參數資料
型號: LTC3700EMS#TRPBF
廠商: Linear Technology
文件頁數: 11/16頁
文件大小: 215K
描述: IC REG DL BUCK/LINEAR 10MSOP
產品培訓模塊: More Information on LDOs
標準包裝: 2,500
拓?fù)洌?/td> 降壓(降壓)(1),線性(LDO)(1)
功能: 任何功能
輸出數: 2
頻率 - 開關: 550kHz
電壓/電流 - 輸出 1: 可調至0.8V,5A
電壓/電流 - 輸出 2: 可調至0.8V,150mA
帶 LED 驅動器: 無
帶監控器: 無
帶序列發生器: 無
電源電壓: 2.4 V ~ 9.8 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 10-TFSOP,10-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 10-MSOP
包裝: 帶卷 (TR)
11
LTC3700
3700f
APPLICATIONS INFORMATION
U
U
U
Molypermalloy (from Magnetics, Inc.) is a very good, low
loss core material for toroids, but it is more expensive than
ferrite. A reasonable compromise from the same manu-
facturer is Kool M? Toroids are very space efficient,
especially when you can use several layers of wire. Be-
cause they generally lack a bobbin, mounting is more
difficult. However, new designs for surface mount that do
not increase the height significantly are available.
Power MOSFET Selection
An external P-channel power MOSFET must be selected
for use with the LTC3700. The main selection criteria for
the power MOSFET are the threshold voltage V
GS(TH)
 and
the on resistance R
DS(ON)
, reverse transfer capacitance
C
RSS
 and total gate charge.
Since the LTC3700 is designed for operation down to low
input voltages, a sublogic level threshold MOSFET (R
DS(ON)
guaranteed at V
GS
 = 2.5V) is required for applications that
work close to this voltage. When these MOSFETs are used,
make sure that the input supply to the buck is less than the
absolute maximum V
GS
 rating, typically 8V.
The required minimum R
DS(ON)
 of the MOSFET is gov-
erned by its allowable power dissipation. For applications
that may operate the LTC3700 in dropout, i.e., 100% duty
cycle, at its worst case the required R
DS(ON)
 is given by:
R
P
I
p
DSON
P
OUTMAX
DC
( )
(  )
%
=
=
(
)
+
(    )
100
2
1 ?/DIV>
where P
P
 is the allowable power dissipation and 磒 is the
temperature dependency of R
DS(ON)
. (1 + 磒) is generally
given for a MOSFET in the form of a normalized R
DS(ON)
 vs
temperature curve, but 磒 = 0.005/癈 can be used as an
approximation for low voltage MOSFETs.
Kool M?is a registered trademark of Magnetics, Inc.
In Burst Mode operation on the LTC3700, the ripple
current is normally set such that the inductor current is
continuous during the burst periods. Therefore, the peak-
to-peak ripple current must not exceed:
I
R
RIPPLE
SENSE
d
003
.
This implies a minimum inductance of:
L
V  V
f
R
V   V
V  V
MIN
IN  OUT
SENSE
OUT  D
IN  D
=

?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
+
+
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
003
.
(Use V
IN(MAX)
 = V
IN
)
A smaller value than L
MIN
 could be used in the circuit;
however, the inductor current will not be continuous
during burst periods.
Inductor Core Selection
Once the value for L is known, the type of inductor must be
selected. High efficiency converters generally cannot af-
ford the core loss found in low cost powdered iron cores,
forcing the use of more expensive ferrite, molypermalloy
or Kool M?/DIV>
?/DIV>
 cores. Actual core loss is independent of core
size for a fixed inductor value, but it is very dependent on
inductance selected. As inductance increases, core losses
go down. Unfortunately, increased inductance requires
more turns of wire and therefore copper losses will in-
crease. Ferrite designs have very low core losses and are
preferred at high switching frequencies, so design goals
can concentrate on copper loss and preventing saturation.
Ferrite core material saturates hard, which means that
inductance collapses abruptly when the peak design cur-
rent is exceeded. This results in an abrupt increase in
inductor ripple current and consequent output voltage
ripple. Do not allow the core to saturate!
相關PDF資料
PDF描述
LTC4151HMS#TRPBF IC PWR MONITOR MS 80V SD 10MSOP
LTC4210-2CS6#TRM IC CONTROLLER HOT SWAP TSOT23-6
LTC4211IMS8 IC CONTROLLER HOT SWAP 8-MSOP
LTC4212IMS#TRPBF IC CTRLR HOTSWAP TIMEOUT 10MSOP
LTC4214-1IMS#TRPBF IC CTRLR HOTSWAP NEGVOLT 10MSOP
相關代理商/技術參數
參數描述
LTC3701EGN 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3701EGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3701EGN#TR 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3701EGN#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3701EGNPBF 制造商:Linear Technology 功能描述:DC-DC Controller Dual Step-Dn 10V SSOP16