to Setting the
Switching Frequency and Synchronization for details on
setting the PHASE pin.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3766EUFD#PBF | SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PQCC28 |
| LTC3805EDD | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3805EMSE | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3805HMSE#TR | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3805EDD#TR | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3770EG | 制造商:Linear Technology 功能描述:LDO Cntrlr SYNC BUCK REG 0.6V to 32V 28-Pin SSOP |
| LTC3770EG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3770EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3770EUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3770EUH#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。