參數資料
型號: LTC3766IGN#PBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PDSO28
封裝: 0.150 INCH, LEAD FREE, PLASTIC, SSOP-28
文件頁數: 14/60頁
文件大?。?/td> 607K
代理商: LTC3766IGN#PBF
LTC3766
21
3766f
APPLICATIONS INFORMATION
control. If excessive pulse skipping occurs in applications
that use a peak charge circuit to generate bias voltage, this
can cause the bias supply to fall, preventing proper start-
up. To preclude this possibility, use the RUN pin to inhibit
the LTC3766 start-up until the output voltage is at least:
VOUT(ON) >300ns
NSfSWVIN(MAX)
NP
Note that in self-starting applications, direct RUN/STOP
control should be handled only on the primary side using
the LTC3765. If the LTC3765 gets disabled, the LTC3766
will sense that the primary side is no longer switching
and automatically shut down. To avoid a possible output
overvoltage, do not manually disable the LTC3766 unless
the LTC3765 is also manually disabled.
If the RUN pin function is not needed, it can be tied directly
to the VIN pin.
Setting the Switching Frequency and Synchronization
The switching frequency of the LTC3766 is set using the
FS/SYNC pin. This pin sources a 20μA current, and a re-
sistor to ground on this pin sets the switching frequency
to a value equal to:
fSW = 4RFS
Alternatively, the FS/SYNC pin can be tied to VCC, which
sets the switching frequency to a fixed value of 275kHz.
In general, a higher switching frequency will result in a
smaller size for inductors and transformers, but at the cost
of reduced efficiency. Although the LTC3766 can operate
from75kHzto500kHz,thebestbalancebetweenefficiency
and size for a forward converter is found when operating
between 150kHz and 350kHz.
Ifaclocksignal(>2V)isdetectedattheFSpin,theLTC3766
willautomaticallysynchronizetothefallingedgeofthissig-
nal. Table 1 summarizes the operation of the FS/SYNC pin.
Table 1
FS/SYNC PIN
SWITCHING FREQUENCY
VCC
275kHz
RFS to GND
fSW = 4RFS
Reference Clock
fSW = fREF (100kHz to 500kHz)
InPolyPhaseapplications,synchronizationcanbeachieved
by tying the PTpin of the master to the FS/SYNC pin of
each slave. The relative phase delay of each slave is set
using the PHASE pin. Any one of five preset values can be
selected as shown in Table 2. Note that the phase delay
is relative to the falling edge of the incoming reference
clock on the FS/SYNC pin, since the falling edge of PT
corresponds to the beginning of the PWM cycle.
Table 2
PHASE PIN
PHASE DELAY
APPLICATION
GND
180°
2-Phase and 4-Phase
25k to GND
240°
3-Phase
50k to GND
120°
3-Phase
100k to GND
90°
4-Phase
100k to VCC
270°
4-Phase
In some applications, it is desirable to start switching at a
given frequency, and then synchronize to a clock reference
signal at a later time. This can be accomplished by using
the circuit shown in Figure 6.
FS/SYNC
LTC3766
GND
RFS
BAT54
50k
CLK
2N2222A
10nF
10k
3766 F06
Figure 6. Synchronization After Free Running
OncetheLTC3766hasbeensynchronized,donotremove
the external synchronizing clock unless the LTC3766
is also shut down. Removal of the external clock after
synchronization will result in operation at low frequencies
for a period of time, which can lead to very high currents
in external power components.
Setting the Output Voltage
The LTC3766 output voltage is set by an external feedback
resistor divider placed across the output as shown in
Figure 7. The regulated output voltage is determined by:
VOUT = 0.6V 1+
RB
RA
相關PDF資料
PDF描述
LTC3766HGN#TRPBF SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PDSO28
LTC3766HUFD#TRPBF SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PQCC28
LTC3766IUFD#TRPBF SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PQCC28
LTC3766MPUFD#TRPBF SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PQCC28
LTC3766IGN#TRPBF SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
LTC3766IUFD#PBF 功能描述:IC CONTROLLER SYNCH 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器,監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(5x5) 包裝:帶卷 (TR)
LTC3766IUFD#TRPBF 功能描述:IC CONTROLLER SYNCH 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器,監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(5x5) 包裝:帶卷 (TR)
LTC3766MPGN#PBF 功能描述:IC CONTROLLER SYNCH 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器,監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(5x5) 包裝:帶卷 (TR)
LTC3766MPGN#TRPBF 功能描述:IC CONTROLLER SYNCH 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器,監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(5x5) 包裝:帶卷 (TR)
LTC3766MPUFD#PBF 功能描述:IC CONTROLLER SYNCH 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器,監視器 系列:Direct Flux Limit™, PolyPhase® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(5x5) 包裝:帶卷 (TR)