參數資料
型號: LTC3738CUHF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 3-Phase Buck Controller for Intel VRM9/VRM10 with Active Voltage Positioning
中文描述: 5 A SWITCHING CONTROLLER, 630 kHz SWITCHING FREQ-MAX, PQCC38
封裝: 7 X 5 MM, PLASTIC, M0-220WHKD, QFN-38
文件頁數: 18/32頁
文件大?。?/td> 316K
代理商: LTC3738CUHF
18
LTC3738
3738f
applied. Physically, if the capacitance value changes due
to applied voltage change, there is a concommitant piezo
effect which results in radiating sound! A load that draws
varying current at an audible rate may cause an attendant
varying input voltage on a ceramic capacitor, resulting in
an audible signal. A secondary issue relates to the energy
flowing back into a ceramic capacitor whose capacitance
value is being reduced by the increasing charge. The
voltage can increase at a considerably higher rate than the
constant current being supplied because the capacitance
value is decreasing as the voltage is increasing! Ceramic
capacitors, when properly selected and used however, can
provide the lowest overall loss due to their extremely low
ESR.
The selection of C
OUT
is driven by the required effective
series resistance (ESR). Typically once the ESR require-
ment is satisfied the capacitance is adequate for filtering.
The steady-state output ripple (
V
OUT
) is determined by:
V
I
ESR
NfC
8
OUT
RIPPLE
OUT
+
1
where f = operating frequency of each stage, N is the
number of output stages, C
OUT
= output capacitance and
I
L
= ripple current in each inductor. The output ripple is
highest at maximum input voltage since
I
L
increases
with input voltage. The output ripple will be less than 50mV
at max V
IN
with
I
L
= 0.4I
OUT(MAX)
assuming:
C
OUT
required ESR < N R
SENSE
and
C
OUT
> 1/(8Nf)(R
SENSE
)
The emergence of very low ESR capacitors in small,
surface mount packages makes very small physical imple-
mentations possible. The ability to externally compensate
the switching regulator loop using the I
TH
pin allows a
much wider selection of output capacitor types. The
impedance characteristics of each capacitor type is sig-
nificantly different than an ideal capacitor and therefore
requires accurate modeling or bench evaluation during
design.
Manufacturers such as Nichicon, United Chemicon and
Sanyo should be considered for high performance through-
hole capacitors. The OS-CON semiconductor dielectric
capacitor available from Sanyo and the Panasonic SP
surface mount types have a good (ESR)(size) product.
Once the ESR requirement for C
OUT
has been met, the
RMS current rating generally far exceeds the I
RIPPLE(P-P)
requirement. Ceramic capacitors from AVX, Taiyo Yuden,
Murata and Tokin offer high capacitance value and very
low ESR, especially applicable for low output voltage
applications.
In surface mount applications, multiple capacitors may
have to be paralleled to meet the ESR or RMS current
handling requirements of the application. Aluminum elec-
trolytic and dry tantalum capacitors are both available in
surface mount configurations. New special polymer sur-
face mount capacitors offer very low ESR also but have
much lower capacitive density per unit volume. In the case
of tantalum, it is critical that the capacitors are surge tested
for use in switching power supplies. Several excellent
choices are the AVX TPS, AVX TPSV, the KEMET T510
series of sur
face-mount tantalums or the Panasonic SP
series of surface mount special polymer capacitors avail-
able in case heights ranging from 2mm to 4mm. Other
capacitor types include Sanyo POS-CAP, Sanyo OS-CON,
Nichicon PL series and Sprague 595D series. Consult the
manufacturer for other specific recommendations.
R
SENSE
Selection for Output Current
Once the frequency and inductor have been chosen,
R
SENSE1,
R
SENSE2,
R
SENSE3
are determined based on the
required peak inductor current. The current comparator
has a maximum threshold of 75mV/R
SENSE
and an input
common mode range of SGND to (1.1) V
CC
. The current
comparator threshold sets the peak inductor current,
yielding a maximum average output current I
MAX
equal to
the peak value less half the peak-to-peak ripple current,
I
L
.
Allowing a margin for variations in the IC and external
component values yields:
R
N
mV
I
SENSE
MAX
=
50
The IC works well with values of R
SENSE
from 0.001
to
0.02
.
APPLICATIOU
W
U
U
相關PDF資料
PDF描述
LTC3770 Synchronous Controller with Margining, Tracking and PLL
LTC3770EG Synchronous Controller with Margining, Tracking and PLL
LTC3770EUH Synchronous Controller with Margining, Tracking and PLL
LTC3776 16-Bit Buffer/Driver With 3-State Outputs 48-TVSOP -40 to 85
LTC3776EUF Dual 2-Phase, No RSENSE Synchronous Controller for DDR/QDR Memory Termination
相關代理商/技術參數
參數描述
LTC3738CUHF#PBF 功能描述:IC CTRLR SW REG 3PH STPDWN 38QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器,Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN(7x7) 包裝:管件
LTC3738CUHF#TR 功能描述:IC CTRLR SW REG 3PH STPDWN 38QFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器,Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN(7x7) 包裝:管件
LTC3738CUHF#TRPBF 功能描述:IC CTRLR SW REG 3PH STPDWN 38QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器,Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN(7x7) 包裝:管件
LTC-3743KG 制造商:Lite-On Semiconductor Corporation 功能描述:
LTC3765EMSE#PBF 功能描述:IC CTLR GATE DRIVER 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器,監視器 系列:Direct Flux Limit™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(5x5) 包裝:帶卷 (TR)